Question about 2007 Chrysler Pacifica FWD New Cars

Open Question

Unhooked battery to clean termnals. after hooking back up. a delay light is flashing along with light on the reconcirculation button for a/c. any ideas?

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Unhooked battery when hooked back up on the 2005 isuzu ascender vehicle idles low and dies when defrost or a/c is turned on


Common problem, will cost you about $8 and some time to fix yourself. Unhook the battery, remove the throttle body and clean it with sensor safe spray like Seafoam. When finished, hook battery back after clean throttle body is installed up and with all HVAC on off, driver around for a while so the computer relearns the newly cleaned tb.

Apr 17, 2014 | 2005 Isuzu Ascender

1 Answer

When I start my 2004 Envoy and let it idle, I turn on the a/c and the engine bogs down and sometimes dies on me. I would like to know what is wrong with it.


Betting you unhooked the battery recently. Unhook the battery again, and clean your throttle body. After clean, hook the batter back up, this will fix your problem. Very common.

Aug 24, 2013 | Cars & Trucks

1 Answer

Is there a computer rest button on a 2011 dodge avenger


no but if you leave the key on and unhook the battery then hold down either the horn or breaks to get the remaining charge all cars store even after the battery is unhooked to drain away when either the break lights stop lighting up or the horn stops blowing leave it unhooked with the key on for ten to fifteen min then take the key out and hook the battery back up that should reset it

Mar 19, 2013 | 2011 Dodge Avenger Express

2 Answers

Air bag is on after taiking seat out to clean


possibly pulled wire off sensor normally worked on weight so has to be wired under seat somewhere

Jun 01, 2011 | Volkswagen Jetta Cars & Trucks

1 Answer

I have a 2004 chevy trailblazer and whenever i turn on my a/c or heater it seems my engine losses power and wants to die.


I'm taking a wild guess that you recently unhooked or replaced your battery?

Your problem is a dirty throttle body, and if you do it yourself, can cost you about $5 for the can of throttle body cleaner. Unhook your battery again, and clean the throttle body and butterfly very well, must be shiny. Careful as the butterfly is very sharp. While removing the entire throttle body and cleaning it is best, leaving it bolted on will solve your problem too. When finished, hook your battery back up and drive around for 20 minutes or so with all accessories OFF. During this period, your computer will relearn a properly functioning throttle body.

Your computer learned some bad habits before the battery was unhooked the first time. When it was hooked back up, it thought the throttle body was clean and functioning properly. Cleaning it takes care of this problem. I do mine about once a year.

Mar 21, 2011 | 2004 Chevrolet TrailBlazer

1 Answer

My 2004 hyundai has a check engine light on with a code p1520. I clear the code and it comes back on and my car goes into fail safe mode.


P1520 Generator Front Terminal Malfunction is what that code means. you need to fix that issue as clearing the code and not fixing it will just cause the check engine light to keep coming on.

i would suggest unhooking the battery. cleaning the terminals and hooking the battery up again... if you have an antitheft radio make sure you know the code and how to enter it before you unhook the battery.

Mar 04, 2011 | Hyundai Motor 2005 XG350

1 Answer

98 Windstar w/ good battery needed jump anyway....


if the connections on the battery are clean follow those cables down into the engine compartment and check the connections down by the starter. alot of times itll be a crack in part of the line along the way or the other side fo the connection or itll be the connection going into the starter

May 18, 2009 | 1998 Ford Windstar

2 Answers

The security on my 1993 Grand Cherokee will not turn off


I may be able to help if you havent fixed it yet. I believe I had the same/similiar issue...

I would make sure all of the doors were locked with auto lock button on inside of door, then I would shut the door so all doors were locked from pressing the inside auto lock button. then I would use my key to unlock the trunk, open the trunk and close it leaving it unlocked. then i would use the key to unlock the drivers door and the security would reset... if not then unhook the battery for a few minutes then hook back up and see if that works.. glgl

Mar 10, 2009 | 1993 Jeep Grand Cherokee

Not finding what you are looking for?
2007 Chrysler Pacifica FWD New Cars Logo

Related Topics:

425 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...