SOURCE: lotus elise 2005 fob and key does not work
Re-synchronize the FOB if the problem is with just one key.
1. Hold down both buttons simultaneously until the fob LED goes out. (10 seconds)
2. Release both buttons -- the LED should come on and stay on.
3. Press the larger fob button for a second, and the LED should flash.
IF re-synchronization doesn't work, you may have to replace the fob. Call customer service with your PIN (on the key-card that came with the keys). IF you don't have the PIN, then you need to call customeor service to confirm/register your ownership of the car.
If the keys are re-synchronized and it still doesn't work:
Re-program.
1. Re-synchronize as above, if you have not done so.
2. Turn the ignition on 3 times within 7 seconds. The red light above the odometer should light and stay on for 3 seconds.
3. Enter the PIN. Immediately after the red light goes out as per 2 above, switch on the ignition and count the number of flashes until it equals the number of the first digit on your PIN, then turn the ignition off, then on again. Do this for all four numbers.
4. What a pain, but if you get it wrong on a count, then you can restart by turning the ignition off for 10 seconds.
5. After the fourth digit, if the PIN is correct, the red light will stay on. Then you can re-test the fobs, and it should work.
Otherwise, call customer service.
Hope this helps.
SOURCE: WHAT IS THE A/C R134a
there should be a label in the engine compartment that gives the A/C system capacity. If you can't find that a call to the dealer parts department will tell you. Hope this helps
SOURCE: where is the blower motor and resistor on 2005 lotus elise
try under the bonnet on passenger side
SOURCE: Any parts for a Lotus Elise 111s where is the best part to buy it
try sj sports cars . www.sjsportscars.co.uk
SOURCE: Lotus elise heater fan has stopped working. What
it is poor design on behalf of lotus the resistor pack that controls the fan is mounted externally below the fan unit and subsequently gets wet corrodes and fails. it is a difficult job not for the faint hearted and requires **** shell removal. There is a lotus mod released to fix this fault i would suggest using it prevent future trouble. Speak to a lotus dealer or specialist.
371 views
Usually answered in minutes!
×