Question about 1989 Nissan Sentra 4 Door
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 1996 nissan sentra
Find the big hose that comes out of the top of the radiator and follow
it to the engine and that is where the thermostat is located. My
advice is to be sure to get a factory thermostat and rubber gasket as
it makes installation much easier. I have done it both ways and the
factory one is easier to install.
Posted on Jun 29, 2008
it should be underneath your car in between the firewall and the engine. Now you don't want to supply direct power to your starter because you'll end up frying it. However to just start the car once you've located the starter, get a long screwdriver with a plastic handle and connect the two wires with the screwdriver.
As for a long term fix, without investing the money to replace the necessary parts. You will need to attach a wire that can handle 12v to both wires on your starter separately. Then connect the other ends of both wires to a switch that can handle 12v, and mount that in your car somewhere. Then whenever you need to start your car just flip the switch on until the car starts then once it is started flip it back off.
I know this sounds like a lot but it is very doable with about $5 and a little bit of time.
Posted on Jan 30, 2009
im not completely sure but maybe one of these answers can help ya...... 1. the starter is connected to the bellhousing (the part of the transmission that connects to the engine) and sits above the tranny but on the fire wall side.
or ....2.The bolt heads to unbolt the starter on the Sentra are located on the left side of the engine under the air cleaner and air inlet housing to the fuel injector intake. These housings must be removed to access the bolts heads, and then the starter is taken out from under the car on the right back side of the engine. The hardest part is disassembly of the intake housing to get to the bolt heads for starter removal.
Posted on Jun 25, 2009
Negative battery cable Air inlet tube Harness bracket Wiring at the starter Starter
Install or connect the following:
Starter and torque the bolts to 60 inch lbs. (7 Nm) Starter electrical connectors Harness bracket Air inlet tube Negative battery cable
Thanks for using FixYa - a Very Helpful rating is appreciated for answering your FREE question.
Posted on Jul 31, 2009
Tips for a great answer:
Jul 22, 2015 | 2001 Nissan Sentra
Jan 12, 2013 | Nissan Cars & Trucks
Jul 26, 2012 | 1993 Nissan Sentra 4 Door
May 22, 2012 | 2002 Nissan Sentra
Jan 27, 2012 | 1997 Nissan Sentra
Jan 11, 2011 | 1983 Nissan Sentra
Dec 16, 2010 | 1992 Nissan Sentra 4 Door
Jan 29, 2009 | 1996 Nissan Sentra
Jan 28, 2009 | 1989 Nissan Sentra 4 Door
37 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: