Question about Dodge Ram 2500
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 2002 dodge ram 2500 diesel
I'm no expert, but I am on my second Dodge. I have a 2004 Ram 2500, 125k miles on it. I traded in my 2001 1500 with 99k on it.
Your problem sounds like one of two things that happened to me. At 110k mi's it was not accelerating properly, particularly between 40 and 50 mph. It turned out my torque converter was going bad and I ignored it for too long and it's disintegrated pieces ruined my transmission. I recommend getting over to Aamco right away or to the dealer if you are still in warranty and have the TC checked out. The diesel is just too much torque for a torque converter on the automatic transmission, but manuals are too much of a pain these days. $2300 at Aamco to have the TC replaced and the tranny rebuilt.
The new problem I have now is when it acted like it was out of fuel and then wouldn't turn over after it died. My fuel lift pump (diesels have two of everything and the expensive one is always what goes) has gone bad and is currently being replaced, $700 part, plus another few hundred in labor.
Hope this helps.
Posted on Oct 28, 2008
If you are looking for the fuse box diagrams or any other diagrams for your Ram, check promanuals.net for a factory service manual for around 20 bucks or so. It's an invaluable tool for my Ram 2500.
Posted on Sep 26, 2009
Zerex's G-05 type coolant is specifically formulated for Chrysler specs.
Thanks for using FixYa and please do rate my answer.
Posted on Nov 22, 2009
Not too much amperage. HID lights use less amps. Duh. The circuit is showing a failure in the HID kit from not enough amps so it turns off. You need to add a resistor.
Posted on Dec 07, 2009
It means "Crystal Clear Display"
but in basic term its called a ccd bus, basically the OH console module is not communicating with body control module so you want to check power and ground pins or you just might have a bad module, sorry.
A self-diagnostic test is used to determine that the
compass mini-trip computer module is operating
CCD communications test.
Following completion of these tests, the compass
mini-trip computer will display one of three
messages: “PASS,” “FAIL,” or “CCd.”
if the “CCd” message is displayed, the use of a
DRBt scan tool and the proper Diagnostic Procedures
manual are required for further diagnosis.
Posted on Jun 30, 2010
Testimonial: "Many thanks for your expert advice"
Tips for a great answer:
Dec 02, 2015 | Cars & Trucks
Feb 25, 2015 | 2005 Smart Fortwo Coupe
Jun 12, 2013 | Cars & Trucks
This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve but always run a OBD2 fault code as well as the cleaning procedure. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control. If the above cleaning doesn't cure your issues you need to have the computer controlled automatic idle speed control system diagnosed and repaired by a dealer or electronic engine control repair shop.
Nov 07, 2012 | Cars & Trucks
Aug 09, 2010 | 2006 Dodge Sprinter
May 23, 2010 | 1993 Dodge Dakota
Dec 20, 2008 | 1993 Ford Probe
Dec 02, 2008 | 2000 Jeep Grand Cherokee
87 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: