Question about 2002 Buick LeSabre

1 Answer

A/C & heater blower will not work. Was running fine. Stopped at a store and it would not come on. I can feel cool air but no blower. I cannot figure if it is a fuse or the fan. I can't even find the fan. Thank You.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Buick Master
  • 7,780 Answers

Blower is over the passenger's feet. Pull down insulating panel, and you should see it. Pull off connector and check for voltage in cable with ignition on and fan set to high--should be 12-13 volts. If you have voltage, replace motor. If not, troubleshoot fuses/relays, switch, and resistors.

Posted on Sep 03, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Heater temp on high only bows luke warm air after driving. A/C works just fine.Plenty of cold air from it


heater blows cold air idle chrysler 300 Questions & Answers ...

www.fixya.com > Forum > Tags
Find solutions to your heater blows cold air idle chrysler 300 question. ... blow warmair for a few mins then back to luke warm. i replaced thermostat ... HEAT BLOWSCOLD AIR WHEN IDLING ONLY GETS HOT WHEN START DRIVING ... About 15 minutes after driving the diver side vents start blowing straight cold air but the ...

Heater only works when pressing the gas? - DoItYourself.com ...

www.doityourself.com/...repairs.../459521-heater-only-works-when-pres...
Nov 3, 2011 - When I press the gas, the air from the vents is nice and hot. .... So am Idriving a car with a ton of problems, or could the power steering ... Just anotherquestion, when warmed up does the engine temperature ... When the heater is on and I'm not pressing the gas pedal, luke warm air blows from the vents.

Heater blows cool air when stopped and warm air while ...

https://www.reddit.com/.../heater_blows_cool_air_when_stopped_...

RedditFeb 12, 2014 - Heater blows cool air when stopped and warm air while driving 2008 Kia Spectra (self. ... just fine but appears to blow cool air when I was stopped at a stoplight. ... My temp gauge would also be pegged high when at idle / low RPM. ...thermostat only blocks coolant going to the radiator, and the heater core, ...Missing: 300m ‎luke

Why is My Car AC Blowing Hot Air? - BlueDevil Products

gobdp.com/blog/car-ac-blowing-hot-air/

Jan 27, 2016 | 2000 Chrysler 300M

1 Answer

2008 Jeep Liberty-My heater was barely warm-blowing fine tho. Was told I had a plugged heater core and needed a new one. Had a new heater core put in and then my air conditioner stopped blowing cold air....


I woild be checking the vent controls as if the ac is working and the core was blocked then the air would be cool when the heat was selected but not changing Fixing the heater has resulted in a /c not being good enough to cool the air if the vent is not properly selecting. The point is that if the vent selection is not working properly (vacuum hoses) then the 2 faults will be related.

Oct 24, 2013 | Jeep Liberty Cars & Trucks

3 Answers

I have a 95 Ford Contour 6 cyl DOHC, we had ice accumulation last night and stated car ealy this morning and defroster worked fine, ran about 15-20 minutes and it was too early to leave so we shut car off....


the fan may have went out. what your feeling is air coming in as you drive. ford trick for fresh air lol. the fan needs to be tested to see if it has stopped working

Jan 20, 2011 | 1995 Ford Contour

1 Answer

Heater just stopped working in 1996 explorer what can i look at or what could it be?


im not sure if you mean the blower is'nt working or if you mean the blower is working but the air is cold so I'll try to answer both, if the blower is'nt working it is possibly a bad fuse, the fuse panel may list it as the heater or it may say blower, now if its blowing but the air is cold it is most likely a bad thermostat, sometimes the heater core goes out but if you havnt noticed the window fogging on the front windshield on the passenger side or smelled coolant in the cab of the vehicle the heater core is probably fine , the thermostat is a common culprit and they are fairly easy to change, one other thing before you go changing anything, check to make sure the radiator is full, with the car cool take the radiator cap off and run the car until it starts to get warm and see if you can add some coolant

Jan 12, 2011 | 1996 Ford Explorer

1 Answer

Heater stopped putting out heat, blower works fine air conditioning works fine


What you are saying is when you turn knob to hot you don't get any heat.? Let's start with the basics. Make sure your cooling system is filled up with coolant. Then with the engine warmedup and the temp gauge on the dash indicating between H and C. Find your heater hoses under the hood and feel them. Are they BOTH very warm or hot? os is only 1 warm and the other cool? If both are warm/hot, and still not getting heat from your vents. You have a problem with either the temp controller or the blends doors under the dash. usually the blend doors and it requires removal of the dashboard to get to it. If the heater hoses are wrm and cold then you may have a plugged heater core or water pump not circulating properly.

Jan 14, 2010 | 2000 Jeep Grand Cherokee

2 Answers

There's no heat coming out of the vent, just cold air. What is the possible solution to this problem


possible low anti freeze, air bound heater core, defective heat blend door control servo. Start with coolant level, if o.k. check hoses feeding heater core. If the lines are both hot suspect blend door servo/control unit. If only one hose hot suspect clogged/air bound core. Special bleed procedure for engine. With engine running, check for bleeder scews at upper hose mounting, open bleeder and watch for steady stream of coolant. Be careful as coolant is hot. If this does not help, disconnect hoses frm heater core when cool and blow out core with compressed air to unclog system. I hope this helps.

Dec 25, 2009 | 2002 Acura 3.2TL

1 Answer

No heat from cabin heater on my 2004 Focus


sounds as if you have an air lock on your heater try bleeding it or check your heater cable it may be jamed or needs ajustment

Nov 11, 2009 | Ford Focus Cars & Trucks

1 Answer

Heat will not work air work fine cannot get heat to come on blow cold air


Check to see if your heater core is stopped up. To do this, start the car and warm up the engine. Turn the heater on and turn the temp up. Raise the hood and locate the two heater hoses on the passenger's side going through the firewall below the windshield. Feel both hoses with your hands. If one is hot and one is cool, then the heater core is stopped up. Turn the engine off and let it completely cool. Disconnect the two heater hoses and blow through one and then the other with an air hose till it is clear. Reconnect heater hoses. If this is not the problem, then listen for a clickin noise behind the dash while the car is running and the heater of air is on.

Oct 04, 2009 | 1997 Lincoln Town Car

1 Answer

Air conditioner blower stopped blowing


It could be a fuse, or the blower motor resistor.

Jun 27, 2009 | 1995 Pontiac Grand Am

2 Answers

Blower for AC/Heater stopped working


if you can reach the blower motor, it could be a worn out carbon brush of the blower motor. if they are, buy a set of carbon brush, learn how to replace them and it would be back running in no time. by the way, when you pull out the carbon brush holder, make sure you dont interchange the position. you can put them back wards and what would happen is the rotation will be reversed. either you reversed the carbon brush holder or just simply interchange the wires that are coming to the motor. i hope i was able to help...

Jul 07, 2008 | 2000 Ford Focus

Not finding what you are looking for?
2002 Buick LeSabre Logo

362 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...