Question about 2000 Buick Century

1 Answer

Blower motor has no speeds put new resister in 4 times works on 3 speeds then stops hocked fan moter up and it works its on a 2000 buick centery

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Buick Master
  • 8,574 Answers

There is a short between the resistor and the motor. Recommend you replace wiring from resistor to the blower.

Posted on Sep 04, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Blower motor speed not working


This is usually due to 1 of 3 possible problems.

  1. Bad blower motor resistor - attaches to blower motor and regulates fan speeds. Not uncommon to lose 1 speed at a time until you get stuck with only 1 speed
  2. Bad blower motor
  3. Bad heater control module - less likely but still possible the module is bad and the whole unit requires replacing

Oct 16, 2011 | 2000 Kia Sportage

2 Answers

Heater blower stopped working?


Hello,
You may want to try your fan on all speeds. If it will work on high, you have a bad resistor for the fan motor. ( high speed doesn't go through the resistor ).
If it doesn't work on any speed, I would check the following;
1. Make sure the fuse isn't blown for the fan blower motor.
2. Check, or have checked the wires between the fan control switch and the fan blower motor.
3. Have the fan control switch checked.
4. Have the fan blower motor checked.

I hope this helps you.

Feb 03, 2011 | 2002 Buick Rendezvous

2 Answers

How do you fix a fan speed control that only works on speeds 3, 4, and 5?


replace blower motor resister this can be found not far from blower moter usally

Dec 14, 2010 | Pontiac Grand Am Cars & Trucks

2 Answers

Ok, my blower was not working at all. It used to work on the 2 and 3 setting. I replaced the resistor nothing. Took out blower and hooked it up to 12 volts it came on. So I went and bought a new control...


the blower motor is going. It's drawing too much current and taking out the resistor pack. It has a thermal limiter that melts when the resister gets too hot. Repalce motor and resistor.

Dec 10, 2010 | Ford Focus Cars & Trucks

1 Answer

2000 Buick Century. Blower quit working for


I had the same problem. It turned out to be the ignition switch. i have no idea how that is connected to the fan but... it worked, got me my fan speeds back, although it is not working again...

Jul 16, 2010 | 2000 Buick Century

1 Answer

Speedometer and Heat blower not working


The fan motor has gone out,it was bad before it went out,drawing too many amps,so it took the blower motor resister out with it.The resister is next to the blower motor.On the speedo,check,or replace the speed sensor in the transmission,

Nov 20, 2009 | 2000 Ford Focus

1 Answer

Fan for the a/c - heat will only work on high.


Common issue for many cars, Jeeps big time. Your "Blower Motor Resister" is defective. The reason for only 4 on the speed is the resistor controls the voltage going to the blower motor on the lower three speeds. This is a common problem, don't let anyone tell you it is the blower moter itself. The part should cost between $20-$40, depending on where purchased. The killer is getting it installed, some are easy to get at behind the glove box, others are up in the dashboard harder to get at. Chevy techs should be well aware of this, and be able to give you a good estimate of repair.

Oct 01, 2009 | 2005 Chevrolet Colorado

2 Answers

Blower fan stops working and then starts again


My suggestion is replacing your wiring going to the resistor which is acdelco part number PT1231. I have had the problem of speeds 1,2, and 3 intermittently working while 4 always worked. Afterreplacing this part, all of my fan speeds work all of the time.

Mar 21, 2009 | 2004 Chevrolet Colorado

1 Answer

Blower fan


it sounds to me like your blower moter resister or your blower moter switch are going bad both are right under the hood next to the blower moter one has 2 witers on it the other has 4 it usuley on the pass side right near the window

Dec 03, 2008 | 2000 Chevrolet Venture

3 Answers

Lights out


The radio light is a separate issue and not related, the radio needs to be pulled out and a tiny bulb inside the radio replaced that lites up the display, the other issue is caused by a burnt out blower speed controller circuit or module.

Aug 05, 2008 | 2000 Pontiac Grand Prix

Not finding what you are looking for?
2000 Buick Century Logo

208 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...