Question about 1996 Jeep Grand Cherokee

1 Answer

When i drive it makes a clicking sound from thefront axle

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 474 Answers

Chseck c/v joint

Posted on Sep 03, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Can a tye rod end make clicking sound when u turn if there bad


No, but a CV Joint can. The (constant velocity) joint is on the end of each drive axle where it enters the wheel. It allows for the turning and up and down movement of the wheels, while still transmitting power from the transmission. When they go bad from wear, lack of grease, etc., they will make a clicking sound during turning. You are hearing the "outer CV joint" on one of your front wheels.

A replacement is not that expensive as a part. You can buy a new drive axle with remanufactured CV Joints on both ends of it for less than $100. Installing one is a bit of a chore, so if you pay someone to do it, it will take about 3 hours labor. Plus it is recommended to have a front end alignment done after any front end work. The wheel and hub has to be partially dismantled to remove the drive axle.

Sep 15, 2015 | Cars & Trucks

1 Answer

Clicking noise when in 4WD


Front drive shaft CV going bad or CV axle going bag

Jan 30, 2014 | Dodge Durango Cars & Trucks

1 Answer

2000 chevy blazer


The vibration or jet engine sound as you described it sounds like to me could be wheel bearing they tend to make a growling sound the faster you go. The clicking sound while turning could be cv axle if your vehicle is equipped with them if not could it be 4x4 it would still be a wheel axle. You need to have it checked and pin point which wheel is causing the sound.

Jan 16, 2013 | Chevrolet Blazer Cars & Trucks

1 Answer

My 1995 Geo Prizm. I hear noise at the left side of the transmission where the drive axle enter the transmission not the usual clicking sound when the drive axle goes bad. The noise show up when I...


I would still suspect the drive axle because it could very well be the inner joint of the axle clicking and not making the accustomed noises related to a drive shaft noise.Thanks Megabuck

Aug 29, 2011 | 1995 Geo Prizm

2 Answers

Clicking and popping sound coming from the right front tire when I turn a corner.


This sounds to me like you have a drive axle (CV-Joint) going bad on the passenger side. Hope this helps, TJ

Aug 05, 2011 | 1995 Buick Skylark

2 Answers

Makes a hard clicking sound in the passenger side tire area when i turn either way. ony when im sitting still and start to turn tho.


this sounds like a bad cv axle, this is what turns the wheels to make the car move if its clicking its going to break soon and leave you stuck out on the road, the axle needs replacing.

Sep 07, 2010 | 2000 Kia Sephia

2 Answers

Bad axle


A bad axle will make a continuous clicking or clunking sound when making a sharp turn (left or right), but if they are really worn out it would not have to be a sharp turn for them to make that noise.

May 11, 2010 | 1996 Dodge Stratus

1 Answer

2000 Dodge Caravan tranmission started making a clicking sound only in 1st gear. Otherwise drives fine. What could be wrong?


you need to have the CV axle shafts checked,the clicking sound is the first sign of a bad one,you need to turn the steering wheel one way sharp wile accelerating,then the other way,so you can determine if left axle or right.

Jan 15, 2010 | 2001 Dodge Grand Caravan

1 Answer

1993 subaru legacy front cv axles


First thing to have checked would be the front CV axles. If the rubber boots rip and allow the grease out it can damage the joints and they will make a clicking sound. Worn out axle joints can also bind and make it feel jerky. If they are making that loud of a noise it could become a safety issue, have them checked out soon.

Jan 24, 2009 | 1993 Subaru Legacy

Not finding what you are looking for?
1996 Jeep Grand Cherokee Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7711 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...