Question about 2000 Jeep Cherokee

1 Answer

I have a leak in my evaporative coller on my 2001 Jeep Cherokee. I need instructions on how to remove the dash in the vehicle and what the cooler looks like and also what the heater coil looks like.

Posted by on

  • Richard Scordino Sep 02, 2010

    You would be best served by getting yourself either a haynes or chilton manual for r&r instructions. (way too long to write here) Both units look pretty much the same except that the heater core is attached to the heater hoses and the evaporator is connected to the A/C lines with pressure fittings. It is far from a fun job!!!! Good Luck!!!

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 677 Answers

Have you checked first that the evap/drip tray has not got a blocked run-off hose?It sits under the evap.It collects the water and allows it to flow out through a tube through the firewall.It's about 1/2 to 3/4" wide.If you are getting engine coolant leaking into the car, then what I wrote,won't help you.Hope it's not the coolant because it's a fiddly job.Hope this helps you

Posted on Sep 03, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Error codes p0442 and po445


Po442 is evap system leak
check intake and all vacuum hoses for leaks
check evap canister and purge valve
Po445 is evap canister purge valve short circuit
check wiring and connection

Apr 16, 2016 | 2002 Jeep Grand Cherokee Limited

1 Answer

How to change gasket on oil cooler 2001 Kia Sportage?


An "O" ring can be purchased at your local auto parts along with your oil filter. Your oil filter screws on top of your oil cooler. Mine leaked as well. A new "O" ring and filter screwed on tightly solved my problem.

Jun 22, 2014 | 2001 Kia Sportage

1 Answer

Evaporator Core in 2000 Cherokee


The center console, dash board and a-pillar trim will need to be removed as well as the heater box.

Jun 27, 2010 | 1998 Jeep Cherokee

1 Answer

How to replace a/c evaporator in 96 jeep cherokee 4.0?


would advise garage repair as dash needs to be removed because evaporator located in heater box located behind dash

May 07, 2010 | 1996 Jeep Cherokee

2 Answers

How do you install a heater core in a 1999 jeep grand cherokee?


I suggest review the ZJSecc24-Heating-and-Air-Conditioning

First you'll need remove the heater A/C unit from the vehicle; after, remove the heater core retaining screws, and finally, pull the heatrer core straight out of the housing.

Hop helped with this (remember rated this help) Good luck.

Nov 30, 2009 | 1999 Jeep Grand Cherokee

1 Answer

How to replace heater core in a 1988 jeep cherokee?


Jeep Cherokee XJ Heater Core

Work for '92 models, but can use it like a reference guide.

6042054.gif

Figure 1

  1. Disconnect battery ground cable, then drain cooling system.
  2. Disconnect hoses from heater core.
  3. If equipped with A/C, remove evaporator/blower housing as follows:
    1. Discharge A/C system, then disconnect hoses from expansion valve.
    2. Disconnect electrical connector and vent tube from blower motor.
    3. Remove console, if equipped.
    4. Remove lower instrument panel attaching screws, then the lower panel.
    5. Disconnect electrical connections from A/C relay, blower motor resistors and A/C thermostat.
    6. Disconnect vacuum hose from vacuum motor.
    7. Cut evaporator/blower housing to heater core housing retaining strap, then disconnect heater control cable.
    8. Pry retaining clip from rear of blower housing flange, then remove the three retaining screws.
    9. Working from engine compartment, remove evaporator/blower housing attaching nuts, then the evaporator drain tube, Figure 1.
    10. Remove right kick panel, then the instrument panel support bolt.
    11. Pull right side of dash outward, then rotate housing downward and towards rear of vehicle until studs clear dash panel. Remove housing from vehicle.
  4. Remove heater core to housing retaining screws, then the heater core, Figure 2.
  5. Reverse procedure to install.
ad4c27d.gif

Figure 2

Personally, I'd pressure test the cooling system then look at the heater core to see if it leaks. It may just be a loose clamp or leaky hose.

Also can check the forum jpmagazine.com

I hope help you; good luck (remember rated this).

Sep 15, 2009 | Jeep Cherokee Cars & Trucks

1 Answer

88 Jeep Cherokee Transmission Fluid Leak


you need to tighten those fittings with a wrench... if they still leak... remove them and wrap them with a couple turns of "teflon tape" the kind they use for plumbing. the clamps you should use are hose clamps of the same type that you use for radiator hoses... you will note these can be tightened with a socket.... you really don't need to over tighten them but fairly snug... transmission fluid has quite alot of pressure.

Apr 19, 2009 | 1988 Jeep Cherokee

1 Answer

How do replace a 2000 Jeep Grand Cherokee evaporator? Do I need to take the whole dash apart?


I have read it is quite a job. The heater core in my 97 Grand Cherokee (which is in the same location as the evaporator) is leaking. I think you have to remove the entire dash to get to it.

Apr 15, 2009 | 2000 Jeep Grand Cherokee

1 Answer

Entire heater needs to be replaced


i work at a dealer and generally its is 8 hours labor to remove the dash. disassemble the HVAC box, repair whatever doors or motors broke, checking the Evaporator and heater core for leaks. and it typically comes out to around $1400 when all is said and done but thats also at $90 per hour

Dec 19, 2008 | 2001 Jeep Grand Cherokee

Not finding what you are looking for?
2000 Jeep Cherokee Logo

Related Topics:

98 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...