Question about 2002 Kia Spectra

1 Answer

Must cranck 2 to 3 time before the engine get running

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Kia Master
  • 14,036 Answers

Could be bad spark plugs and wires

Posted on Sep 06, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hard crancking when i fill the tan


run fault codes to check for faults in the canister solenoid /servo system

Nov 09, 2013 | 2003 Hyundai Accent

1 Answer

At morning the engine cranck but do not starter


If it takes several tries to start on the first attempt, you may have a problem with the fuel pump relay or the check valve in the pump.
The relay may not be powering the pump until the engine has oil pressure, and the check valve in the pump may be letting the fuel pressure drop back into the tank.
I would have the fuel pressure checked after sitting overnight.

Sep 04, 2012 | 1985 Chevrolet S-10 Blazer

1 Answer

2.9L bronco 2 will not idle without missing and backfiring was running good done all at once


It sounds like your timing belt jumped a tooth. You'll have to realign your camshaft to crankshaft and change your timing belt. Also, did you recently fill up?

Feb 28, 2012 | 1986 Ford Bronco II

1 Answer

Dosen't start cranck ok i change comp on dash sais


One thing to check: the Neon SOHC engines have a design flaw where the pin that aligns the timing belt sprocket to the camshaft shears off. The sprocket can then slip but still appears to be lined up properly. On later models the engine control software detects this because the crankshaft and camshaft sensors are out of sync and the result is that it can shut down the ignition and fuel injection but not set a code (not enough run time). Verify by taking out plugs and checking compression. If the camshaft is out of time, compression will be low. Also, valves can be bent if the sprocket slipped too much. This is the problem I had.

May 15, 2011 | 2001 Dodge Neon

1 Answer

No spark from coil to distributor, anything other than bad coil could be the problem?


I just fix my grand cherokee with that similar problem it was the cranckshaft sensor,if its a 6 cylinder its located on top of the bellhousing of your transmission you need to check the wires as well for that, some times they are bad,to trouble shoot, disconect the battery for a few minutes then conect again cranck the engine, now move the key fast off/on ( not crancking) 3 times and the last time leave it on and if it display momentarely code 0362 on your mileage display thats for sure your problem good luck

Dec 16, 2009 | 1994 Jeep Grand Cherokee

2 Answers

Cam & crank sensor code intermitten spark 2.4


are they the same engines? and i mean exactly the same? if the arent the same maybe check and look at the starter ring gear and count the teeth...also check the camshaft sprocket...is it different?

Oct 09, 2009 | Pontiac Sunfire Cars & Trucks

1 Answer

1992 jeep engine problem


When you say new parts, does that mean cranck bearings and rod bearings?
Is the noise from the top or bottom?
Top noise could be lifters or rocker arms.
Bottom noise could be crank or rod bearings.
Oil pressure?

Oct 13, 2008 | 1998 Jeep Cherokee

Not finding what you are looking for?
2002 Kia Spectra Logo

Related Topics:

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75051 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...