Question about 2003 Ford F250 Super Duty Crew Cab

1 Answer

Need to remove the turbocharger from truck to replace oil cooler. Am unable to get it out. It is a 2003 ford 250 superduty tubo diesel 6.0 litre

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 13 Answers

1 - Remove the turbocharger intake tube
2 - Disconnect the charge air cooler inlet pipe
3 - Remove the push pins on turbo cowl
4 - Disconnect the turbo VGT solenoid
5 - Remove the oil supply tube
6 - Using the special tool, remove the oil feed tube
7 - Remove clamp from the turbo down pipe
8 - Remove the clamp from the turbo inlet
9 - Loosen the exhaust inlet pipe-to-EGR cooler clamp
10 - Loosen the RH & LH exhaust inlet pipe-to-exhaust manifold nuts
11 - Remove the rear turbocharger mounting bolt
12 - Remove the front mounting bolts
13 - Position the turbocharger and remove the turbocharger drain tube
14 - Remove the turbocharger

If you cant do it with these instructions put down your wrench and take to a dealership for a professional to work on it

Posted on Sep 03, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2006 f350 6.0 powerstroke diesel missing. help

there is no wastegate on a 6.0l turbo. its a variable geometry turbocharger and doesn't need it. i have never seen a turbocharger cause a misfire, the turbocharger is most likely not your problem. if you didn't clean the intake out when replacing the egr valve there is a really good chance that the egr is bad again. also, a bad egr cooler can cause repeat egr failure. also, fuel injector control module is a common cause for misfire

Feb 18, 2012 | 2003 Ford F350 Super Duty DRW SuperCab

1 Answer

2003 ford f 250 6 l. diesel when the hearter is turned on it is only blowing cool air not hot , the termature is running halk way we put new termustate in it the heater cole is got really good flow ,...

6l is a tricky engine... there is a bypass in the heatercore so you will always have good flow no matter what...first thing i would do is go to napa and buy a block tester and test the cooling system for exhaust gasses. if exhaust gasses are found replace the head gaskets, the oil cooler, you can try to backflush the heatercore but replacement is recomended.ONLY use motocraft GOLD coolant. anything else will clog the oil cooler and you will have to do it all again. other than that only thing it could really be is a busted blend door motor or blend door(inside dash)

Mar 30, 2011 | Ford F-250 Super Duty Cars & Trucks

1 Answer

Where do you find the oil pressure sensor for 2006 F-250 superduty Diesel

The oil pressure sending unit on a 6.0L is found on the top of the engine just a little in front of the oil filter. Here is a picture but it might be hard to see. On the right hand side of the picture it says Oil Pressure Switch, try to follow that arrow. Sorry the picture is so blurry


Feb 13, 2011 | 2006 Ford F-250 Super Duty

1 Answer

Engine problem with 2006 Ford 250 Superduty Diesel

Sounds as if you have a glow plug relay problem,this needs to be diagnosed and repaired as necessary

Jul 23, 2010 | 2006 Ford F-250 Super Duty

1 Answer

2005 Ford F250 6.0L Diesel - ( 63,000.mi) Excessive water vapor in exhaust - is there any other possibility than a leaking head gasket - loosing coolant.

is the coolant level for sure dropping quickly?.i have heard of the oil coolers going bad on the 6.0 litre,but not a head gasket yet.Even at 63,000 miles.if you are for sure its eating coolant,try tightening some intake bolts,or crossover tube bolts.if it stops burning it which will take time,easier watching the coolant level than to wait for the exhaust to clear up,then consider replacing the intake gasket soon.

Feb 21, 2010 | 2005 Ford F 250 Super Duty

5 Answers

2005 Ford F350 SuperDuty 6.0 litre Diesel. Truck was very sluggish to accelerate and little or no boost showing on turbo pressure gauge. Next morning, it started fine, but when put in gear would quit and...

well the question is where did the coolant go. if it didnt leak out it must have went out the pipe. As you stated, white smoke, white smoke is coolant. You definately need to get this to the shop. You cannot drive it this way or further damage will occur.

Nov 21, 2009 | 2005 Ford F 350 Super Duty

1 Answer

My 2003 f-250 turbo not engaging

If you are getting zero boost, then your wastegate actuator may be jammed, causing the wastegate to be stuck open. That'll bleed all the boost off around the turbine, straight to the exhaust, and you'll never build any boost pressure.

Nov 11, 2009 | 2003 Ford F Super Duty Chassis Cab

1 Answer

2003 ford f350 6.0 diesel

The 6.0l diesel is noted for having oil and fuel enter the coolant system. If it is oil then the oil cooler has failed. The oil cooler is located the the center of the engine under the intake.On an F-series truck the oil cooler is below the oil filter housing. It can be identified by two things. The low oil pressure sensor and a small blue or orange hose is connected to the cooler. If it is fuel in the coolant then you have a cracked head or cracked injector sleeve.

Oct 21, 2008 | 2003 Ford F350 Super Duty DRW SuperCab

Not finding what you are looking for?
2003 Ford F250 Super Duty Crew Cab Logo

321 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers


Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides