Question about 2004 Mazda RX-8
Ok, we here found a problem similar to this, the 2006 RX8 we had has a problem with the sensor at the end of the IMT valve, which lets the computer know weather the valve is open or closed. Have a technician OHM the sensor, IF it reads open and closed, remove the valve, and clean , then clear code and drive.
Posted on Sep 09, 2013
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: Need to tow 04 mazda rx 8
Top left and right corners of the front grill pull away to reveal the fixing holes. Make sure you WD40 the threads as Mazda coat the threads with paint. insert towing eyes and turn slowly unscrew and screw a bit at a time as you have a good chance of cross threading if you don't. Keep lubricating as you go. Make sure you take the plastic inserts off completely before towing as you will loose them when towing. replace when completed towing. Good luck and hope what ever the reason for towing it is not serious.
Posted on Mar 08, 2009
SOURCE: Check engine light came on
THERE IS A VALVE ON THE RIGHT SIDE OF THE INTAKE MANIFOLD THAT OPEN THE RUNNER.IT HAS A VACUUM LINE TO IT.FOR IT TO BE STUCK OPEN EITHER THE SOLENOID IS BAD,THE VACUUM LINE IS BAD OR THE RUNNER IS GUMMED UP WITH CARBON AND STUCK OPEN
Posted on May 15, 2009
SOURCE: mazda rx8 fault code p0410
The P0410 code refers to the (secondary air system) emissions system. The AIR pump puts air to the exhaust to lower emissions. It takes in outside air and pumps it through two one-way check valves into each bank of the exhaust.
About 90% of the time that this code is set, the one-way check valves have worn out or failed and allow water (which occurs naturally in the exhaust) back into the pump. In any cold climate, especially in climates with higher humidity, this water may be more excessive. The water partially fills the AIR pump, it can then freeze. When the PCM commands the pump on, if the pump is frozen it cannot turn, thus overloading the circuit and "popping" the fuse.
A code P0410 may mean that one or more of the following has happened:
This may be covered under the emissions warranty on the vehicle. If your vehicle is out of bumper-to-bumper warranty, check if the emissions warranty is still valid!
Posted on Jun 03, 2009
Tips for a great answer:
Feb 03, 2016 | 2003 Mazda MPV
Mar 01, 2015 | 2006 Chevrolet Chevrolet Impala LT
Sep 21, 2014 | Cars & Trucks
Sep 09, 2013 | Mazda Cars & Trucks
Po660 means "Intake Manifold Tuning Valve Control Circuit/Open".it't means as same as "Engine Light ON (or Service Engine Soon Warning Light".The Intake Manifold Tuning Valve (IMTV) system is monitored for failure during continuous, key ON engine OFF or key ON engine running self-test. The test fails when the signal on the monitor pin is more or less than an the expected calibrated range
what is the reason?
1,IMTV signal circuit open, shorted to power or ground.
2, Damaged IMTV actuator.
you may learn more definition about Diagnostic Trouble Code (DTC) at:
Jul 13, 2011 | Mazda Protege Cars & Trucks
Jul 13, 2017 | 2004 Mazda RX-8
May 15, 2009 | 2001 Mazda MX-5 Miata
Nov 18, 2008 | Mazda RX-8 Cars & Trucks
841 people viewed this question
Usually answered in minutes!