Question about 2004 Jeep Liberty

1 Answer

Changed fuses for back up lights in 2004 jeep liberty. bulbs are not blown. is there a relay or a wire (where) that needs to be replaced?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Having the same problem. bulbs are good. fuses keep blowing.

Posted on Sep 05, 2010

  • WERKSAUTO Nov 05, 2010

    HAVE SAME PROBLEM TRACED HARNESS DOWN AND UNPLUGGED REAR HARNESS STILL BLOWS ONLY WHEN PUT IN REVERSE, TRACED TO PROBLEM IN SOLENIOD BODY OR TRANS HARNESS HOPING SOMEONE ELSE HAS HAD THIS BEFORE ITEAR TRANS DOWN

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

08 jeep liberty has no brake lights all other lights ok, fuse -bulbs ok


Try replacing the brake light switch on your motor . It should be near the brake pedal .

Feb 07, 2015 | 2008 Jeep Liberty

1 Answer

2004 Jeep Liberty left tail light, left front parking light, and license plate light not working. Replaced all bulbs and number 7 fuse. Any ideas?


sure, do you have 12vdc to the lamp, in park?
if not work to the source , the relay that the operates that.
alldata.com has the schematic.

fact 1, license plate feed runs off left park.
fact 2, the park relay feed both left and right park fuses and lamps.
so, fuse 7 is left, and fuse 9 is right.
did you only just look at the fuse, and proclaim, good.
or use a voltmeter? or use ohms to test fuse 7, oops
fuses that look good, can be bad. 0 ohms good, infinity is bad.

use volts, is there 12vdc on both sides if fuse 7,>?
yes, then fuse is good, parks turned on.
no, the output side of fuse 7 is 0v. so fuse is blown
if input is dead, the relay is bad, but how can it , if right works, answer.
it cant be bad.
so what is the voltage all the way from the fuse to the lamps.
id bet, (fuse good an voltage good at fuse 2 sides) that the line is open. cut wire, corroded connector.

the BCM turns the relay on, this part works.
so.... its just a break in this simple copper path.

use a voltmeter, it will not lie to you, trust it./

Apr 05, 2014 | 2004 Jeep Liberty

1 Answer

Right side parking lights


usa car, not Renegade or export car. nor DRL lamps.

fuse, can look good but be bad.
use any ohm meter, to make sure they are good. 0 ohms good.
the car can have park-tail relay. yes, it does have a park relay
that feeds 2 fuses (#7&9) then all lamps left and right.
the BCM controls the relay. body brain.

check voltage at all 4 pins of park relay, and bingo know who is messing up,?
pins 86/87 hot 12v all the time( battery)
87a = ground 0v all times.
30 is relay output, 12v park on.
85 pin is relay coil control. 0v park, 12v not park.
if you have 0v on 85 , in park the BCM is working

there is start.
if a fuse is blown to the BCM, it will mess up

Jan 06, 2014 | 2004 Jeep Liberty

2 Answers

2005 jeep liberty no parking lights front or


you may have ablown fuse or a bad ground

May 21, 2010 | 2005 Jeep Liberty

1 Answer

I have a 2008 Jeep Liberty sport it has 39600 back-up lights not


If you have tested fuses and bulbs with test light,and they check out,
the next step is to put you jeep in reverse with the key on,and use your test light to probe the wires before they enter the bulb sockets for power,if you have power replace sockets,if not check to make sure wires are still connected to back up light switch on trans,if you find no problem there,replace the switch

Dec 03, 2009 | 2006 Jeep Liberty

1 Answer

Fuse box not marked in my 2004 jeep liberty, having light problem and have replaced bulbs


It takes about ten minutes to check all the fuses. Use a test light and probe the cavities on the ends of the fuses (don't even need to remove them) With the key and light switch turned on, all fuses should have power at both ends. Replace any that don't. Check all fuses under dash and in power distribution center under hood...also check any lighting relays in dist center. Likely you will find something if you do this, if not, check grounds and any lighting modules involved.

Nov 28, 2009 | 2004 Jeep Liberty

2 Answers

Left tail light does not work i put a new bulb in and still dont work i plug the whole assembly in on the right side and it works


Must be a broken wire. You'll have to trace it back using a test light, and probing every foot or so, until you find power.

Nov 15, 2009 | 2004 Jeep Liberty

1 Answer

Turn signals on my 2004 jeep don't work what to


If one of your bulbs has blown you will get a faster relay click when you activate the indicators. It sounds as though the relay itself could be sticking / broken.

Of course it could just be a blown fuse, I would check that first before changing relays

Nov 12, 2009 | 2004 Jeep Grand Cherokee

1 Answer

Why is my 2004 Jeep liberty sport Brake lights not working. I have replaced the bulbs and fuses, what else can i do?


The brake light switch is probably bad. It's usually located up under the dash and is connected to the brake pedal shaft. It could even be unplugged.

Jun 18, 2009 | 2004 Jeep Liberty

2 Answers

2002 jeep liberty - limited - electrical problem


If yor liberty is a 2002 to 2004 it is very likley that the wiring harness is pinched under either the drivers or passengers seat. you need to remove the seats (its only 4 bolts) and lift up the carpet and look at the harness that runs under the seats. I have seen this many times before.By the way i am a Jeep master technicain and have been for 15 years.

May 18, 2008 | 2002 Jeep Liberty

Not finding what you are looking for?
2004 Jeep Liberty Logo

Related Topics:

181 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...