Question about 2004 Nissan Armada

Open Question

Arm rest stuck in the upright position. - 2004 Nissan Armada

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How do you reset the windshield wipers to the start position on a 97 camero? The stop In the middle off the window when turned off.


Pull off the wiper arms when the motor has turned off and the wipers at rest. Realign the arms in the position desired and do a test with a mist of water on the glass. The gear alignment is critical to the way the arm rests when in operation and when at rest.

Mar 05, 2014 | Chevrolet Cars & Trucks

1 Answer

Rear wiper arm stuck out of position; will not return to window


Open the rear window and push the arm past its usual position against the window. It may restore the the tension. However, You likely need a new wiper arm, you could also try lubricating the pivot point.

Nov 10, 2013 | 2005 Toyota 4-Runner SR5

1 Answer

BACK SEAT ARM REST IS IN THE UPRIGHT POSITION AND WILL NOT RELEASE 2010 JOURNEY


take a screwdriver and pop the latch out towards the arm rest and pull the arm rest down and it should go down.

Aug 24, 2012 | 2010 Dodge Journey

3 Answers

I replaced the wiper control module and while I did that the wipers were in the up position. Now the new module is in and they are operating but come to rest in the upright position. Do I need to remove...


Perhaps, you could remove the arms and reset them, but, I am curious, did you replace the 'windshield wiper motor?' I was always taught that if the wiper arms did not come to rest in the right resting place, that the wiper motor was at fault.

Good luck on this repair.

Feb 05, 2011 | 1997 Lincoln Town Car

1 Answer

Wipers will not move, makes noise and there is power to the motor. Motor was replaced. Someone told me that the arms probably moved to far and are now stuck, how do I fix this?


Windshield Wiper Blade & Arm Removal & Installation Front To Remove:
  1. Mark the location of the wiper on the windshield.
  2. Remove or disconnect the following:
    • Nut cover
    • Nut from the wiper arm
    • Wiper arm
Wiper arm mounting nut gm_truck_s10_w-wpr-arm_ret-nt.gif
To Install:
  1. Install or connect the following:
    • Secure the wiper arm with the nut.
      1. Tighten to: 17 ft-lb (23 Nm)
    • Nut cover
Rear To Remove:
  1. Put the wiper arm in the park position.
  2. Remove or disconnect the following:
    • The washer hose from the connector
    • The cap from the wiper arm
    • The nut from the wiper arm
    • The wiper arm from the wiper motor shaft
Rear wiper arm mounting nut gm_truck_s10_w-wpr-arm_ret-nt_rr.gif
To Install:
  1. Install or connect the following:
    • The wiper arm on the wiper motor shaft in the park position with the wiper arm resting on the park ramp
    • The nut on the wiper arm
      1. Tighten the nut. Torque to: 17 ft lbs (23 nm)
    • The cap on the wiper arm
    • The washer hose on the connector

---
The wiper motor hopefully is ok, but if the wiper arms were not mounted at the right spot, it could have damaged the motor as it returned to the rest position, unfortunately.

If there is noise, the noise could be coming from the wiper arm joint being stripped out or the motor itself assuming that the ball joints under the hood and behind the firewall are still connected.

Check these items, and I'm sure you will get to the bottom of this.

Good luck on this repair.

Oct 08, 2010 | 1997 Chevrolet Blazer

3 Answers

2003 Chevrolet Venture rear wiper blade does not work and is stuck in an upright position. Turn it on - nothing. Push the blade down to correct position it eventually ends up back in upright position. Is...


I went to Jiffy Lube, and they did something free that made mine work again. Granted I rarely use it anyway(I'm in the desert), but so far, so good. No idea what they did, but it can't have been very difficult.

Apr 06, 2010 | 2002 Chevrolet Venture Passanger

1 Answer

My windshield wipers are stuck in an upright position when they are turned off. they run fine when they are on. what is the problem and is it an easy fix


The wiper blade arm may have stripped the splines that keep it in position on the wiper motor shaft.Sometimes you need a special
arm puller to remove the blade arm, but if it's stripped,it will pull off pretty easy. If yopu take it off,look inside to see if the splines are stripped inside, where the motor shaft holds the arm.It will look all
rounded off, and not sharp ridges.Make sure you start taking it off,
with the arms in their normal down position,and the car off.
Good luck.

Mar 30, 2010 | 1990 Ford Taurus

1 Answer

Removing/replacing wiper motor in '93 Ford Ranger


You don't have to put the wipers in an upright position You can take the arms completely off. It's very easy to do, when you are looking at the base of the wiper arm, on the side closest to the windshield, at the base, there is a spring-loaded tab. Lift the arm on its hinge to where the arm is now pointing away from the windshield, pull the tab and the wiper arm will slide right off. Now you can access the linkage joints easily. Hope that helps!

Nov 09, 2009 | 1993 Ford Ranger SuperCab

1 Answer

Window Switch Removal - The Drivers window switch has stopped working. How do I get the switch out to repair it or replace it? The window is currently stuck in the down position.


the arm rest containing the control, does come off seperate than the door panel. You will have to be careful when prying it off to avoid damaging the arm rest. There are tabs holding it in place.

It's a fairly simple job, the most aggravating part is pulling the arm rest to avoid bending it or damaging the external finish. Good luck!

Jul 28, 2009 | 2006 Ford F-150

1 Answer

2005 impala windshield wiper


the wirpers are connected to a shaft. the shaft is connected to a motor. The shaft must have turned and wipers were stuck and didn't move. So you will need to pull of each wiper arm and reposition with wipers turned off.

Apr 03, 2009 | 2005 Chevrolet Impala

Not finding what you are looking for?
2004 Nissan Armada Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

77194 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...