Question about 2003 Mitsubishi Lancer

1 Answer

My lancer mx 2003(cvt). what do you think is the problem if it is not that fast when pushing it gas pedal.... theres a delay.. im talking about when overtaking.... not like the other car when you push the pedal it will automatically accelerates........not like my mx (cvt). is there a problem with the transmission of timing only.......

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 273 Answers

It could be problem with air filter choked clean or replace it.

Posted on Sep 06, 2010

  • mike_angel_1 Sep 07, 2010

    thanks i will try it...

  • lancer_3000g
    lancer_3000g Oct 15, 2012

    there is no problem on it if you take two cars like corola 1.6 and lancer 1.6 cvt they will give you same time when accelerate from 0 to 180 but the problem came from felling it's heavy and other car light because other car have many gears in transmision like manual but lancer cvt only one gear with different point

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Im pretty sure I ran my 2011 cvt mitsubishi lancer out of gas but after putting in 2gallons it had a couple rough starts but won't start at all now


There still may not be enough gas in it. When you run a vehicle completely dry it takes a quite a bit to get it running again. You have to get the gas all the way through the gas lines and to the motor. Try turning your key over just a notch (not so to start it). That will turn your fuel pump on. Give it a few minutes. Do not push on the gas more than a few times. If that does not work you may need more gas

Sep 23, 2015 | Mitsubishi Cars & Trucks

1 Answer

Could it be the booster


check your push rod going from the pedal to the booster a quick way is to pull the vaccum hose and see if they release the vaccum not being released can cause sticky problems also check your vaccum hose also

May 26, 2014 | 2008 Mitsubishi Lancer GTS CVT Sedan

1 Answer

2009 mini cooper clubman with sport button-delay when press on gas.


The fuel pressure and fuel system needs to be inspected.
-------
I suggest you few helk links.Click the link below and follow its troubleshooting procedure:------------------Pushing on the gas pedal, but the car slows down? Gas pedal to the floor and the car slows down? http://technoanswers.blogspot.in/2012/02/pushing-on-gas-pedal-but-car-slows-down.html
-------------
Car dies when gas pedal is pressed? http://schematicsdiagram.blogspot.com/2011/12/car-dies-when-gas-pedal-is-pressed.html
---------------
Car won't start without hitting the gas pedal? http://schematicsdiagram.blogspot.com/2011/12/car-wont-start-without-hitting-gas.html
-------------Car only starts when gas pedal is pressed? http://technoanswers.blogspot.com/2012/01/car-only-starts-when-gas-pedal-is.html
----------1999 Ford F-150 Idles rough and quits when gas pedal is pressed less? http://technoanswers.blogspot.in/2012/01/1999-ford-f-150-idles-rough-and-quits.html
----------Delay starting on Toyota Prius? http://schematicsdiagram.blogspot.in/2012/02/delay-starting-on-toyota-prius.html

--------
These will help.
Thanks.

Nov 26, 2012 | Cars & Trucks

1 Answer

Keeps shutiing off when Im not pushing the gas.


It's important to adjust the pedal in this case. On the floor near the pedal there should be a nob or other adjustment. Turn or crank it until it is tighter, you should notice this moving the gas pedal closer to the floor. The only down side to doing this is that when you floor your pedal, you won't go as fast.

Sep 01, 2010 | Dodge Durango Cars & Trucks

1 Answer

What is the throttle position sensor? my 2003 jeep delays starting unless i pump gas pedel. delay start is around 5 sec of grinding starter, with gas smell. fuel filter and pump are ok.


Believe it or not pumping the fuel pedal is no help. This is a fuel injection system not the old carburetor type. the throttle position sensor is a sensor to tell the computer were the fuel pedal is at it is sensing how much you are pushing it to send fuel to the throttle body.

does sound like you have a leak down problem after sitting a while you may still have a fuel pump concern

May 20, 2010 | 2003 Jeep Grand Cherokee

1 Answer

Looking to buy an 09 lancer. A little leary about the CVT tranny. I have 25 years Ford and GM experience but not much about CVTs. Would appreciate any input


I was a little leary myself when i bought the my 08 lancer gts cvt. I have only owned it for three months and has a little over 51000 km on but havent had any problems with it. You will be very impressed with the smooth operation of the cvt, the sprotronic and paddle shifters are amazing and work beautifully. I would recommend it over a regular five speed or a rough changing auto tranny. Besides the fact you should have proper warm up for it to work in colder temps(which is good for all trannys anyways) and the special transmission fluid needed. Fewer components and operates much like a snomobile belt drive system which i thought might affect gas mileage but i got a suprising 42mpg at 100km/hr. Towing anything might be an issue with this transmission since its a belt drive system(small camper or travel trailer) but im not to certain about that.So far so good......i would get another one!

Nov 03, 2009 | 2008 Mitsubishi Lancer GTS CVT Sedan

2 Answers

Cvt transmission problem


how, you can change the oil transmission

Sep 18, 2009 | 2003 Saturn VUE

1 Answer

Lancer problem


I have the same problem.... It is an easy thing to fix. What it is, is the cable has jamed up in the casing, but you can manually pull and push the cable. On the drivers side of the car under the steering wheel above the gas/brake pedals there should be a bunch of wiring. To the right of all the wiring and mess there should be a cable if you reach in far enough. It will probablly take you a while to find it. It would most likley be surrounded by white plastic. once you find the cable you can pull it and push it, When you do pull/push it you will see the knob turn on your console.

I posted a video on youtube.
http://www.youtube.com/watch?v=uaX-YASmgp8

Good luck!

Oct 13, 2008 | 2003 Mitsubishi Lancer

Not finding what you are looking for?
2003 Mitsubishi Lancer Logo

469 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...