Question about 1993 Oldsmobile Eighty Eight

1 Answer

What is the proper tire pressure for a 1993 olds 88

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 10,319 Answers

Tire manufactures rate their own tires for proper inflation. Look at the inner part of the tire near the rim for the correct tire pressure needed

Posted on Sep 04, 2010

  • J McKiness
    J McKiness Dec 18, 2014

    This is absolutely NOT true! The pressure rating on the tire is the MAXIMUM allowed pressure NOT the proper pressure for the specific vehicle. After all the tire manufacturer does not know what vehicle you installed the on.



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Instructions on changing front brakes on a 1993 delta88 oldsmobile 1993

    • 1Loosen the lugs nuts using the tire iron. Place the wood blocks in front of the tires you will not be removing.
    • 2 Raise the vehicle using the floor jack. Set the jack beneath the support strut that runs along the outer edge of the undercarriage. Raise it enough to allow the tires to clear the ground. Place the jack stands underneath the same strut as the jack.
    • 3 Remove the lugs nuts completely and take the tire off. Set these all aside.
    • 4 Remove the mounting bracket bolts with a socket wrench. The mounting bracket is the metal half-circle that is revealed when you remove the tire. Tie the mounting bracket to the undercarriage with rope to prevent stress damage to the brake line.
    • 5 Remove the brake pads from the bracket by hand.
    • 6 Compress the caliper cylinder with the C-clamp. The caliper cylinder is the 3- to 6-inch wide cylinder in the center of the bracket. Make sure that it is flush with the bracket.
    • 7 Install the new brake pads where the old ones were.
    • 8 Reattach the mounting bracket to the rotor. Reattach the tire and finger-tighten the lug nuts. Lower the vehicle and the tighten all of the nuts with the tire iron.

Apr 08, 2014 | 1989 Oldsmobile Delta 88

1 Answer

I need instructions on how to replace the rear brakes on a 1990 Oldsmobile delta 88

never changed brakes on any car and would like to on my front tires. its a 1993 oldsmobile delta88

Oct 29, 2011 | 1989 Oldsmobile Delta 88

1 Answer

Where is the fuel filter located on my 1993 olds 88 royale?

In front of the fuel tank on the passenger side of the vehicle,tucked up under the vehicle.About 18 inches from the passenger side rear tire.

Apr 13, 2011 | 1993 Oldsmobile Eighty Eight

1 Answer

What tire pressure for 1993 mecury sable....nothing in book or door,....low tire just don't want to over inflate

Look carefully on the tire itself. The max pressure WILL be stamped into the tire side wall. You then choose how close to max pressure you want to run. heavy load ?? Max pressure. Normal load a few pounds below max.
Note ---- The closer you run to max the better your fuel mileage. You will get a "stiffer ride" with max. You will feel the bumps more.

Mar 03, 2010 | 1993 Mercury Sable

2 Answers

What is the proper tire pressure for my '94 Olds LSS with Goodyear P225/60 R 16 tires

The max infaltion will be stamped on the tire itself, I would inflate to manufaturer spec., which will be on the drivers door or door frame on a little sticker. If it is not then it may be in the owners manual. If it can't be found in those places then go by whats on the tire (which will prob. be max 44 psi).

Oct 08, 2009 | 1994 Oldsmobile 88

1 Answer

My 1993 Olds 88 wont start cranks but wont kick over. Fuel prob

3.8 are known for ignition trouble but first use the fuel release valve located on top of engine under a screw cap to see if your getting fuel. It takes 4 things to make engine run fuel spark air and compression. But most likely the Ign control module or crank sensor. So try this
1) check the fuel pressure
2) check for spark
3) compression test

Apr 26, 2009 | 1988 Oldsmobile Delta 88

1 Answer

Tire pressure

Factory recommended tire pressures are usually on the drivers door frame, check the decals for size and tire pressure.
a second site is on the inside of the gas cap cover.

Apr 15, 2009 | 1987 Oldsmobile Cutlass Supreme

Not finding what you are looking for?
1993 Oldsmobile Eighty Eight Logo

Related Topics:

149 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts


Level 3 Expert

79123 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides