Question about Toyota RAV4

Open Question

Which lambda sensor is sensor1 bank1 on the 2.0vvti engine, and is left/right from the driver's perspective or from the outside the car?

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 31 Answers

SOURCE: check engine light

B1S1 O2 sensor is threaded into your exhaust manifold, closest to the actual engine in the exhaust stream.

Posted on Dec 13, 2008

  • 78267 Answers

SOURCE: How to locate the oxygen sensor in a LEXUS LS430 (Bank1 Sensor1)

the O2 sensor for bank one sensor one is located between the catalytic converter and the engine in the exhaust head pipe. see photo of your engine cylinder layout, the sensor u want to replace is the one at the cylinder #1 0aa2e73.gif bank on right.

Posted on Apr 15, 2009

SOURCE: Can't find the bank 1 sensor 1 Oxygen Sensor

bank one in a C280 99 sport its located on passanger side where 1st cylinder its located, When you step front of you car, take out the plastic cover and see right on top of the front spark plugs, you will see numer 1 on you left side (diver side) 1st top of 1st spark plug you'll see number 4 on you right side same first spark plug from your right.

In you want to replace bank 1 1-2 or 1bank-2nd sensor. you'll need to remove exhaust pipes about 6 bolts total in you garage your car well lifted and a 12pack of beer one friend of you may take about 3 hrs be patiente.. beers are for after job done!!

Good luck..
Durango, mexico

Posted on Aug 16, 2009

  • 3640 Answers

SOURCE: picture of bank1 sensor1 o2 sensor location on

I do not have a diagram but, bank 1 is the bank where #1 cylinder is at. other side would be bank #2. so bank #1 o2 sensor is just before convertor.

Posted on Aug 29, 2010

  • 194 Answers

SOURCE: My 96 Chevy Blazer 4X4 failed echeck, due to

It is a good idea if replacing one 02 Sensor to replace all of them at the same time. Location is- they screw into the exhaust pipes below the exhaust manifolds and before the muffler.( Very hard to miss them ). Make sure you have the codes cleared from the on board computers memory after repairs are finished. Good Luck and have a good XMASS,

Posted on Dec 19, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

I got a jeep 2.5 crd that doesnt want to start

Should be bolted to the right front side of the engine head.

The right side is as you are sitting in the drivers seat. Anytime car parts are labeled left or right it is as viewed from the driver's seat.

It you are facing the front of the engine it will be on your left.

Apr 30, 2014 | 2002 Jeep Liberty

1 Answer

Caravan door lock

the word "hand" means , on all cars (SAE rules)
the driver seated in his seat to drive, and HIS/HER perspective.

these word, from the mouth of instructor, day 1.
yes, is a show stopper.... sorry it did that to you.....

Sep 15, 2013 | Cars & Trucks

2 Answers

2007 Suzuki XL7 O2 sensor Bank1 - sensor1. Where is it located?

in the exhaust pipe after the cat converter of the bank closest to the firewall

Jan 02, 2012 | 2007 Suzuki XL-7

1 Answer

E-Check Light P0125 and pending p1153/p1155. Replaced ECT and codes reappear. Where is this Bank2 Sensor1 located on my 1998 toyota camry v-6 auto with air. P1155Code book described as AF sensor.

Air/Fuel Sensors are mounted upstream of the catalytic converter. They are located on the exhaust manifold side of the catalytic converter (pre-converter - Sensors 1). Oxygen Sensors are mounted downstream of the catalytic converter (post-converter - Sensors 2). The catalytic converter has two chambers (left and right). Bank1 is left, drivers side. Bank2 is right, passengers side. The Bank2 Sensor1 sensor (Air/Fuel Sensor) is the one located on the 'right and ahead' of the converter. The PowerTrain Control Module (PCM) is reporting that the heater or circuit ( wiring / plug-in) of the sensor is malfunctioning.

Jan 31, 2011 | Toyota Camry Cars & Trucks

1 Answer

I need a bank1 sensor1 P0135 Lambda sensor, they are telling me it will cost over £200 to source! Please help!!

try a universal oxygen sensor from bosch. autozone sells them,& they cost about half as much!

Dec 31, 2010 | Daihatsu Charade Cars & Trucks

1 Answer

2001 gmc sierra 3/4 ton bank 1 sensor1 location

ok bank 1 sensor 1 is on the left side of the engine driver side. and the sensor in bolted to the exaust manifold.good luck.Danny B

Aug 30, 2010 | GMC Sierra 1500 Cars & Trucks

2 Answers

Were are the 02 senors located on a 2001 saturn L100

This is a 4 cylinder right? Open the hood and look down between the engine and firewall, this is behind the engine. You will see the exhaust pipe, follow the exhaust pipe up to where it is bolted to the exhaust manifold. You will see the upstream O2 sensor screwed in there, more or less horizontally with wire connector pointed at driver side of car. Now get under the car and find the catalytic converter in the exhaust pipe, a big bulbous thing, the downstream O2 sensor will be after the converter, but before the muffler and will also have an electrical connection.

Aug 03, 2010 | 2001 Saturn L-Series

1 Answer

Where is the front oxygen sensor located on a 2003 chevy avalanche 1500 5.3l

There are 4 oxy. sensors listed for your truck. they're located as follows
Left exaust before catalytic converter. bank1 sensor1-after cat conv.
bank1 sensor2. right exaust before cat.conv. bank2 sensor1-after cat.
conv. bank2 sensor2. Hope this helps.

Mar 31, 2010 | 2003 Chevrolet Avalanche

2 Answers

Can you tell me what a lambda sencer does and how does it affect the engine,as my engine light comes on but dosent stay on but when on reduces power.thank you it is a vauxhall astra club 2000 16v did not...

Not sure, but I believe the lambda sensor is the feedback sensor, to determine if the mixture really is right.
On most cars that is the oxygen sensor I believe, and is located in the exhaust manifold or the top of the exhaust pipe.

Mar 30, 2010 | 1985 Volkswagen agon

3 Answers

How to locate the oxygen sensor in a LEXUS LS430 (Bank1 Sensor1)

the O2 sensor for bank one sensor one is located between the catalytic converter and the engine in the exhaust head pipe. see photo of your engine cylinder layout, the sensor u want to replace is the one at the cylinder #1 0aa2e73.gif bank on right.

Apr 15, 2009 | 2001 Lexus LS 430

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

78257 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides