Question about 1993 Chrysler New Yorker

1 Answer

Turn signal on driver side won't blink - 1993 Chrysler New Yorker

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert that has over 500 points.


    An expert whose answer got voted for 20 times.

  • Expert
  • 192 Answers

Usually either the front or rear bulb is burnt out the indicator in the car will stay on when engaged. If the bulbs are good then you probably have a bad relay which is one of the little black squares in your fuse box. Your owners manual should tell you which is which. Hope this helps.

Posted on Sep 06, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a 2002 Buick Rendevzeous. Sometimes the driver side low beam works, sometimes it doesn't. When it doesn't, the turn signal won't blink. It just stays dimmly lit. Right now, the low beam...

You have a bad electrical connection. Check the wiring harness and both sides of it's connectors for corrosion and or breakage. The connector terminals will become worn and corroded and the wiring sheaths a prone to weathering and become brittle. Replace or clean as needed.

Sep 04, 2011 | 2002 Buick Rendezvous

1 Answer

Can someone tell me where the round turn signal switch is located. On the 1991 Ciera. Not on floor or under dash. Signals won't blink.

it should be located way up under the dash behind the fuse box along side the drivers side foot panel,, ( the panel your left foot would hit on the side, ) remove that panel, and look up in there,, its not actually under the dash, but up in that side panel

Aug 07, 2011 | 1991 Oldsmobile Cutlass Ciera

3 Answers

Turn signals dont work on 1993 skylark. all bulbs are good. hazard lights blink fine. turnsignal dash light stays green and doesnt blink

There are 2 separate flasher relays. 1 for the turn signals and one for the hazards. I believe you have a bad flasher relay for the turn signals. The location of that is in the front seating area on the drivers side, under the dash on the drivers side of the steering column, mounted on support bracket. I provided a picture of what it should kind of look like although the picture I gave you is an aftermarket one so the color and such may be a little different but will look the same. Don't get it mixed up with the hazard relay which is located in the front seating area on the drivers side under the dash above the kick pane lmounted on top of the convenience. I am almost 100 percent sure the flasher and hazard relay are the same so if you want to just swap them out in order to have turn signals that should work. You won't have hazards however. I hope this helps you and good luck.


May 07, 2011 | 1993 Buick Skylark

1 Answer

Driver front turn signal does not blink. front

This may have more then one bulb in the front or possibly a bad socket try wiggling the new bulb in the socket to see if it will work.Compare all turn signal lights that come on the passenger side to those drivers side.Some vehicles also incorporate sidemarker lights with the turn signals.

May 29, 2010 | 2001 Pontiac Aztek

1 Answer

Turn lights don't blink

If the turn signals don't blink on both sides of the car, the culprit is the flasher, a small box usually located under the dash on the driver's side. Replace it with a new part.

If the turn signals don't blink on only one side, one of the bulbs on that side is burned out. Turn on the turn signal for that side and visually inspect the turn signals. Replace the burned-out bulb.

May 15, 2010 | 1999 Plymouth Breeze

2 Answers

2002 Hyundai elantra driver side turn signal not working outside

This simply means that the front driver side turn signal bulb has failed. Replace it.

Oct 28, 2009 | 2000 Nissan Maxima

1 Answer


the turn signal flasher is located under the dash, driver side, on steering column

May 20, 2009 | 1994 Pontiac Bonneville

1 Answer

Turn signal driver's side doesn't blink

A safety (warning) feature on many cars is that the turn signal light will come on but not blink. This should indicate a burned out filament in one of the bulbs on the effected side. Try checking the bulbs and replace them one by one and see if this cures the problem.

Apr 30, 2009 | 2002 Pontiac Firebird

Not finding what you are looking for?
1993 Chrysler New Yorker Logo

Related Topics:

66 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

77194 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers


Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides