1992 Jeep Wrangler Logo

Related Topics:

Posted on Sep 02, 2010

How to fix 1992 Jeep wrangler horn? Fuse and wires seem fine.

5 Related Answers

Anonymous

  • 188 Answers
  • Posted on Feb 14, 2009

SOURCE: Horn wont work

If you are facing the front of the jeep. It is on your left, on the fender well. Yes, you do have a fuse under the dash. The fuse panel should be marked on what fuse is it.

Ad

Anonymous

  • 1 Answer
  • Posted on May 10, 2009

SOURCE: horn don't work 1992 jeep

The horn is located in the front bump on the drivers side. You'll need the remove the side cap to access the horn itself. As for the fuse, check under your dash on the drivers side. You will see the fuse box. Printed in white type up-bove each slot, should indicate which one the fuse watches, there should be one for horn. If you can't find it, then one by one remove the fuses and check to see if any have blown.

Anonymous

  • 60 Answers
  • Posted on May 11, 2009

SOURCE: 95 jeep wrangler 4x4 6cyl. no spak from coil and

you have a short in the ign. circut

Anonymous

  • 49 Answers
  • Posted on Sep 12, 2009

SOURCE: Dont know were to put in new transmission oil on a 1992 Jeep Wrangler

It's on the passenger side of your transmission, around half way down. after draining your fluid, fill untill fluid comes out where your putting it in

Anonymous

  • 30 Answers
  • Posted on Feb 16, 2010

SOURCE: replace horn fuse in fuse panel of 1992 pontiac bonneville

Your fuse box is located on the driver side under the dash board. Up above where your brake and gas pedal are located. There should be a plastic cover that can be snapped off to reveal all of your fuses and on the inside of this plastic cover there should be a diagram of the fuses that are in use.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

How do I repair horn on 2005 Jeep Wrangler?

how to fix a horn on the work bench
or how to diagnose a dead horn on car.?

my guess, #2
TJ car.
here is the list;
  1. do not fiddle wires near horn sitting at steering wheel unless you defeat air bags first, per the BOOK "FSM" or u may die.
  2. check the fuses first.
  3. scan the PCM next, got DTC errors ?
  4. read the FSM yet?
here, TJ
http://colorado4wheel.com/manuals/Jeep/TJ/

the pdf.
chapter 8H> horn
and the schematic there 8w?
8w41-3 see that relay, does it click with button pushed?
key on?
need more ask.
is ground good to horn
did you hot wire horn to see if its really good first
connector pulled?
0helpful
1answer

2007 jeep wrangler horn wont work

you will need to remove air bag from steering wheel wire for horn is behind it
0helpful
1answer

My horn isn't working quite right. It only blows if you push the button in a certain place and that certain place moves around all the time. But even when it does blow, it stutters. I don't think...

if it was a fuse problem the horn wouldn`t make a noise.it sounds like the horn contacts that touch when you push on the button are not making proper contact each time.if you remove the horn button and look at the contact spots you may see the problem(uneven contact surfaces).if you move/bend the contact surfaces closer to each other of straighten this may help the problem.you may even have a horn that needs to be replaced as you said when it does work it stutters and not blow.the diaphragm in the horn can dry out and not vibrate like it should.try tapping on the horn when someone tries to blow the horn if it stops or gets louder then the diaphragm is no good.you could also check the connection at the horn itself it may have a bad connection due to corrosion and just need cleaning.
1helpful
1answer

I just bought a 1993 jeep wrangler 4wd. The only thing is the horn isn't working. How can I fix this?

First check that the fuse for the horn is good and if it is you will need to replace the horn relay that is found in the under hood high amp fuse box.
0helpful
1answer
1helpful
2answers

2006 Jeep Wrangler cigarette lighter not working

Check for un-isulated connection on the hot wire lead. It might have been after-market but on mine the connection would short out, blowing a fuse. 1 inch of heat shrink tube fixed the problem.
0helpful
1answer

Horn not working. Fuse is good. 2005 Jeep Wrangler. How do you remove the rubber cover on the sterring wheel to get at the horn.

May be bad horn. Get a 12 volt test light or multi-meter and attach to the horn wire at the horn. Have a helper press the horn. If you have 12 volts when it is pressed, horn itself is bad. Otherwise, may be bad horn relay. Horn cover should pull off.
0helpful
1answer

Horn wont work

If you are facing the front of the jeep. It is on your left, on the fender well. Yes, you do have a fuse under the dash. The fuse panel should be marked on what fuse is it.
0helpful
1answer
Not finding what you are looking for?

739 views

Ask a Question

Usually answered in minutes!

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...