Question about 1993 Cadillac Fleetwood

1 Answer

My pass key light is on when I try to start car. nothing happens. How do I solve the problem

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 11,896 Answers

Put key in ignition, turn to on position (do not start)
Leave in ON position for EXACTLY 10 minutes. As soon as pass light turns off, then IMMEDIATELY start the car.

Posted on Sep 06, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Dixie Chopper zero turn mower will not start.


check or by pass the parking brake sw. it is on the same circuit.

May 13, 2017 | Seat Cars & Trucks

1 Answer

Why does nothing happens when key is turned to start?


You have a faulty ignition switch relay. It's responsible for using a low voltage signal (key in start position) to send full battery power to your starting circuit.

Sep 03, 2014 | 2000 Mazda MPV

1 Answer

2006 GMC Envoy car alarm goes off when I open doors or start engine. This happened after installing new battery. It had the same problem when I bought it in 2008. I forget how it was solved.


U need to reset security system (pass lock II). Turn key to on right b4 cranking but don't start and let security light flash for about 10-12 mins until it stops and then turn key back off, repeat procedure two more times don't actually turn key far enough to start during first two 10-12 min cycles, third cycle though after flashing stops turn the rest of the way forward for it to start. This should then reset security and solve problem sometimes only takes two cycles to reset. Good luck, hope this is helpful & solves problem.

Nov 23, 2013 | 2002 GMC Envoy

1 Answer

1999 Buick Century Custom Security light blinks and car will not start


someone told me to by getting out of the car and locking the driver door with the key, going to the front passenger door and unlocking, then relocking the door using the key. I have to repeat this step 2-4 times and eventually it will start. ?????????
This has nothing to do with it starting !

This is what's happening , Inside the lock cylinder are contacts that read the resistance of the pellet on the key , the contacts are getting worn out . You have two options , replace the lock cylinder or by-pass it all together .
The PASS-Key II® ignition key (1) contains a unique resistor pellet which is idenified by the Body Control Module (BCM) (2). There are 15 different key (resistor) codes. Only one ignition key resistor pellet code will work with each PASS-Key II® theft deterrent system.
Ignition Key Lock Cylinder
The ignition lock cylinder contains spring loaded contacts which make physical contact with the ignition key when it is inserted into the ignition lock cylinder. This allows the ignition lock cylinder to provide the Body Control Module (BCM) (2) with the resistor code embedded in the ignition key.

GM VATS Key Resistor Key Security Bypass
http://www.autopartswarehouse.com/sku/Buick/Century/Standard/Ignition_Lock_Cylinder/1999/SIUS222L.html?apwcid=bngpla

Jun 29, 2017 | 1999 Buick Century

1 Answer

My 1998 olds 88 won't start. it is not the battery or starter. The security light is flashing. when i try to start it i get nothing. lights are on and stay bright


Is probably the Pass key security system. On your main key you may have a little black raised dot. This is a resistor for the Pass system. make sure you can see a little copper line on each side of the black dot. Sometimes this gets worn or dirty and if the vehicle does not recognize the proper key, it will go into security mode and not start. I think you have to wait like 1/2 hour to try again. Had this happen to a customer of mine who had a key made at Home Depot (without the black dot). Good luck.

Aug 31, 2010 | 1998 Oldsmobile Eighty Eight

1 Answer

No power 96 camaro 3.8


I have the same problem, it seems related to the security system, maybe your key chip died, some times disconectin g the battery for some 10 minutes solves the problem

Mar 10, 2010 | 1996 Chevrolet Camaro

2 Answers

2003 Toyota Matrix won't start. No click when we


yes theres is, try locking and unlocking the pass/side door with the key. you can check for power at the starter at the small wire if theres power at that wire when the key is held in the crank position then you have a bad starter try taping on starter while key is held in start if its starts when tapping then starter is bad,heres a diagram to show you were to tap and where to check for power, hope this helps.4a6e88f.jpg8d713e8.jpg

Feb 10, 2010 | 2003 Toyota Matrix

1 Answer

I went out a few days ago and my Ford escort would not even turn over. I tried jumping it and had no luck. I tried switching over to a new battery and still no luck starting. When I turn the ignition key...


high im haveing simalar problems with mine except i turn the key and get nothing no lights no radio nothing batter is new and altenartor is good so seys pepboys.im going to check all the wireing to make sure i have a good ground to the block or frame and im also going to see if there is any exsposed wireing that could be grounding out the car ??? im probaly going to replace the alternator despite what pepboy says ill let you know what happens if i solve it or not hopefully that it will help you also check your fuses to

Mar 21, 2009 | 2001 Ford Escort ZX2

3 Answers

95 chevy caprice pass key fault.


WELL I HAD THE SAME PROB. ON A 95 CHEVY CAPRICE.I REMOVED THE IGNITION AND THE WIRE WAS BROKE.WHEN U TURN THE KEY THE PASS KEY WIRE TURNS WITH THE IGNITION,WHAT A FAULTY DESIGN.ANY HOW BUY A NEW IGNITION AND KEY THAT SHOULD SOLVE THE PROB. GOOD LUCK

Feb 25, 2009 | 1995 Chevrolet Caprice Classic

Not finding what you are looking for?
1993 Cadillac Fleetwood Logo

Related Topics:

229 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...