Question about 2004 Toyota MR2

Open Question

Hi i have a toyota mr 2 roadster the speedo works sometimes can you tell me where the sensor is pls or does it work of the rear abs

Posted by on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
alicantecoli
  • 22326 Answers

SOURCE: Speedo erratic

sensor will be on the diff housing at the back of the gerabox

Posted on Jun 27, 2009

Ad
  • 1986 Answers

SOURCE: toyota mr2 roadster 2001 engine light on code po141 oxygen sens

bank 1 will be whichever side cylinder 1 of your engine is and bank 2 will be the opposite side. It's named bank 1 and bank 2 so that no matter how the engine is laid out, bank 1 is always on the same side as cylinder 1. I cannot say whether the right hand or the left hand one will be bank 1 as I do not know where your cylinder 1 is. The garage should know

Posted on Sep 08, 2009

  • 12 Answers

SOURCE: How do I replace the right rear wheel ABS speed

REPLACEMENT

HINT: The replacement procedures for the RH side are the same as those for the LH side.

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
  2. REMOVE SPEED SENSOR REAR LH
      1. Disconnect the speed sensor connector.
      2. Remove the nut and speed sensor rear. NOTICE:
      • Do not attach any foreign matter to the sensor tip.
      • Ensure that no foreign matter enters the sensor installation hole.
    1. INSTALL SPEED SENSOR REAR LH
      1. Install the rear speed sensor with the nut. Torque: 8.0 Nm (82 kgf-cm, 71 inch lbs.) NOTICE: Make sure that the sensor tip is clean.
      2. Connect the speed sensor connector.
    1. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL Torque: 3.9 Nm (40 kgf-cm, 35 inch lbs.)
    2. CHECK ABS SENSOR SIGNAL
d807a26.gif

Posted on Sep 26, 2009

Testimonial: "Simple to understand, straight-forward answer provided very quickly. Thanks Much "

timsauto123
  • 750 Answers

SOURCE: i have toyota camry abs lights on since i changed

you have to take it to the dealer to have it on a toyota computer and dial in all sensors.











TIM

Posted on Jan 04, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Speedometer of a toyota yaris its not reading


the speedo works with the abs speed sensors. note the following
1- is your abs light staying on

2- was any work done on the cv joints , if so did they fit the ring gear on the cv

3- are all the fuses ok

Sep 21, 2015 | Toyota Cars & Trucks

1 Answer

97 nissan 2 4 speedometer cable


Sounds as if it is a cable or the speedo sensor. If there is ABS it could also be the ABS sensor playing up on one of the wheels.
Best advice is take it to a diagnostic place or find a local mobile diagnostic mechanic where they can tell you why the light is coming on the desk.. This may be a cheaper way as they may be able to tell you the exact part which is showing the fault.

Apr 12, 2014 | 1997 Volvo 850

1 Answer

99 silverado abs light stays on transmission won't shift from 1st and speedo doesn't work I have replaced all vss sensors and checked fuses and still no luck help please!


for the speedo its going to be a speed sensor and with the ABS light on it will probably be an ABS sensor you'll have to figure out which one.Does the speedo go crazy sometimes or just doesn't work at all

Mar 28, 2014 | Cars & Trucks

1 Answer

1998 dodge Dakota Ok so I just got this truck and when I got it the abs light and brake light were on plus the speedo doesn't work sometimes I replaced the rear speed sense on the diff but the lights...


If the red brake light and the ABS light are both lit up on the dashboard, do NOT drive the vehicle. It indicates a major malfuntion with the brake system. The red light indicates low brake fluid or the parking brake engaged. The yellow ABS without the red light, indicates a problem the computer found and it disables the ABS system while still having conventional brakes. Since both are lit, it needs the brake system repaired. What you replaced on the rear diff was probably the rear ABS sensor. The vehicle speed sensor for the speedometer should be located on the rear of your transfer case if you have 4WD, or on the rear of the trans if you have 2WD.

Oct 11, 2012 | Cars & Trucks

1 Answer

Abs light stays on also speedo stops working


Hi, I am new to the website. I am an automotive technitian. If the ABS light is on ,and the speedo wont work, your vehicle speed sensor (vss) is likely the cause! The ABS system depends on knowing the individual wheel speed and the overall vehicle speed in order to properly operate. The fact that your speedo also is out tells me that either the sensor is bad or there is a wiring problem. The ABS light will stay on and will probably be in "limp mode" until the problem is solved.....if you live in a snowy or icy place be careful because it probably wont work! If I am right, even a simple code scanner like an auto parts store has for free use will show a vss code since it will affect other systems in the car such as shifting points and fuel trim. I have no history on your car...and dont even know the type of car it is so I hope this has been helpful!!

Jan 03, 2012 | Cars & Trucks

1 Answer

I have a toyota aurion 2007 v6. speedo not working


I just had a non abs spindle put on my 06 corolla and my speedometer stop working and I have an abs light on now
so i am gonna try to put an abs spindle on and recconnect the abs sensor
hopefully that is the problem just an abs sensor connection

Feb 15, 2010 | 2006 Toyota Corolla

1 Answer

2000 powerstroke abs light on speedo not working od light flashes


ok one thing to do is scan codes to see which sensor is not reading. then go to it with a scanner hooked up. youre gonna be able to see live moh parameters or windows to see live data anyhow access the rear which isnt working. jack up truck safely put in drive then proceed tothe rear sensor wire. u can do this at any sensor that isnt reading. u then look at the mph window in scan tool an watch it while u wiggle the affected sensor wire goin to the harness. watch for jumps an droputs of the mph parameter while wiggling sensor wires from sensor all the way to the harness. thats how its done looking for broken wires. food luck hope this helps

Oct 22, 2017 | 2000 Ford F250 Super Duty Crew Cabs

1 Answer

Speedo not working on astra 03


if ur car doesnt have abs brakes the sensor should be on the topside of the gear of the differential, right on your gearbox, it has 2 cables and it looks like this
http://www.alibaba.com/product-gs/242337100/Vehicle_Speed_Sensor.html

hope this helps

take care and have fun!

Apr 14, 2009 | 2003 Volkswagen Golf

2 Answers

2005 ToyotaCamry fault code P0500 Vehicle Speed sensor Malfuction


They are not the sensors you want. The car uses the abs wheel sensors for vehicle speed. Your problem lies in the abs system , possibly the left front sensor, abs ecu or speedo cluster, Clear the code and see if it stay out otherwise you'll need to go to a trusted technician. .

Mar 13, 2009 | 2006 Toyota Camry

Not finding what you are looking for?
2004 Toyota MR2 Logo

Related Topics:

126 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...