Question about Chrysler Sebring

Open Question

How to remove and install a convertible top with a glass window on a 1999 chrysler sebring jxi

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 10 Answers

SOURCE: 1997 Chrysler Sebring jxi

Are you trying to replace one of the turn/hazard signal bulbs? If so, which one. The backside of the bulb will turn about a quarter turn and come out the back side of the housing then you can change the bulb out as usual.

Posted on Sep 05, 2008

  • 1 Answer

SOURCE: Replacing headlight in 1996 Chrysler Sebring JXI

piece of cake....
take off the two "star" bolts, one toward the center of the engine above the light assembly and the other toward the fender (it is very long). when you remove them both the entier assembly falls off into your hands and makes changing the bulbs much easier.

Posted on Sep 16, 2008

c17hydro
  • 2984 Answers

SOURCE: I need to replace an ignition switch on my 1999

This is for the ignition switch like you are asking for:

Ignition Switch REMOVAL & INSTALLATION Cirrus, Stratus, Sebring Convertible and Breeze CAUTION
The Supplemental Inflatable Restraint (SIR) system must be disarmed before working around the steering column. Failure to do so may cause accidental deployment of the air bags, resulting in unnecessary SIR system repairs and/or personal injury.

  1. Disarm the air bag system, as described in Section 6.
  2. Remove the left end instrument panel cover/fuse panel and remove the retaining screw holding the end of the instrument panel top cover.
  3. Remove the instrument panel center bezel.
  4. Remove the screws that secure the instrument panel top cover to the center of the instrument panel.
  5. Lift the instrument panel top cover enough to gain access to the knee bolster attaching screws.
  6. Remove the lower knee bolster attaching screws and knee bolster from the vehicle.
  7. Remove the lower steering column cover attaching screws. Pull down on the lower cover to clear the ignition key cylinder and key release (if equipped).
  8. Remove the lower steering column cover, sliding the cover forward while holding down the steering wheel tilt lever.
  9. Tilt the steering wheel down to the fully lowered position and remove the upper steering column cover.
  10. Remove the screws that hold the combination switch to the ignition lock housing.
  11. Place the ignition lock cylinder in the RUN position.
  12. Insert a small prying tool into the hole in the lower cover and depress the cylinder release tab.
  13. Remove the ignition lock cylinder from the steering column.
  14. Unfasten the electrical connectors from the switch.
  15. Using a No. 10 Torx® bit, remove the ignition switch mounting screw.
  16. Depress the retaining tabs and remove the switch. To install:
  17. Place the ignition switch in the RUN position. Be sure the actuator shaft in the lock housing is also in the RUN position.
  18. Install the switch, making sure the switch snaps over the retaining tabs.
  19. Install the retaining screw.
  20. Connect the wiring to the ignition switch.
  21. Install the ignition lock cylinder.
  22. Install the 2 combination switch mounting screws.
  23. Install the lower and upper shrouds.
  24. Install the knee bolster to the lower dashboard panel and tighten the lower knee bolster attaching screws.
  25. Install the screws that secure the instrument panel top cover to the center of the instrument panel.
  26. Install the instrument panel center bezel.
  27. Install and tighten the screw holding the end of the instrument panel top cover. Install the left side instrument panel/fuse panel cover.
More coming.....

Posted on Jun 26, 2009

  • 1 Answer

SOURCE: 98 sebring jxi convertible. water pools in my back floor board

Sebring Convertibles have weep holes under the body that get clogged with debris and cause the water to back up into the floor. Take a paper clip and straighten it to clean out the weep holes. The weep holes can be found just under the frame at the doors where there is a seam(about where the jack would go). Along this seam about ervery 12 or 16 inches there will be a small slot for the water to drain.

Posted on Sep 29, 2009

reisdos
  • 1297 Answers

SOURCE: 1999 chrysler sebring convertible jxi code p1495

replacing the fuel pump relay is one thing but what about the (ASD auto-shut down) relay

additionally...

  • what engine size?
  • what transmission?
  • any codes?
  • does the pump run KOEO?
  • Do you have spark?
  • What is the cranking speed?

you may find faster service by subscribing to a "live chat" since there are so many questions and variables in your concern

Posted on Jun 04, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Obd2 scanner nolink response for 2000 chrysler sebring jxi limited convertible what can I check for?


Check pin 16 of the OBD2 connector it should have 12 volts key on. Pin 16 is the lower pin on the far right of the bottom row of connectors.

Dec 16, 2016 | 2000 Chrysler Sebring JXi

1 Answer

Firing order; 1999 sebring 2.5l V6?


1999 Chrysler Sebring JXI 2.5L 1-2-3-4-5-6
tecnovative_127.gif

Jul 21, 2014 | Chrysler Sebring Cars & Trucks

2 Answers

How to find 2000 Chrysler jxi convertible top motor


sebring transmission pan torque spec need torque specs for 2000 Sebring jxi convertible, transmission pan torque specs and bolt tighting

Nov 29, 2011 | Cars & Trucks

1 Answer

1999 sebring dies after driving but will start after it sets for a while


I had same exact problem with my 1999 Sebring Convertable jxi, Problem ended up being a bad Crankshaft Positioning Sensor

Dec 20, 2010 | 1999 Chrysler Sebring

1 Answer

1999 chrysler sebring convertible jxi code p1495 intermittant shut off while driving. Replaced fuel pump and filter, distributor, spark plugs and wire. Was advised by ZJLimited to remove connector from the...


replacing the fuel pump relay is one thing but what about the (ASD auto-shut down) relay

additionally...
  • what engine size?
  • what transmission?
  • any codes?
  • does the pump run KOEO?
  • Do you have spark?
  • What is the cranking speed?

you may find faster service by subscribing to a "live chat" since there are so many questions and variables in your concern

Jun 03, 2010 | 1999 Chrysler Sebring

1 Answer

How do you prime fuel pump on 1999 sebring jxi?


all you should hve to do is press the valve stem in on the fuel rail, located on the top of the engine on most vehicles.

Apr 22, 2010 | 1999 Chrysler Sebring

1 Answer

How do you install a convertible sebring rear window? I just need something,like a sheet made of clear vinyl or something like that to replace the rear window with.Would Velcro work?


Nope, from my sports-car "roadster" days the rear window is either bonded in between the layers of the top or sewn-in. An auto upholstery or "trim" shop can probably put you in a new window fairly resonably. Velco, glue, etc. and the window will blow-out if you open the door window at speed. The rear-window would be sucked out at high-way speed by the draft behind the top. BTW: I thought Sebrings had real glass rear windows, like alot of "rag-tops" do these days. (back to the Model T's !)

Feb 11, 2010 | 1999 Chrysler Sebring

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

123 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...