Question about Chevrolet Impala

Open Question

How to test coil on 1963 chevy impala - Impala Chevrolet Cars & Trucks

Posted by on

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 4 Answers

SOURCE: i have 2000 chevy impala . 4.8 mis fire on cly 3.

I had misfire on cylinder 3 and i had to change the connection rod bearings, extremely hard to do unless you have the proper tools because you need to remove the oil pan to get to it. take to mechanic

Posted on Jun 11, 2010

  • 4 Answers

SOURCE: I'm helping a buddy with his car. I was wondering

If you want to tune the timing for performance, use a degree timing light. Find the straight mark on the harmonic balancer. On the timing cove is a tab or it may have a aftermarket timing mark bolted to the timing cover. With the vacume advance unpluged from the distributor and the vacume line plugged (to prevent a lean condition).

Use the trottle and rev engine to 1500 rpms. Set the timing light to 32 degrees and adjust distributor until the marks on the harmonic balancer and the zere mark on the tab align. Tighten distrubutor clamp and recheck one more time.

Posted on Jan 14, 2011

  • 248 Answers

SOURCE: looking for a 1963 chevy

I found a 1963 Chevy Impala owners manual on Ebay for $18.00 plus S&H.

http://cgi.ebay.com/ebaymotors/1963-Chev-Impala-Factory-Owners-Manual-_W0QQcmdZViewItemQQhashZitem588bc7461eQQitemZ380302214686QQptZMotorsQ5fManualsQ5fLiterature

Posted on Jan 18, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What type of ignition coil should I buy ?? resister type or normal it is a1979 1600cc


1979 1600cc what? Early chevy cars (1963 for example) had a resistor wire between the coil and the ignition switch that took the place of a resistor coil. The theory here is that when cranking to start, you want the full 12 volts that by ohms law means you have lower amps, but higher voltage to jump the cold spark plug gap and make for easier starting. Once running, you have a resistor that reduces voltage but increases amps, to get a fuller burn and better efficiency. THEREFORE, you can test for voltage being supplied to the coil at "key on" to see which coil you need. If you have full 12 volts, buy resistor coil. If more like 6.8 or so, use non resistor coil.

Mar 23, 2016 | Cars & Trucks

2 Answers

Where is the fuel filter on a 2000 chevy impala


I have a 2000 chevy impala and i have replaced wires and ignition coils, it starts ok, but when you drive it , it drives rough and stalls.do you know what this may be?

Jan 31, 2011 | 2000 Chevrolet Impala

1 Answer

How do you check drivers side heated seat coil on 03 chevy impala to see if its bad?


the easy way is to check it with a multi-meter check it for a power shart to groung or the most common is open curcuit, the heater element is burnt and the coil has an open and that will not complete the circuit. a continuty test would show that, good luck.

Jan 22, 2011 | 2002 Chevrolet Impala

2 Answers

2003 Chevy Impala 3.8L #3 and #6 not firing, we replaced the coil still not firing. Husband doesn't think 2 plugs would go bad at the same time any suggestions?


may be a bad module it is under the coils I think 3 and 6 are on the same coil so that would make both cyls not fire

Apr 12, 2010 | 2003 Chevrolet Impala

3 Answers

Ignition control module on a 2001 Chevy Impala


There is a switch relay that plugs behine the ignition switch cylinder.You would have to take apart the dash console to take it apart to replace it.Also helps solve a few problem on the 2001 chevrolet impala, with heat gauage not working and a/c not blowing cold air anymore.Replacing it, should fix the problem with that.

Apr 11, 2010 | 2001 Chevrolet Impala

1 Answer

2002 chevy impala car wont start coil not firing


You can take the distributer out and spin it yourself. You can also take the distributer, coil, etc., in to a place like Autozone to have it checked. But make sure there is power coming from the ignition switch and getting to the coil first.

Jan 20, 2010 | 2002 Chevrolet Impala

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

37 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...