Question about 2005 Chevrolet Impala

1 Answer

Sometimes the car won't crank at all, you might try and then on the sencond try it will start. If it's ju,ped it will start.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 8,180 Answers

Clean and tighten battery terminals.

Posted on Sep 05, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

L have a 2003 Kia Sorento, sometimes it will just turn over but won,t crank. after a while it will start up. or l can be driving down the road and it will start poping and cut off, and won,t start.it does...


It will be a position sensor problem Check the air gap and check that the censor rotor is tight and that there is no material getting in the air gap causing a problem

Jan 06, 2014 | Kia Cars & Trucks

1 Answer

Harmonic balancer


align the key way and push it on the end of crank shaft install a ballencer installition kit with bearing abd tighten till its flush dont hit with hammer this causes bad ju ju in the thrust bearings in the engine

Sep 04, 2013 | 1999 Jeep Grand Cherokee

1 Answer

My Camry sometimes won't start nor crank either.


Could be a battery cable connection, faulty starter, or the neutral safety switch. You would need to know if you have battery power at the starter terminals when it fails to crank.

Jun 24, 2013 | Cars & Trucks

1 Answer

94 cutlass ciera s won't crank


It could be a near-dead battery. Sometimes they have enough power for lights/etc. but not enough to crank.

Apr 01, 2013 | 1994 Oldsmobile Cutlass Ciera

1 Answer

My 4 runner starts sometimes and won't other times, it justs cranks over but won't run


As with any no start issue, you will need to check for spark and fuel pressure when it won't start to know how to proceed.

Aug 19, 2012 | 1997 Toyota 4Runner

1 Answer

Can you tell me where the crankshaft sensor is located? Would this being bad make it not start sometimes? Sometimes it will start up, other times, not. Sounds like the fuel pump is not running when it...


the crank sensor is behind the crank pulley and must pull off the pulley to gain access to it and it must have the air gap set so the timing slots don`t hit it when the motor is running,this can cause your problem also if the wires rub through by the crank pulley can cause it as well.you say you don`t hear the fuel pump running when it won`t start then you need to make sure that is what is happening as this will cause an intermittent no start(pump works sometimes).do you get a 2 second run pump prime when the key is turned on and a no start then it could be the crank sensor as the computer looks for a crank signal from the crank sensor when trying to start the car.

May 03, 2011 | 2001 Pontiac Grand Am SE

1 Answer

My blazer trys to start but wont turn over and its not every time some times it will some times it wont. i had the fuel filter changed in it cause someone told me to try that but there is no differece.


by not turning over i`m guessing that you mean the engine won`t crank over,if you mean won`t start when the engine turns over then that is a different path of diagnosis.if you mean that it starts to turn crank over but stops almost immediately then this could be a weak battery,or bad starter with a bad spot in the starter,that`s why it will start sometimes and sometimes not as the starter hits and misses stopping on the bad spot.if you mean it cranks over fine but will not start then this could be a fuel pump going bad,a dirty throttle body,a bad crank of cam sensor,these usually set a code in the computer and sometimes turns on the check engine light sometimes not.you should have the computer checked for codes to see if there is any,or just a wiring problem for the ignition system

Mar 09, 2011 | 2000 Chevrolet Blazer

1 Answer

Honda odyssey cranks excessively when engine is warm


I find that in most fuel injector cars this can happen if the car is not given a couple of seconds to pump enough fuel to charge the injectors properly, especially on warmer days.

Try this: The next time you test this, instead of putting in the key and turning it all the way to start in one smooth move, try moving the key to the ON position, leave it there for a couple of senconds (you should hear the fuel pump whirr for a couple of senconds, then shut off. This means it is finished charging the injectors to the right pressure) then move the key to the start position to crank. See if that helps... (it has helped me...)

Apr 22, 2009 | 1988 Chevrolet K1500

Not finding what you are looking for?
2005 Chevrolet Impala Logo

Related Topics:

30 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...