Question about 2008 Cadillac Cts

Open Question

2008 cts rolls in park. transfer case problems

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

97 Dodge Ram Transfer case locked up would that also be reason truck wouldn't move and when in park it rolled


Transmission Failure of some sort

You never replace a transfer case,you repair yours

What your given with the tranfer is a junk yard unit

If your going to put more money into a 16 year old
& badly rusted dodge & they all rust terribly underneath,
then install Jasper Engine & Trans units

Time to part with it,too old,too rusty,& no reason to have
spent what you did

I bought a 1992 dakota new & only did the water pump in over
18 years,then donated to the veterans & took $500 tax credit

Feb 01, 2013 | Cars & Trucks

1 Answer

We understand that your problem is: I have a 2000


Whats happening is when you go into drive the transfer case spins but is not in gear and then when you go into park the gears are grinding, because the transfer case is spinning, its like trying to go into park while the wheels are spinning, the transfer case is in neutral you need to adjust it, and make sure the adjustment is right or you may be in 4wd low instaed of 2wd so after the adjustment check and postions of the 4wd.

Mar 17, 2011 | Dodge Dakota Cars & Trucks

1 Answer

03 cts i put it in park on a hill and let go of the brake then it started to click and slowly roll back


Your trying to ruin the transaxle.

Read your owners manual,no vehicle is designed to hold on a hill,with just the trans parking pawl

You never had it in park ,in the first place,what you heard was the parking pawl, trying to engage the teeth on the parking gear

Your suppost to put the trans in park,apply the parking brake,then let off the foot brake,on all vehicles.

Nov 10, 2010 | 2003 Cadillac CTS

2 Answers

Can a 1998 4x4 S-10 blazer be dinghy towed?


Yes it can, just place your Transfer Case in Neutral position.
Shifting into NEUTRAL
To shift the transfer case to NEUTRAL do the following:

Make sure the vehicle is parked so that it will not roll.
Set the parking brake.
Start the vehicle or turn the ignition to RUN.
Connect the vehicle to the towing vehicle.
Put the transmission in NEUTRAL (N).
Shift the transfer case to 2HI.
Simultaneously press and hold the 2HI and 4LO buttons for 10 seconds. The red NEUTRAL light will come on when the transfer case shift to NEUTRAL is complete.
Shift the transmission to REVERSE (R) for one second, then shift the transmission to DRIVE (D) for one second, or FIRST (1) for vehicles equipped with a manual transmission.
Turn the ignition to LOCK.
Place the transmission shift lever in PARK (P), or FIRST (1) for vehicles with a manual transmission.
Release the parking brake prior to towing.

Shifting Out of NEUTRAL
To shift out of NEUTRAL:

Set the parking brake and apply the regular brake pedal.
Shift the transmission to NEUTRAL (N) and turn the ignition to RUN with the engine off.
Press the button for the desired transfer case shift position (2HI, 4HI, AUTO 4WD or 4LO).
After the transfer case has shifted out of NEUTRAL the red light will go out.
Release the parking brake.
You may start the engine and shift the transmission to the desired position.
Excessively shifting the transfer case into or out of the different modes may cause the transfer case to enter the shift protection mode. This will protect the transfer case from possible damage and will only allow the transfer case to respond to one shift per 10 seconds. The transfer case may stay in this mode for up to three minutes.

NEUTRAL: Shift the vehicle's transfer case to NEUTRAL only when towing your vehicle.
Good luck and hope this answers your question.

Jan 30, 2010 | 1998 Chevrolet Blazer

1 Answer

2008 CTS - Key fob doesn't always open the doors


The battery may need replacing. I've experience the same problem and the battery was the problem. Good luck. Ned

Oct 09, 2009 | 2008 Cadillac Cts

1 Answer

Hi all i have a 1997 bravada that rolls/inches back while in park! i looked under the the truck to find that it is a 4x4 that is missing the drive shaft to the front transferred case and there is not any...


When you place your vehicle in park, a metal bar slides into one of many large slots on an internal drum in the transmission. If the slots or bar are worn, or if the differential or universal joints are worn, that play has to be taken up before the vehicle will not roll further.

Jul 22, 2009 | Oldsmobile Bravada Cars & Trucks

2 Answers

I put my 95 grand cherokee in park and it rolls


Hey there..my name is Keith..and in your transmission..there is a parking cog..and its not in your transfer case..and either its wore out..or you vehicle needs some shift linkage adjustment..or the linkage has gotten bent from 4 wheeling..and i hope this helps..if not..please write back

Jun 29, 2009 | 1995 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

89 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

76051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8266 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...