Question about 2003 Ford Explorer Sport Trac

Open Question

The fuel cap light is on again on 2003 Ford Explorer Sport Trac. the other 3 times it was for a sensor. how many sensors are there?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 20 Answers

SOURCE: sport trac

there should be a diagram in your handbook

Posted on Nov 21, 2008

Ad
  • 160 Answers

SOURCE: 2003 ford sport trac --- abs sensor light on

its is the abs comp

Posted on Jan 03, 2009

billandrade
  • 6 Answers

SOURCE: P2195 CODE ON 2003 FORD EXPLORER SPORT TRAC 4.O

Hello,
Very common concern with the Explorer, Explorer Sport Trac and Ranger with the 4.0l SOHC engine! The upper and lower intake manifold gaskets fail, causing vacuum leaks..It can be Extremely difficult to detect these leaks, because they only leak intermittently (usually in the AM after a cold soak)... As the engine warms up they seal back up! Sometimes the vehicle will idle rough, surge or stall after initial start up, then the symptoms will clear after it gets to operating temperature... Usually there will be no driveability symptoms at all, except the engine light coming on and setting lean codes.. The gaskets have been redesigned to correct this concern..


Bill Andrade Ford Master Technician/ASE Master Technician

Posted on Sep 22, 2009

  • 104 Answers

SOURCE: I have a 2005 Ford

I think 1 is the sensor and on is the sender I beleive. Cant remember the order they are in. They should both be keyed different. If you unplug the pigtail from both, you can match the end up to the new one. Not a bad idea to do both though. They are cheap.

Posted on Jan 27, 2011

  • 492 Answers

SOURCE: light out behind fuel indicator

All the bulb types are listed in the owner's manual. Access is somewhat difficult but not too hard.

Posted on Mar 11, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2007 sport trac. What will fix codes po320 &


po320
Faulty Ignition/Distributor engine speed sensor, Faulty Crankshaft Position sensor
Ignition/Distributor engine speed sensor harness is open or shorted, Ignition/Distributor engine speed sensor circuit poor electrical connection, Low battery charge, Faulty Engine Control Module (ECM)
po446
try tightening the fuel cap if not replace it

Oct 19, 2014 | 2007 Ford Explorer Sport Trac

1 Answer

How to replace the fuel pressure sensor on a 2005 ford explorer sport trac?


Google a picture

If you do not know where to look for a fuel sensor

I would assume you don't know how to test it & don't
have the skills to be doing that type of work

No parts get replaced until they fail a test

Jul 23, 2014 | 2005 Ford Explorer Sport Trac

1 Answer

Check engine light is on and fuel cap liight


take cap off and put it back on.. fuel cap sensor may have malfunctioned also..

Jan 27, 2013 | 2001 Ford Explorer Sport Trac

1 Answer

Diagnostic code p0193


P0193 FORD - Fuel Rail Pressure Sensor Circuit High Input
Symptoms - Engine Light ON (or Service Engine Soon Warning Light)
- Engine will not start Possible causes - Excessive resistance in the circuit
- Low or no fuel
- Wiring harness connector of the fuel pressure sensor
- Fuel Rail Pressure Sensor
- Fuel Pump

Mar 17, 2012 | 2004 Ford Explorer Sport Trac

1 Answer

How to clean the MAF for a ford explorer sport trac 2003


there is no cleaning of this with solvents of any kind it will contaminate the sensor. you can blow it out with air but if it is acting up and setting a code replace it. hope this helps

Jan 31, 2011 | 2003 Ford Explorer Sport Trac

1 Answer

P2195 CODE ON 2003 FORD EXPLORER SPORT TRAC 4.O SOHC. I CHANGED OUT ALL THREE OXYGEN SENSORS, AS ADVISED, AND STILL COMING UP WITH P0171, P0174, AND NOW P2195. HAVE ALSO CHECKED ELECTRICAL CONNECTIONS,...


Hello,
Very common concern with the Explorer, Explorer Sport Trac and Ranger with the 4.0l SOHC engine! The upper and lower intake manifold gaskets fail, causing vacuum leaks..It can be Extremely difficult to detect these leaks, because they only leak intermittently (usually in the AM after a cold soak)... As the engine warms up they seal back up! Sometimes the vehicle will idle rough, surge or stall after initial start up, then the symptoms will clear after it gets to operating temperature... Usually there will be no driveability symptoms at all, except the engine light coming on and setting lean codes.. The gaskets have been redesigned to correct this concern..


Bill Andrade Ford Master Technician/ASE Master Technician

Sep 22, 2009 | 2003 Ford Explorer Sport Trac

1 Answer

Air intake sensor


the air intake sensor is a 2 wire sensor usually located in or close to the air cleaner

Jul 10, 2009 | 2003 Ford Explorer Sport Trac

Not finding what you are looking for?
2003 Ford Explorer Sport Trac Logo

Related Topics:

107 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5530 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...