Question about Oldsmobile Cutlass Supreme

1 Answer

How to remove steering wheel from a 1982 cutlass

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Oldsmobile Master
  • 4,350 Answers

It takes a steering wheel puller to remove the wheel.

Posted on Sep 03, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How do I pull steering wheel off 95 Oldsmobile cutlass supreme

safety fix the air bag
remove the center pads to the wheel
undo the nut and use a steering wheel puller

Feb 01, 2017 | 1995 Oldsmobile Cutlass Supreme

1 Answer

I need to replace a power steering pump on a 1992 Olds Cutlass Ciera. How does one tackle that problem?

First you will need a pulley remover/installer. Remove the power steering belt, remove bolts holding the pump, remove p/s lines, replace in reverse order,and fill pump. Start car and move steering wheel back and forth slightly, then turn the wheel all the way stop to stop Always watch that there is plenty of fluid in the reservoir. Check with dip stick, should be full to bottom mark;

Jul 19, 2011 | 1992 Oldsmobile Cutlass Ciera

1 Answer


Yes,the steering wheel puller will be needed,and a lock plate remover/installer will be needed to do this.

Jun 07, 2010 | 1988 Oldsmobile Cutlass Supreme

1 Answer

Horn wiring diagram 65 el camino

a 1965 camino,centre steering wheel horn push? remove the steering wheel and check the carbon brush that runs against the copper metal ring on the bottom of the steering wheel

Dec 24, 2009 | 1982 Chevrolet El Camino

1 Answer

I need to know how to change my ignition lock cylinder on a 1982 cutlass supreme

ok first thing first take steering wheel off its kinda hard to do anyway take steering wheel off u might loosen the nut on the steering half way off and put your knees on back of steering wheel then hit nut with hammer as u pull up with your knees or buy a wheel puller cost around 20.00 but id rather just use hamer and my knees after u get wheel off they will be a lock wheel its black in the center is a meatal o ring clip u have to push down realy hard on that round lock and take o ring out after u get it out pull the black ring lock off then the plastic horn thing out then u will see the turn sng switch they are three screws in it taake them out dont take wires loose leave them just pull it out let it hang down thenu will look down see on back of lock mist have a screw there lossen it then take switch out slide the new one in then fun part putting all back together

Oct 03, 2009 | 1983 Oldsmobile Cutlass Supreme

1 Answer

97 ols cutlass sup

there should be a couple of 8 or 10 millimeter bolts on the back side of the steering wheel.

Sep 17, 2009 | 1997 Oldsmobile Cutlass Supreme

1 Answer

1994 cutlass ciera ignition switch. how do i get to it to get it out?

Drop the steering wheel down and you can access the switch. Just remove the dash cover to access the bolts holding the steering wheel in place. Once you remove those 2 bolts the steering wheel will fall toward the seat.

Sep 11, 2009 | 1994 Oldsmobile Cutlass Ciera

1 Answer

My problem is that my steering wheel is loose in my 1993 cutlass supreme.

It has a nut on center, to get there, You have to remove horn depressing mechanism, it is attached to wheel, with screws holes 2 or more behind steering opposite side to You on the dash side of the steering wheel, the par You can't see, remove both Philips screws with spring mechanism, the inside of the steering is made of sheet metal, on the center of the steering You will see a big nut with a washer, make sure steering is locked *** the nut with clock, if free place remains after, or You note that steering wheel is secured and nut wont turn, look below, follow column down, than You will see a flex cross on steering axle, if cross OK, steering wheel OK and problem remains, Look at steering box free play if, problem? Take to a shop

Jan 24, 2009 | 1993 Oldsmobile Cutlass Supreme

2 Answers

1989 cutlass oldsmobile with tilt steering wheel ?

remove column trim, insert ket turn to on position, and push the pin in at the underside of the steering column pull straight out please rate -jeff

Jul 29, 2008 | 1989 Oldsmobile Cutlass Supreme

Not finding what you are looking for?

Open Questions:

Cars & Trucks Logo

Related Topics:

78 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts


Level 3 Expert

80339 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides