Question about 2003 Cadillac CTS

Open Question

Need to replace turn signal switch on 2004 cadaillac cts

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: Left Front Blinker Replacement on 2004 CTS

changing the blinker on a CTS

Posted on Apr 10, 2009

Ad
  • 1201 Answers

SOURCE: Do you need to disable the air bag to replace the

Yes, if you accidently touch the wrong thing, it could deploy.
Disconnect the wire plug, and pull the fuse.

Posted on Jan 13, 2010

  • 1 Answer

SOURCE: 2004 CTS Cadillac front passenger turn signal bulb is out.

Actually no you don't. Crank your steering wheel all the way to the right so yo have the maxumum clearance for your hands and arms in the front of the wheel well. Remove the plastic clips that hold the wheel well splash guard and pull it back enough to allow access to the interior of your bumper.
Replace bulbs as needed.
Yes, a jack is nice and makes it a touch easier to access, but I did this in an AutoZone parking lot during a cross country road trip.
5 mins tops to complete.

Posted on Mar 14, 2010

Zeevert
  • 373 Answers

SOURCE: procedure to change turn signal light bulb on a

Remove 3 or 4 of the plastic pins holding the inner fender. They are located around the lip of the fender opening. The pins are removed by pulling the center cap of the pin straight out about an 1/8" and then wiggle and pull the whole pin out.
Pull the inner fender down and back.
Reach your arm in and grab the socket and squeeze the locking tab.
Rotate the socket counter-clockwise less than a quarter turn, and pull straight back.
Reach your other hand in and remove the bulb by pulling it straight out of the socket. It takes a 3157 bulb

Posted on Jun 22, 2010

Testimonial: "Thank you so much for your help. Really I had ask the question about 3 months ago, but since I didn't had it fixed yet, it's OK now. Franco"

  • 73 Answers

SOURCE: o replace passenger side rear turn signal bulb on 2004 Cadillac

open trunk, remove the plastic panel around the latch plate, remove the plastic mounting bolts that hold the grey trunk liners in place, there are two 10mm nuts that hold in the light remove nuts pull out light twist the bulb retainer out and replace bulb.

Posted on Aug 23, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My 2003 Cadillac cts hazard lights won't turn off. How do I disable them without turning off my turn signals also?


Need to pull wire from fusebox or dissect switch. Cud b hardjob on a caddy. A partstore can show u diagrams.

Sep 30, 2016 | 2003 Cadillac CTS

1 Answer

Temp gauge not working 2004 cadillac cts


It would have to be on a scanner to see if the PCM is sending a signal(most likely is, other gauges working). Instrument panel gauges do go bad. And they can be replaced.

Feb 19, 2015 | 2004 Cadillac CTS

1 Answer

How to change front turn signal bulb in Cadillac cts


KMTANNER is correct for the 2003-2007 CTS. For the 2008+ CTS, you need to remove the bumper. The bumper comes off fairly easy, but there are a 2 hidden screws. Look for the youtube video on removing the bumper. I have a 2004 and 2009 CTS. I did both.

Sep 13, 2014 | Cadillac CTS Cars & Trucks

1 Answer

Where is the turn signal flasher located on my 2004 cadillac cts 3.6l?


Most flasher are incorporated into the hazard switch. Check to see if you have the hazard lights. If not replace this and you will get your turn signals back.

Jul 19, 2011 | Cadillac CTS Cars & Trucks

1 Answer

How do you replace a front turn signal bulb


I replaced the front turn signal bulb on my 2004 CTS. I removed about 4? screws holding the inner fender to the outer fender, just forward of the tire. Then you reach your hand in and find the socket. Twist the socket about a quarter turn to unscrew it and remove the socket. As I recall the bulb is pulled straight out of the socket.

May 14, 2011 | 2003 Cadillac CTS

1 Answer

Replace 2005 CTS left front turn signal bulb


Sorry to reply so late.
It's got to be the same as my 2004 CTS...
Remove 3 or 4 of the plastic pins holding the inner fender. They are located around the lip of the fender opening. The pins are removed by pulling the center cap of the pin straight out about an 1/8" and then wiggle and pull the whole pin out.
Pull the inner fender down and back.
Reach your arm in and grab the socket and squeeze the locking tab.
Rotate the socket counter-clockwise less than a quarter turn, and pull straight back.
Reach your other hand in and remove the bulb by pulling it straight out of the socket. It takes a 3157 bulb

Aug 26, 2010 | 2005 Cadillac CTS

1 Answer

O replace passenger side rear turn signal bulb on 2004 Cadillac


open trunk, remove the plastic panel around the latch plate, remove the plastic mounting bolts that hold the grey trunk liners in place, there are two 10mm nuts that hold in the light remove nuts pull out light twist the bulb retainer out and replace bulb.

Jul 12, 2010 | 2004 Cadillac CTS

1 Answer

2004 CTS: what is the replacement battery...


The correct battery is a #101. But that is expensive and hard to find. I just replaced my 2004 CTS 3.6L battery with a #78. Many people use the #78 in the CTS.

May 18, 2010 | 2004 Cadillac CTS

2 Answers

2004 CTS Cadillac front passenger turn signal bulb is out.


Actually no you don't. Crank your steering wheel all the way to the right so yo have the maxumum clearance for your hands and arms in the front of the wheel well. Remove the plastic clips that hold the wheel well splash guard and pull it back enough to allow access to the interior of your bumper.
Replace bulbs as needed.
Yes, a jack is nice and makes it a touch easier to access, but I did this in an AutoZone parking lot during a cross country road trip.
5 mins tops to complete.

Feb 19, 2010 | 2004 Cadillac CTS

1 Answer

2004 Cadillac CTS 3.6L Won't start.


Check neutral safety switch and security system

Sep 14, 2009 | 2007 Cadillac CTS 3.6L

Not finding what you are looking for?
2003 Cadillac CTS Logo

Related Topics:

99 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...