Question about 1996 Audi A4

1 Answer

Fob wont work i have put new batteries in it - 1996 Audi A4

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 4,793 Answers

Put key in door unlock/hold key over,windows will go down,wait 30 secs....lock car/hold key over,windows will go up wait 30 secs.then press/hold unlock button on remote for about 30 secs,you have just reset system,if that dont work, you will need to put it on diagnostic computer.....

Posted on Sep 04, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Alarm wont set 2008 jeep commander


the car came with 2 RKE FOBs
are both dead.?
alway have 3 FOB if not you can not reprogram a new one. self.
can cost you $300 for more to tow your car to the dealer if the 1 fob dies. never run one fob. or bad happens.
put in a new battery in the FOB for door issues
the transponder part does not use the battery .
the transponder must be good, or the car would never run.
the jeep cuts fuel after 2 seconds if the transponder fails.

Apr 20, 2014 | 2008 Jeep Commander Sport

1 Answer

Key fob wont re set on my ssan yan rexton


I recently changed the battery on my key fob for my ssanyong rexton. I then did the following for the key fob to make it work. 1. Enter vehicle and close all doors.

2. Put seatbelt on (or clip it into the buckle) to shut the warning buzzer off.

3. Put key in ignition, turn to run position but don't start it.

4. Press and hold both buttons on key fob until red light on fob stays on. Then let go of both buttons. Then pressed the alarm button then the panic button, somthing like that. To be fair the button sequence after the red light came on is a bit vague. The alarm was blaring so i was happy when it just stopped.

May 23, 2012 | SsangYong Rexton Cars & Trucks

1 Answer

1996 dodge grand caravan le key fob doesn't work, batteries are good. Can I need to sync it or reset it?


I put a new battery in the key fob for a 2008 Dodge Grand Caravan, and, at first, it still didn't work. Took it to the Dodge Dealer, who said the fob was dead. NOT SO! My husband put a little piece of cardboard on top of the battery so the battery contact was improved, and the fob works fine now.

Aug 04, 2010 | 1996 Dodge Caravan

2 Answers

Remote key fob is not working


replace fob and or clean or replace receiver eliment located somewhere on car

Jun 10, 2009 | 2000 Hyundai Accent

1 Answer

Key fob wont work


the battery part just use a flat screwdriver, or if you are like my wife a butter knife, and pop off the back and go get a battery. You should not have to reprogram the remote. I just bought a 98 lincoln and the battery was dead in the remote also and all I did was replace the battery. hope this helps.

May 28, 2009 | Chrysler Voyager Cars & Trucks

2 Answers

Renault megane key fob wont work


I had the same problem with mine

your key fob is now out of sync with the ECU to sync them just follow this link (renault will charge up to £180 for new key and to sync it)

http://renaulthelp.110mb.com/ImmBypass.html

Jan 03, 2009 | Renault Megane Cars & Trucks

1 Answer

HELP HELP !!!!!!! Electric fault i think !!!!!!!!!!


1....ensure the battery in the "Key Fob" is OK............Press either Lock or Unlock button for more than 1 second, the lamp on the fob will light if OK. Change battery if it does not illuminate! 2.....if battery on fob OK.......Re Syncronise the key fob to the car by:.... a brief press on either button twice and within 30 seconds turn Key to position 2 on the ignition lock
Hope that fixes it...let me know?

Nov 09, 2008 | 1998 Mercedes-Benz C-Class

1 Answer

Want fuse go to the alarm on a 2004 chevy tahoe


The key fob comes apart with a small screwdrive and you can replace the battery in it. Most fobs are CR2032, but check it before you go buying a new battery. If this dosen't work you can take the fob to a dealership and they have a tool that can check to see if your fob is putting out a wireless signal. If it is not putting out a signal you will need a new fob. If it is putting out a signal there could be other problems in the wireless controller of your vehicle.

Aug 16, 2008 | 2004 Chevrolet Tahoe

Not finding what you are looking for?
1996 Audi A4 Logo

144 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

yadayada
yadayada

Level 3 Expert

76848 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14384 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...