Question about 1997 Pontiac Sunfire

Open Question

Where is the inertia switch located on a 1997 pontiac sunfire?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 31 Answers

SOURCE: trying to find where the thermostat is located on

just follow the upper hose the comes out of the radiator ,,top hose ,,to where it goes to the engine it should be there good luck ,,,Joe

Posted on Aug 29, 2009

  • 701 Answers

SOURCE: need location of crank angle sensor on 1997 pontiac sunfire 2.2 liter

Hello oldiro: My name is Roger and I can help. From under the vehicle look up between the transmission and the side of the block. Mid motor above the pan rail there is a bolted in sensor. This should be the crank sensor.It will have two wires plugged in to it. Please rate this answer as this lets us know you received the information you asked for. Should you need further help please just ask. Thank You for using FixYa. Roger

Posted on May 06, 2009

  • 436 Answers

SOURCE: Location of fuel inertia switch for 1997 Dodge

i would guess by your question that you are used to Fords. Chrysler vehicles do not use these switches. just pressure switches and fuel pump relay. from relay power then goes right to the fuel pump.

Posted on Sep 12, 2009

michigan man
  • 3533 Answers

SOURCE: REPLACE SERPENTINE BELT ON 1997 PONTIAC SUNFIRE

give these websites a try www.alldatadiy.com and www.autozone.com and drive belt diagram www.webcrawler.com wish you the best of luck Michigan Man.if all fails stop by your local library and get your hands on a Haynes auto repair manual for your car.

Posted on Nov 12, 2009

citroenchris
  • 600 Answers

SOURCE: my 1997 pontiac sunfire is overheating. There is

there is a steel pipe that runs across the motor there, they are prone to corroding and leaking, you might get away with cutting it and bridging with a piece of hose but the best bet is to replace it. We have been lucky a couple of times and found a car in the wreckers that had newish ones fitted.

Posted on Dec 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Location under hood of a 1997 pontiac sunfire


The throttle position sensor is mounted on the side of the throttle body.

Jul 05, 2012 | Cars & Trucks

1 Answer

Where is the fuel pump shut off switch located in a 2000 pontiac sunfire


GM doesn't use a fuel pump shut off switch, the safety system works like this, fuel pump is turned off if the engine oil pressure goes to zero with the key in the run position. Ford uses a shut off switch that is activated by an impact exceeding 3 G's (3X the force of gravity), it is called the fuel pump shut off inertia switch.

Aug 24, 2011 | 2000 Pontiac Sunfire

1 Answer

1996 sunfire wont idle noiw wont start fuel pump n filter replaced maybe its the pressure regulator it has lots of spark any ideas?


maybe the fuel pump relay, inertia switch, ,MAF sensor, MAP sensor,...the list goes on. just check one at a time untill you find it!

Dec 06, 2010 | 1996 Pontiac Sunfire

1 Answer

Locate the engine temperature sensor


For 1997 Pontiac Sunfire 2.2L SFI OHV 4cyl the Coolant Temperature Sensor is located under hood, driver side, upper engine area, below valve cover, mounted in cylinder head.

zjlimited_51.jpg

Fig. 1: The ECT is also the temperature sending unit for the gauge on the instrument cluster

Hope helps (remember to rate this answer)..

Nov 11, 2010 | 1997 Pontiac Sunfire

1 Answer

Pcv valve location on 1997 pontiac sunfire, 2.4 liter


the positive cranckase ventilation is going to be on the valve cover. usually has a rubber hose about 5/8 coning off it and running to the intake.

Apr 03, 2010 | 1997 Pontiac Sunfire

1 Answer

Where is the cam sensor located on a 1997 pontiac sunfire se 2.2l


under the motor , between the transmission and motor, up by the pan, bolted onto motor, should have 2 wires connected

Nov 01, 2009 | 1997 Pontiac Sunfire

1 Answer

Where is the inertia switch located on the 2005 pontiac sunfire


Hello kmcwil: My name is Roger and I will be glad to help you. On this particular car there is no inertia switch. The PCM or ECM controls the function of the fuel pump. Located under the hood you will find a fuse box. You will find a relay that is marked fuel pump. These two are all that controls the fuel pump. Also check the ECM,ignition and fuel pump fuses.
Should you need further help please just ask. Please rate the quality of your answer. This way I know the information helped. Thank You for using Fix Ya. Roger

Oct 09, 2009 | 2005 Pontiac Sunfire

Not finding what you are looking for?
1997 Pontiac Sunfire Logo

Related Topics:

72 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...