Question about 2001 Chrysler Town & Country

1 Answer

What is the location of windshield washer motor? The rear washer works but the front does not, we have checked the fuse and it is ok.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,565 Answers
Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

WHERE IS THE WIPER/WASHER FUSE LOCATED ON 2007 PONTIAC TORRENT


In the under hood fuse box , should have diagram inside the lid . Front wiper's or rear ? Front fuse # 36 - 25 amp. Plus Two relay's PCB hi and Wiper PCB relay . Wouldn't think this being fuse problem . Wiper switch , motor etc... The wiper's are control by a computer . BCM - body control module .

The windshield wiper/washer system consists of front and rear wipers. The front and rear wipers are operative when the vehicle is in accessory or run. The front wipers have 4 different modes: Mist, Intermittent, Low, and High. When the front wipers are in the intermittent mode, there are 5 delay modes to chose from, commanded by the windshield wiper washer switch through the body control module (BCM). The rear wipers has an only one mode.

If the fuse is bad , could have a short to ground or wiper motor pulling to much current (amps) . Fuse's don't just blow for no reason ! Could also have DTC'S - diagnostic trouble codes stored in the BCM .
DTC B3715
DTC B3873
DTC B3875
DTC B3922

DTC B3715 02: Front Wiper Relay Drive Circuit Short to Ground
The body control module (BCM) controls the wiper motor based on input from the windshield wiper washer switch. The BCM monitors the wiper washer switch through three separate signal circuits and a ground circuit. The windshield wiper switch high signal circuit is used to determine high speed wiper operation, the windshield wiper switch low signal is used to determine low speed, intermittent, and mist operation through the use of a resistor ladder, and windshield washer switch signal circuit is used to determine washer operation.
The BCM controls the windshield wiper motor through two output controls, controlling two different PCB relays which control the desired wiper speed, high or low.
DTC B3922 00: Front Wiper Function Select Circuit

The PCB relay's are non- servicable , replace fuse box . Soldered in Your best bet mit be to take it to a qualified repair shop .

Feb 20, 2017 | Pontiac Cars & Trucks

1 Answer

Both the front and rear windshield washer are not working


See if you can hear the washer motor run. If not, then replace it.

Jul 09, 2014 | Chevrolet Chevy Cars & Trucks

2 Answers

Why no wiper fluid to rear wiper 2002 ford explorer


the washer pump for the rear window is located in the washer bottle under the hood that the front washer work out of. the pump may have stopped working and needs replacing. have someone operate the rear washers and listen at the washer bottle to see if you hear the motor working. if not then you will have to check the plug connection for the rear washer pump for corrosion, broken wires and power and grounds. if these check out ok then replace the rear washer pump in the bottle.

May 15, 2014 | Ford Explorer Cars & Trucks

1 Answer

2004 Hyundai Elantra GT Windshield Washer Pump Not Working. The FRONT windshield washer works, but when I use the rear washer, I hear nothing but silence. I checked the FUSE, it's OK. What is going on?


You have 2 washer pumps on the washer bottle. You need to check to see if power is getting to the rear pump motor by using a test light. When you press the button, one of the 2 terminals should light up. If it does, the pump could be bad or it may have a bad connection. If there is no power, you may have a bad switch.

Nov 02, 2013 | Hyundai Motor 2002 Elantra

2 Answers

I have a 1999 Blazer and the windshield washer pump squirts water on the rear window just fine but will not work for me on the front windshield. Do I have 2 pumps front and back or 1 pump. If it works on...


check front washer pump fuse.if fuse okay problem could be washer switch bad use a 12 volts test light see if washer motor getting power if yes washer motor faulty.if no your fuse okay you have open circuit at fuse box to switch.

Sep 23, 2013 | 1999 Chevrolet Blazer

1 Answer

Where is fuse for windshield wiper pump located ? fluid does not spray and no sound from motor. Motor was replaced still does not work. Rear window defogger does not work. Thank You


This must be the fuse and is found under the dash within the car. If the fuse blows out then you must check the wiring to the front washer motor and to the rear.
Disconnect and check the rear and the front washers.

Jan 20, 2011 | 2000 Buick LeSabre

1 Answer

My windshield wipers don't work but the rear wipers and washer works..do I need to replace the wiper motor? If so, where is it located and how do I replace it?


Check fuses, front and back wiper motors run on different fuses. Test for power and ground at front wiper motor wires. If you have power and ground there your wiper motor may be toast. Good luck

Sep 12, 2010 | 1997 Mitsubishi Montero Sport

1 Answer

MY REAR WIPER AND WASHER DON'T WORK


Check your fuse...for the rear wipers...Now as for the fluid..make sure it's full, because it may not be coming from the front one..you may have a jug located in the back..And if your fuse is good, and you have power to the moter, and the washer fluid pump....Then the washer fluid pump is bad...And you may need a Rear windshield wiper motor...

Dec 02, 2009 | Toyota Sequoia Cars & Trucks

1 Answer

Windshield wipers


From your owners manual:

Fuse#11 30A , Wiper Run/Park
Relay, Wiper Hi/LO Relay, Windshield Wiper
Motor, Rear Washer Pump Relay

U will also need to check the relays if the fuse is ok, the relay, it is the underhood fuse box
Relay #202 — Front Wiper Run/Park Relay

Dec 18, 2008 | 2001 Lincoln Navigator

1 Answer

Front widshield washer fromm 1999 Cherokee doesn't work


the same reservoir is used for both ...it uses separate pump motors.....if the wipers are working the fuse for the washer pump is good...check the power and ground for the pump...

Nov 01, 2008 | 1999 Jeep Cherokee

Not finding what you are looking for?
2001 Chrysler Town & Country Logo

195 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...