Question about 2005 Chrysler Crossfire

1 Answer

Chrysler crossfire fan control module waht part is that

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 385 Answers

Your local auto parts store can give you your specific information, as can the parts desk person at your local dealership or possibly even an aftermarket repair shop by using an electronic component locator manual. your local auto parts store will probably be the most willing and friendly.

Posted on Sep 04, 2010



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer


Radiator fan operation is controlled by the Total Integrated Power Module (TIPM) with inputs from the Powertrain Control Module (PDC). Inputs for coolant temperature and vehicle speed are sent to the the Powertrain Control Module (PCM) (1). This information is then sent via the communication bus to the TIPM which turns on the radiator fans.
Refer to Radiator Fan Operation Chart for fan operation specifications. For fan circuit wiring diagrams, refer to WIRING DIAGRAMS.
If the cooling fan is inoperative or a Diagnostic Trouble Code (DTC) related to fan control has been set, (Refer to 28 - DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Diagnosis and Testing) for diagnostic procedures
One fuse #15 50 amp. No relay , controlled by the TIPM ,computer controlled .

Nov 07, 2017 | Chrysler Cars & Trucks

1 Answer

Location of the heater fan motor on a 05 Chrysler crossfire

Usually, blower motor, under passenger side dash. The fuses as shown, depending on which vehicle. Not only check the fuse, use a test light and check voltage on fuse circuit, hot all the time. At the blower motor connector, red wire is voltage, brown wire is chassis ground. The white wire with pink tracer is probably pwm signal for blower speeds, from hvac control module. My database doesn't have much info on your hvac system.
blower fuse-4nsdvjajcwlcsirt3axsefln-2-0.jpg

Aug 27, 2017 | Chrysler Cars & Trucks

1 Answer

Where is the fuse for the engine fan motor

there is a radiator fan control module on the drivers side near the dffront of the vehicle. There is also two fuse blocks under the hood, one on the right side in front of the battery and one on the left near the antilock brake controller. The fuse for the radiator fan should be in one of those blocks if not in the radiator fan module itself. If the fan fails to run, you might check the control module to see if it is malfunctioning. The owners manual will give you a reference on the fuse location as there are additional fuses under the dask in the Crossfire I believe.

Jun 27, 2014 | 2006 Chrysler Crossfire

1 Answer

2005 Chrysler Crossfire SRT-6 top speed 120?

  • The claim from Chrysler is that the top speed for the Crossfire is 158 miles. This is electronically controlled from the computer.

  • Hope this helps and thank you for using FixYa.

Regards, Tony

Aug 21, 2011 | 2005 Chrysler Crossfire

1 Answer


I had to have the dash taken off cleaned out all hoses and replaced the great now

Jul 08, 2010 | 2005 Chrysler Crossfire

2 Answers

2004 Chrysler Crossfire won't start. Drove in

This is not the problem I have a chrysler crossfire and experienced the same problem there is some good news if it frequently stops working for no reason the problem is most likely the RCM module has a shortage in it I fixed my crossfire and 3 others buy repairing the RCM its easy and simple any question you can email me I can give you a easy walk through to fix the problem and avoid paying hundred at the dealership it shouldn't take no more than 15 minutes to fix DIY!!

Apr 05, 2010 | 2004 Chrysler Crossfire

1 Answer

The Chrysler Crossfire is a nice "looking" vehicle but I've had an issues that my engine would shutdown without warning. The car would restart upwards to about 2 hours later but would shutdown again...

It is a bad solder joint in the RCM (Relay Control Module). Have the dealer replace the module and you should be fine. This is a known problem.

Feb 02, 2009 | 2005 Chrysler Crossfire

1 Answer

Replacing cooling fan

Check the fuse, if that's not it, check the thermostat.

Jul 04, 2008 | 2004 Chrysler Crossfire

Not finding what you are looking for?
2005 Chrysler Crossfire Logo

Related Topics:

541 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

80531 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides