Question about 1996 Mitsubishi Mighty Max

1 Answer

Cranks up, idles fine, won't rev up when pushing gas and once it cuts off will not crank for a while. will not pull hills.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 385 Answers

Sounds like an extreme fuel restriction, possible fuel filter or unventilated tank, or even a clogged catalytic converter which would have that rotten egg smell

Posted on Sep 04, 2010

  • sheilaparson Sep 04, 2010

    tryed all of the above put on test machine it said coolant temp sensor that helped out now it cranks every time got some of the power back but not all still there could use somemore ideas thanks

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Engine revs but no acceleration


Clutch plate and pressure plate seem to be too weak to pull the car. Or one of the CV joints is detached from the gear box. To test the clutch plate, park the car on flat surface. Pull the hand brake up, start the car, depress the foot brake pedal, depress the clutch pedal, put the car in 1st gear, press the gas pedal and leave the clutch pedal at once, while keeping the brake pedal depressed.
Follow one of the two following statements:
1. Engine does not shut down and remain start. (Clutch plate, pressure plate and clutch bearing defective - Replace all as a set)
2. Engine shuts down. (Clutch system is OK and does not require any repair).

May 22, 2013 | Honda Civic Cars & Trucks

1 Answer

Have a 1996 camaro that is idling high and rough


Check your mass air flow sensor on your air intake it has a connector plugged in it or just take it in for a full tune up

Mar 07, 2013 | 1996 Chevrolet Camaro

1 Answer

Car runs fine in park and cuts off in drive


Don't know cars - but it might not be idling fast enough to make the gear change. Idle reset needed maybe?

Feb 14, 2013 | Cars & Trucks

1 Answer

Cranks but won't start sometimes. Also has cut out while idleing in traffic and again cranks but won't start. car has new battery.


From what i've seen over the years with the Chryslers i've encountered. Your describing to the "T" what appears to be a bad Crank Sensor. I will bet money that if you replace the crank sensor it will solve your problem. BUT...Also know that a bad fuel pump can do exactly what you describe in your statement. Once the pump get hot it gets to acting stupid, but yet again so can the Crank Sensor. Still, my money is on the Crank Sensor.

Jul 27, 2011 | 2000 Jeep Grand Cherokee

1 Answer

"cold" start issue - engine cranks and revs right


FICV
fast idle control valve
and a price problem
not hard to replace but a $200 part

Dec 08, 2010 | 1991 Honda Accord

1 Answer

My engiene cut out while driving and wont start it cranks but it wont start... i changed the ignition coil and the wires and the plugs nothing i sprayed starting fluid in the intake and nothing it cranks...


Did you check for good compression? You may have either jumped timing or have a broken timing belt. I would check engine compression first. If it's good then move on to checking your fuel and ignition systems.

Nov 03, 2009 | 2003 Dodge Neon

2 Answers

I have a 200 ford explorer, when starting, the engine cranks but stalls if i don't give it gas. Seems to only happen in the morning. Also, once it does start running, it usually starts up fine fore the...


sounds like you dont have enough cranking amps find out what the cranking amps are for your battery then call an auto part store and ask themwhat cranking amps you should have for where you live this time of year.

Sep 09, 2009 | 2000 Ford Explorer

1 Answer

96 Ford Taurus Runs for a minute then acts like its out of gas


it sounds like your throttle position sensor

Sep 03, 2009 | 1996 Ford Taurus

Not finding what you are looking for?
1996 Mitsubishi Mighty Max Logo

Related Topics:

151 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...