Question about 2003 Chrysler PT Cruiser

1 Answer

Engine cranks but wont start,was running fine,driving down road and just quit

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chrysler Master
  • 8,841 Answers

Lots of possibilities (fuel pump, ignition module, etc.). see my tips at http://www.fixya.com/cars/r5821173-doesnt_car_start_gasoline_engines

Posted on Sep 06, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

BMW 318i starts fine but once you drive it for 5 minutes switch it off, it wont start again.


sounds like a engine sensor i'd guess at the crank sensor but to be sure you would need to get the OBD codes read , this will give the exact fault so wont waste money trying sensor(s) on a hit an miss basis,you can buy a code reader online not expensive just make sure it covers your vehicle make then you have a valuable diag equipment for future use

Apr 26, 2014 | 2004 BMW 318i Touring

1 Answer

No start or quits going down road then re starts after 10 mins no spark


a bad crank sensor will cause car to shut down, and restart in about 10 minutes.while driving down the road.

Mar 13, 2014 | 2004 Chevrolet Impala

1 Answer

My chevy s10 died going down the road. It turns over but wont start


I have 94 s 10..4.3 v6. it does the same thing have replaced fuel pump and filter,ignition module,cap rotor plugs wires,coil,ground strap...driving down the road jus dies like the key got shut off....for a while when troubleshooting through the parts you could get it to restart.....now when it dies it cranks really hard when trying to restart..ive checked the timeing its fine....if i wait a few min it will usually start...sometimes it will show a check engine light sometimes not......never know when it will happen sometimes jus down the the road from the house sometimes 100miles down the road......sometimes three times in a mile sometimes not for weeks at a time..Wtf...Im ready to shoot it like a lame horse....its a shame too its a sharp lil truck thats a two owner and never spent a night outside in its life...i knew the original owner ...i bought it with 90,000 on it it only has 148,000 now and still looks like new...

Apr 22, 2013 | 1994 Chevrolet S-10

2 Answers

2001 dodge 5.9 cummins quit going down the road check engine light came on it cranks over but won't start


sounds like a injector pump to me had a 99 dodge cummins went through three of them in 350000 miles done just like you are describing.

Aug 21, 2012 | Cars & Trucks

1 Answer

Suburban stalls while driving after running for 15-30 minutes. After letting it sit for 5-10 min it runs fine for another 5-10 minutes, then starts doing it all over again.


a bad crank sensor can cause this. shuts off while going down road, and will start about 10 min, later with no problems runs fine until it quits again. hope this helps,

Oct 07, 2009 | Chevrolet Suburban 1500 Cars & Trucks

1 Answer

1996 Outback Legacy quitting while driving down road.


I would check the cam and crank position sensor, these are definitely the symptoms of a bad crank sensor.

May 26, 2009 | 1996 Subaru Legacy

1 Answer

Engine shuts off going down the road


We had a similar problem and it was the connector that connects the ignition module (bottom of coil packs to the wiring harness. The technician spread the socket connectors and it solved the issue.

Mar 17, 2009 | 1993 Oldsmobile Cutlass Supreme

1 Answer

Crank but will not start


yes .check your timeing belt

Dec 23, 2008 | 2006 Mazda 6

Not finding what you are looking for?
2003 Chrysler PT Cruiser Logo

Related Topics:

134 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

80263 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

chargerhp
chargerhp

Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...