Question about 2001 Dodge Durango

1 Answer

I have a 2001 Dodge Durango. While replacing the front brake pads and rotors we noticed on of the studs was cracked almost in half. So we were able to get the old stud out but with the new stud ((yes I checked and it is the correct length) we cannot get it in. There doesn't seem to be a set to where you can put it into the hub. Am I missing it somewhere or is there a trick that I don't know about? Thanks so much.

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 385 Answers

Tap or press it in as best you can. only when you tighten with lug wrnch with tire on will it pull it all the way thru

Posted on Sep 03, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have 98 durango one caliper bolt on front passenger side came out I put new one in and now the brake seems to be locking up

William, did you use the correct bolt(length), did you check all brackets, sliders, seized caliper, pads for damage, free movement, etc.
Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."

How To Install Replace Brake Pads and Rotors Dodge Durango Dakota 97 03...

How To Replace the Front Brakes on 98 03 Durango

How To Replace Front Pads And Rotors Dodge Dakota

Mar 21, 2016 | Cars & Trucks

1 Answer

1998 dodge durango front brakes grab

Usually this is caused by grease or oil getting on rotor or pads. Remove wheels and check rotor, pads and lines for signs of a brake fluid leak or any sign of grease or oil that could have gotten on the rotor or pads.

Aug 13, 2014 | 1998 Dodge Durango

1 Answer

I replaced both wheel bearing hub assembles on the front of my 2001 dodge durango slt 2wd but it is still making a rowing noise from the wheels.

Have you checked the condition of your brake pads? If lining is worn off and you're getting metal to metal contact between the pads and rotor, it will make a similar "roaring" sound.

Dec 26, 2010 | 2001 Dodge Durango

1 Answer

On a 2003 dodge durango, how do the front brake pads come off the bracket? Do you remove the clip to open up a key way?

Stick a flathead screwdriver in between the rotor and pad. Pry against the pad and rotor from the upper side and they'll slide right out.

Sep 26, 2010 | 2003 Dodge Durango

1 Answer

My 2003 dodge durango is making a grinding noise in the front left side what is it?

it could be the brake pads worn to the rotor or it could be the wheel bearing. just take the wheel off and inspect the brake pads and rotor for wear

Mar 23, 2010 | 2003 Dodge Durango

3 Answers

Repeated warping of front brake rotors. Have replace rotors 3 times with both Chrysler OEM and aftermarket. Replace calipers, ceramic pads, etc. Still warps rotors in less than 5000 miles.

do you do a lot of hills work?if so use the gears ,ifdown hill not the brakes if it is auto then slip it down i gear . make sure your rear brakes are adjusted regularly,but for the main part i would think it is the driver that is the problem,you may get an occasional faulty rotor but not three sets, over heating is the cause of your problem.dont missunderstand me chrysler brakes arent anything special but they arenot that bad , slow down

Sep 29, 2009 | 1997 Dodge Ram 1500 Club Cab

2 Answers

Describe your 2002 dodge durango brake problems Problem they feel loose with no pressure I can almost touch the floor.

sounds like your Master clyinder is going out, Have this checked ,with who ever does your brakes.

Jul 20, 2009 | 2002 Dodge Durango

3 Answers

Brake problem on 2001 Dodge Durango 4WD 5.9L

Put new calipers on both sides, my wife has a 2001 durango, 2 years ago i had to put new ones on because of the same problem you are having and it fixed it, acording to everyone i talked to, has had the same problem with calipers on chys. products especialy Dakodas and Durangos with my wifes the right front wheel locked up but when it cooled down it would work again.

Mar 21, 2009 | 2001 Dodge Durango

2 Answers

2005 Dodge Durango Front Brake Squeal

Did you buy factory pads or get cheap aftermarket pads? If aftermarket did you get the ceramic? The cheap aftermarket ones tend to squeal pretty bad. Like the last comment on here, you should have your rotors turned whenever you change the pads.

Jan 13, 2009 | 2005 Dodge Durango

Not finding what you are looking for?
2001 Dodge Durango Logo

50 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8266 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides