Question about 2007 Porsche 911 Carrera S Coupe

1 Answer

How do I check / refill the clutch fliud level?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 182 Answers

Under windshield cowl by brake fluid reservoir

Posted on Sep 06, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Daughters 2002 Hyundai Getz is stuck in what i think is second gear.


Worn Clutch plate or thrust plate.

Check if hydraulic Clutch
if so check clutch fliud level . Could be a faulty clutch master cyclinder in hydraulic system.

Jan 15, 2015 | 2002 Hyundai Getz

1 Answer

So do I need to replace my clutch if its making a grind sound when trying to put it in gear when crunk but it change out fine when turned off and my clutch pedal works good no problem


you need to the hydrulic system first, is the fliud level ok and is the slave cylinder actuating before removing the clutch

May 31, 2013 | Cars & Trucks

1 Answer

Hand brake light on dash intermittant. Switch at hand brake is ok


check the brake fluid level. the brake fluid can be low and comes on when stopping or going around curves. the brake fliud level sensor uses the same brake light as the parking brake. if the fliud is low check the pads and /or shoes for wear.

Aug 07, 2011 | Toyota RAV4 Cars & Trucks

1 Answer

How do you bleed clutch system on manuel trans. 1996 sc2 saturn?


ahaaaa easy....under the battery is a 9mm valve connected to a plastic bullet looking piece thats goes into the top of the transmission....fill the clutch master cylinder with brake fluid an open the valve when fluid start running out close it..now refill the system..have someone start pumping the clutch pedal.pump it ten times an hold it to the floor,open the bleeder valve while still holding the clutch pedal to the floor..close the bleeder an repeat the process until the free play is gone in the clutch pedal this may take many times to get all the air out...but dont forget to keep the system full of fliud or u will pump air back into the system an have to start all over again

Jul 15, 2011 | Saturn SC2 Cars & Trucks

1 Answer

The fluid is below at min, which the mechani says is good for a mazda 3. Is that right?


As you didn't explain which fluid is low, here's a general explaination. There's always a cause for any fliud being low, the only fliuds that can fall below minimun levels are brake fliud [ as the brake pads or shoes wear it takes more fluid to push the surfaces together ] if not checked on a routine service, such as oil changes. The other is windshield washer fliud, which is lost with use.
Any other fliud loss isn't normal, and should be addressed.

Mar 27, 2011 | Mazda MAZDA3 Cars & Trucks

1 Answer

I found some oil linkages around the fuel pump is that from the pump its self or gasket


Usually observing the dripped fluid on the ground as first encounter to acquire if is gasoline leak or oil leakage. A gasoline leakage should have been caused due to overpump at the gas station. Second, a leak from the engine if is antifreeze overflow because of over filling the hydrant with water causes overflow when AC is turned on for the first time. Third, the engine oil would dispense when too much was put in container. The reason is as vehicle precaustion, else the car would not start due to too much oil lubricant. Perform a vehicles fliud levels inpsection to acquire if any require refill due to the leakage. Alternatively, if any requires reducing for example, a mechanic would determine how to dispense the old fliuds in replacement of new oils. The vehicle should perform better. Usually changing fliuds causes efffecient engine performance,least heating, AC cooling capacity, and least polutant generation like air or gasoline leakages.

Jan 13, 2011 | 1984 Toyota Corolla

2 Answers

My clutch petal is going all the way to the floor and can not engage into gear


Have you checked the clutch fluid level? I am referring to the clutch master cylinder which is usually mounted on the firewall near the master brake cylinder. If fluid level is low, clutch won't work. Hope it's that simple. Let me know.

Dec 07, 2009 | 2001 Nissan Maxima

1 Answer

Clutch isn't working. feels really loose and i can't figure out how to check any fluid levels


depending on the car, your fluid level resovior for your clutch should either be under your brake MC or side by side, it is easy to tell, your brake MC will have several lines coming from it where as your clutch cyl will only have 1 line, so look for thr one that has only 1 line, also another place to check for a leak is inside the car, follow the clutch pedal to where it connects to the pedal pushrod that comes through the firewall , there should be a rubber boot covering the pushrod , squeeze that rubbr boot if you get wet with brake fluid then it ( the clutch MC) is bad, also check on the trans for brake fliud leaks coming out of the clutch bell housing, n alot of todays cars the slave cyl is internal and operates the clutch release bearing as well instead of a pivot fork style... please rate theis help, thanks...

Aug 05, 2009 | 2005 Pontiac Sunfire

2 Answers

Need to refill clutch fluid


The housing that the axles come out of is the transmission so if you lost fliud out of there, it's transmission fliuld if it's a manuel transmission you fill from the side of the transmission if it's an automatic transmission you fill it from under the hood in the dip stick tube good luck

Apr 12, 2009 | 1995 Mazda MX-3

1 Answer

Clutch grinds


check cluth fliud level

Dec 22, 2008 | 1994 Hyundai Excel

Not finding what you are looking for?
2007 Porsche 911 Carrera S Coupe Logo

Related Topics:

134 people viewed this question

Ask a Question

Usually answered in minutes!

Top Porsche Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

907 Answers

yadayada
yadayada

Level 3 Expert

76846 Answers

Are you a Porsche Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...