Question about 2002 Buick Rendezvous

1 Answer

How do i get rid of change oil light - 2002 Buick Rendezvous

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 520 Answers

Turn on key and do not start engine. Press the gas pedal to the floor and all the way back up three times. Then on the fourth stroke down hold it to the floor for ten seconds or until the light flashes. Then you can release the pedal and start the engine. The light should then go off. If the light comes back on or does not go off then you will need to take the car to the dealer near you to have them reset the ECM. Hope this helps good luck.

Posted on Sep 06, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Engine management light on car runs fine

Service engine soon or check engine light? Engine light needs scanned for codes. Service engine soon is for oil changes and such. To get rid of service lights, turn the key on, press the gas pedal three times within five seconds. The light will flash. turn the key off. it's reset. At least check or change the oil and filter though.

May 30, 2015 | Cars & Trucks

1 Answer

I purchased car Ford Fiesta EA10 ZZM in December from Motorpoint and had a 12.500 mile service done on 30th Dec 2010. This included an oil change. Recently an amber oil change service light has come in...

No, they you just need lights reset with an OBII scanner. (They forgot to reset your service interval) Any good parts store like Advance, Autozone, etc can do this for you too and FREE

Mar 05, 2011 | Ford Fiesta Cars & Trucks

1 Answer

When i start my car after 2 minutes my oil light blinks and ive checked the oil and its full..what is it?

Hi and welcome to FixYa!

As a first course of action please remove the battery cable and let it sit for atleast 5mins. then reconnect it. This will reset the car's computer and can get rid of the oil light. If the problem persists then get an oil change. This light also flash when it's time for maintenance.

Hope this information was helpful enough and thank you for using FixYa! Have a good one!

Jan 27, 2011 | Mercury Grand Marquis Cars & Trucks

1 Answer

How do i turn off check engine light on a toyota matrix 2005 after oil and filter change

The check engine light indicates a need for a scanning with a engine scan tool (OBD-II perhaps).

An oil change will not get rid of this light.

Jul 05, 2010 | 2005 Toyota Matrix

1 Answer

After oil to get rid of dashboard message indicating the need to change oil

To reset "CHANGE OIL" light, turn the ignition switch to the run position without starting the engine. Fully depress and release the accelerator pedal 3 times within 5 seconds. The light will flash and go out.

Dec 03, 2009 | 1995 Chevrolet Impala

2 Answers

How do you get rid of the change oil light in dash board after you change the oil

turn the key on, the push and release the gas pedal 3 times, to the floor, this should reset the light. you may have to do it more than once for it to work.

Sep 27, 2009 | 2005 Chevrolet Colorado

3 Answers

Yellow Oil Light Comes on and turns off within 10secs.


Aug 31, 2009 | 2001 BMW 330

2 Answers

How to reset an oil change light

Turn the key on (do not start). Wail till the message comes up saying change engine oil. When message comes up hit the gas three times.

Apr 25, 2009 | 2006 Chevrolet Cobalt

1 Answer

Please help me

change the "o2 sensor"

Aug 16, 2008 | 1994 Honda Civic

Not finding what you are looking for?
2002 Buick Rendezvous Logo

145 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts


Level 3 Expert

78238 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides