Question about 2001 Ford Explorer

Open Question

2001 FORD SPORT TRAC O/D LIGHT IS BLINKING - 2001 Ford Explorer

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
chuck943
  • 783 Answers

SOURCE: 2007 FORD EXPLORER SPORT TRAC 4X4 Change oil light on

Press and hold the SELECT/RESET
control switch to select SYSTEM
CHECK when “SYSTEM CHECK /
HOLD RESET” is displayed in the
message center. Selecting this
function from the SETUP MENU
causes the message center to cycle through each of the systems being
monitored. For each of the monitored systems, the message center will
indicate either an OK message or a warning message for two seconds.
Pressing the SELECT/RESET control switch cycles the message center
through each of the systems being monitored.

The sequence of the system check report and how it appears in the
message center is as follows:
1. OIL LIFE RESET
2. CHARGING SYSTEM
3. WASHER FLUID
4. DOOR AJAR
5. EXTERIOR LAMP
6. BRAKE SYSTEM
7. PARK BRAKE
8. MILES TO EMPTY
9. FUEL LEVEL LOW (will only display if 50 miles or less to empty)
To reset the oil monitoring system to 100% after each oil change
[approximately 5,000 miles (8,000 km) or 180 days] perform the
following:
1. Enter SYSTEM CHECK to display
“OIL XXX% RESET IF NEW”.
2. Press SELECT/RESET control
switch to display “HOLD RESET IF
NEW OIL”.
3. Press and hold the
SELECT/RESET control switch for
more than 2 seconds. Oil life is set
to 100% and “OIL CHANGE SET TO
100%” is displayed.

Posted on Apr 02, 2009

Ad
  • 12 Answers

SOURCE: how to change fuel filter on 2001 ford explorer

it in the tank so your gonna either gonna have to drain the tank and lower it to the ground,it shouldn't take more than 30 minutes.make sure you put the seal back in right,so it won't leak,it aint very hard.

Posted on Jul 12, 2009

  • 148 Answers

SOURCE: Ball joint replacement-2003 Ford Sport Trac

if you dont have a ball joint press and dont know how to use one then dont do it, but if you do its not that bad of a job just jack the truck up under the control arm remove the brake rotor then take the lower ball joint nut off then use a pickle fork to break the ball joint loose then take the axle nut off push the axle out of the bearing and use the ball joint press to remove and replace the ball joint

Posted on Jul 19, 2009

  • 5 Answers

SOURCE: how to replace fuel filter on 2001 ford sport trac

Buy a manual and read it. The manual will tell you how to replace...

Posted on Nov 23, 2009

ZJLimited
  • 17970 Answers

SOURCE: steps on replacing a water

4.6L Enginezjlimited_400.jpg

Fig. Water pump installation - 4.6L SOHC and DOHC engines

  1. Before servicing the vehicle, please familiarize yourself with safety procedures.
  2. Drain the cooling system.
  3. Remove or disconnect the following:
    Engine cooling fan Drive belt Water pump pulley Water pump
  4. Discard the O-ring seal.
To install:
  1. Installation is the reverse of the removal procedure.
  2. Install a new O-ring seal and lubricate with engine coolant.
  3. Observe the following tightening torques:
    Pump bolts 18 ft. lbs. (25 Nm). Pulley bolts 18 ft. lbs. (25 Nm).

Hope this helps (remember to rate this answr)

Posted on Jan 04, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My tabs on my steering wheel are gone need to know what they are 2001 Ford sports trac help please


go to 2001 ford sports trac owners manual and download the manual for free it's in there

Mar 04, 2015 | 2001 Ford Explorer Sport Trac

1 Answer

Up and down movement on rear axle 2001 ford explorer sport trac


how do i pull out rear axle from my 2001 ford explorer sport trac

Jul 04, 2012 | 2001 Ford Explorer Sport Trac

1 Answer

Tail lights out brake lights out turn signal blinks right no matter which way you pull lever 01 explorer sport trac


It sounds like a bad earth connection in the vehicle rear wiring loom. Check the earth wire that runs from the globe sockets in the light units and any connectors in the wiring loom near the light assemblies as well as where the earth wire is attached to the body. If necessary, remove, clean thoroughly by removing any corrosion or paint and re-attach securely.

Sep 29, 2010 | 2001 Ford Explorer Sport Trac

1 Answer

2001 ford explorer sport trac wont start all the function turn on


check what the diagnosis machine will give if there is no data then check if the starter crank sensor is getting any power

Jul 26, 2010 | 2001 Ford Explorer Sport Trac

1 Answer

2001 ford sports trac brake lights not working ,


This may be a simple fix, where the wheel jack or washer bottle is located in the back behind the panel, there should be connectors for the rear lights, it is possible that the plug has been dislodged, remove the panels and check the plug connections. Good luck.

Nov 19, 2009 | 2001 Ford Explorer Sport Trac

1 Answer

Does a 2001 ford sport trac have a hi beam relay


no, but you might have a bad switch. thats whatever you click to get high beams. replace that & they should work.

Jul 18, 2009 | 2001 Ford Explorer Sport Trac

Not finding what you are looking for?
2001 Ford Explorer Logo

Related Topics:

148 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5516 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...