Question about 2004 Chrysler Pacifica

1 Answer

Chrysler pacifica 2004 overheat water boiling, y change the thermostat still same, what next step?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 707 Answers

You may want to flush the system.........If you have an air lock in the sistem would also cause this problem.........I would also change the temp sensor.Hope this helps.

Posted on Sep 04, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

If a water pump in a 2004 chrysler pacifica with 3.5l is leaking would it run out right below the crank pulley


This is common water pump failure on the pacifica, the bearings start to leak.
Since it is ran off the timing belt it is very common for the coolant to eat away at the timing belt, once that belt breaks your engine is destroyed.
This is not a repair that is OK to put off, replace the water pump timing belt and tensioner

Sep 20, 2014 | 2004 Chrysler Pacifica

1 Answer

How to replace a EGR valve on a 2004 pacifica 3.5


The EGR is on the drivers side of the engine near the firewall side next to the exhaust pipe it has a wire to disconnect then take out the two bolts that hold the tube to the valve now remove the two bolts that hold valve to engine put back in reverse order

Sep 17, 2014 | 2004 Chrysler Pacifica

1 Answer

Coolant overflow boiling// thick foam


flush thoroughly and have fresh anti freeze,replace thermostat

Jul 03, 2014 | 2004 Chrysler Pacifica

1 Answer

Slow heat up on a chrysler pacifica


Thermostat is stuck open or missing (some people take them out) i don't advise this.

Dec 09, 2013 | 2004 Chrysler Pacifica

1 Answer

Water starts to boil


see the diagram and fix it. God bless you
d24f66be-9d1d-46bc-b77c-3dae4d5ce54f.giffba1a37a-4699-4454-98ff-b17e6db645e8.gif

Jul 31, 2013 | 2004 Chrysler Pacifica

1 Answer

How does the thermostat fit properly in the housing


selectachapter.gif

Pacifica, 2003-2005
Removal & Installation

Print Here is how to do it,if it does'nt fit right make sure you have the right thermostat.


3.5L Engine


CAUTION Never remove pressure cap with the system hot and under pressure because serious burns from coolant can occur.

  1. Disconnect negative cable from remote jumper terminal.
  2. Drain cooling system.
  3. Disconnect radiator upper hose from thermostat housing.
  4. Remove thermostat housing bolts.
  5. Remove housing, thermostat, and gasket.

    0996b43f80204be2.jpg enlarge_icon.gifenlarge_tooltip.gif

    Fig. View of the coolant outlet connector (1) and thermostat housing (2)-3.5L engine
    View of the coolant outlet connector (1) and thermostat housing (2)-3.5L engine

  6. Clean gasket sealing surfaces.

To install:
  1. Install thermostat and gasket into thermostat housing. For ease of installation, install bolts in housing for thermostat and gasket retention.
  2. Install thermostat and housing to the intake manifold. Tighten the bolts to 105 inch lbs. (12 Nm).
  3. Connect radiator hoses and install hose clamp.
  4. Refill cooling system.
  5. Connect negative cable to remote jumper terminal

May 02, 2012 | 2004 Chrysler Pacifica

1 Answer

Car overheating! Its a 2004 Pacifica. Gauge doesn't change while in park but shoots up while driving.


Hello mayaponce and thank you for asking your question, on Fixya.

Here is a simple process that will walk you through a few steps that will pinpoint the overheating problem on your 2004 Chrysler Pacifica, without even using any tools. It has helped millions of people, and I am certain that it will help you, because I wrote it for people like you. So here is the link to:
How to diagnose your overheating 2004 Chrysler Pacifica

Anyways if that helps you any little bit, then feel free to follow me on Twitter. That one is at: twitter.com/acoates23234

Thanks for the vote, and good luck!

Nov 08, 2010 | 2004 Chrysler Pacifica

2 Answers

2004 pacifica radiator overheats every couple


A fan is on or off not slow do any fans in your house run slow because they are old?Your thermostat fan or temp sensor is bad

Jun 27, 2010 | 2004 Chrysler Pacifica

1 Answer

2004 chrysler pacifica water in floor board


the ventilation system of this vehicle has a drain. This may have been plugged from debris that lays in the cowl. I would suggest on your next oil change to have the mechanic clean the drain hose underneath the car.

Sep 03, 2009 | 2004 Chrysler Pacifica

1 Answer

How to change the spark plugs in a 2004 Chrysler


get a haynes manual for a charger it has steps for the v6 to remove the **** to get to your spark plugs

Jul 12, 2009 | 2004 Chrysler Pacifica

Not finding what you are looking for?
2004 Chrysler Pacifica Logo

Related Topics:

425 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...