Question about 1991 Toyota Corolla

1 Answer

Hi im trying to get water pump off to replace gasket...do i need to undo starter motor to get to pump. car is 91 corolla hatch 1300cc

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,917 Answers

Hi

Please check this link regarding your query:-

http://www.ehow.com/how_4521152_install-water-pump-toyota-corolla.html

Please accept the solution if it’s helpful. Do get back to us for any further query.
Thanks for contacting fixya.com

Posted on Sep 06, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How much a head gasket would be for a 91 Acura legend after replacing a water pump radiator and thermostat Or an motor or what my best option


I say new motor because if you dont know what your doing its all bad ...heads might be warped thats more $$ so replace motor

Nov 05, 2014 | Cars & Trucks

2 Answers

Toyota hilux surf problems


have injectors or glow plugs removed and crank engine if water cones out. your engine might have experienced overheating and you have a blown gasket or a cracked cylinder and allows water into one or more cylinders.

May 14, 2014 | 1986 Toyota Hilux 2200

2 Answers

No start after oil change plugs cap rotor air filter...


ok this is your alternator and starter malfunction, needs replacing,

Dec 16, 2013 | 1991 Toyota Corolla

2 Answers

1994 toyota corolla turns over but wont start


If you can, air dry the complete engine compartment where you used water to clean it. Possibly a few electrical connectors to the ignition system are wet. If you can disconnect these and air dry them, it may help. If you have not performed any type of maintenance like tune up, good time to do so.

Jun 27, 2017 | 1994 Toyota Corolla

1 Answer

Toyota corolla 1993 water pump leaking and steam coming from top of radiator. added chem and weld solution to radiator recently


Since the water pump is leaking there is low action of the water pump to circulate the water into the engine jackets and the radiator.
So you need to remove and overhaul or replace the water pump, replace the gasket, check the radiator for leaks with high pressure test, replace with a good cap and the fault of heating and steaming will be gone. Also check the timing of the engine, do a tune up.

Sep 15, 2011 | 1993 Toyota Corolla

1 Answer

Water pump gushing near base of pump.Do I need to replace whole pump or just replace gasket for 91 calais?


Water pumps have what is called a "weep hole" under the main pulley shaft. When this hole is leaking it is time for a new pump. See if you can check this area a bit better with a mirror and flash light. If you go after a water pump gasket, might as well replace the pump also any way. Don't forget the anti-freeze.

Nov 20, 2010 | 1991 Oldsmobile Cutlass Calais

1 Answer

How to change a starter motor on a 1989 Toyota Corolla


Hi you did not say what engine or model but based on a 1.3 12v remove disconnect the battery black (negative terminal) then the air filter housing on top with a wing nut.
then you have the carb underneeth it you can remove this to make access easier label all of the vacum hoses etc. and remove the carb by removing four bolts at all four corners at the base of the carberetor.
the starter is at the back of the engine underneeth the manifold undo the solenoid (one bolt with a wire connected) undo the bolts for the starter sorry cant remember how many. you may need to give it some gentle persuasion with a copper hammer. remove and replace.

Feb 05, 2010 | 1989 Toyota Corolla 2 Door

1 Answer

I have a 91 corolla with 78,000 miles. I've been losing coolant with no obvious leaks. Heat from the vents is sometimes hot, sometimes cool. I've checked and changed oil, and there's no coolant in the oil....


have the system pressure tested for a few hours, if pressure drops and no leaks are found you may have a head gasket leak and the coolant is going out the tailpipe

Oct 26, 2009 | 1991 Toyota Corolla

1 Answer

I just replaced the water pump on my 1990 f150


You have to take the water pump back off and the peice between the water pump and the block and take it too and clean the surface off good with a metal scraper or sharp regular screw driver and put a new gasket on or if you cant get a gasket some high temp.rtv on the surface between the block and the adaptor to the water pump.

Sep 02, 2009 | 1990 Ford F150

1 Answer

Overflow always fills,,,,radiator 1/2 full,,,when driven,,,gauge


My girlfriend has a 91 sundance. I solved that prob by doing a coolant flush and replacing the radiator cap. The gasket was torn to shreds on the cap

Mar 07, 2009 | 1988 Plymouth Sundance

Not finding what you are looking for?
1991 Toyota Corolla Logo

Related Topics:

67 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8560 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...