Question about 2004 Chevrolet Impala

1 Answer

My tranny is slipping into 1st and shuddering the engine light came on

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 116 Answers

You may need to flush the fluid, and change the filter, It may have had the incorrect fluid installed, or the torque converter solenoid may be bad.

Posted on Sep 03, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Transmission bogs down


what counts is ENGINE RPM.
see?
i put shifter in REV.
i do the stall test in the FSM, or at alldata.com
the stall test is brake hard sat and advance throttle with right foot for 5sec max, what is RPM????
if its very very low RPM that is a weak engine, but will not that, because car drives perfect in forward gears.
if the RPM shoots why to high (read the page) 2500 is like max,IIRC.
that means REVERSE slips.

ever try a new tranny filter. or better a full flush and new filter?
ever 50k?
amazing things happen , it last 2 times longer.

hell do the stall test in all gears, takes what 1min?
and see the book , on spec.
alldata.com
or the real FSM
get one, and win.
see it here, in 1st.
this video use the A/T tranny to test a good MAF.
http://www.fixkick.com/videos/FLV-all/showtime.html#MAF

this test is classic test on all trannys, in all FSM of ever car (non CV)
note the rpm in top right corner, and it ends at 2000 rpm
this proves 3 things
1: engine has full power
2: tranny dont slip in 1st.
3: the MAF is at full output and good, (ignore this for now)

then brakes are had set. and chocks on tires.
the engine and tranny be come like a dyno test.
the FSM cover this is vivid details on 1st and reverse.
and the solutions.

Jul 05, 2013 | Honda Accord Cars & Trucks

1 Answer

Just installed a rebuild transmiision on 98 Isuzu rodeo. A GM4L30E. Slips at the start


is it low on tranny fluid ? did you change the tranny filter and gasket yet ?

Jan 19, 2013 | Cars & Trucks

2 Answers

Transmission shuders at 40mph to 60mph


could be a tranny problem developing but cheap checks include checking uni joints or cv joints for looseness. Check rear bush of tranny for sloppy slip joint fitting ( rear drive only) lift tail shaft up and down. any movement allows an out of line tail shaft to occue hence the shudder.Check the color of the tranny oil Should be a bright cherry red. Any other color ( brownish red - tan) indicates possible tranny fault

Jan 11, 2013 | 1996 Buick LeSabre

1 Answer

I HAVE 99 ISUZU RODEO 2WD LOST 1ST & 2ND


if your close or over 100,000 miles, better to have the tranny rebuilt.

Nov 07, 2009 | 1999 Isuzu Rodeo

1 Answer

Goes into neutral and then shifts hard into 1st on slowdown


It sounds like your input clutch seals are rolling. Is the check engine light on. It could also be the pressure control solenoid could be causing the problem aswell

Sep 02, 2009 | 1998 Buick Century

1 Answer

Voyager transmission problem


Sounds like you need a solenoid pack to start, and possibly a service. If the tranny is not slipping, the solenoid pack is stuck and not tell it to shift up. Could possibly be a TCM, but not as likely.

May 30, 2009 | 1999 Plymouth Grand Voyager

1 Answer

Overdrive light is flashing and tranny is slipping in drive and 2nd


my overdrive light is flashing due to a shattered speedo cable tip. check your fluid level. you may have to change the tranny filer and redo all the fluid.

May 21, 2009 | 1992 Toyota 4Runner

1 Answer

Code P1744 on a 1997 Ford Taurus


sound like torque converter or tranny oil pump problems. have tranny pressure tested.

Apr 10, 2009 | 1997 Ford Taurus

1 Answer

1991 Isuzu 4X4 Pickup 3.1 V6 won't warm start plus shudder in low


Your flywheel sound like it has hot spots on it, making the clutch chatter. You might need to pull the flywheel off and get it re-surface. This is like turning your rotor, or brake drum. If you pull the flywheel, you will see discolor spots on your flywheel. This is called hot spots, and will make the clutch slip.

On the other problem, have you changed to fuel filter and fuel pump. It almost sound like your running out of fuel????

Jan 08, 2009 | 1991 Isuzu Pickup

Not finding what you are looking for?
2004 Chevrolet Impala Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...