Question about 2006 Chevrolet Colorado

Open Question

What type of oil does a 2006 chevy colorado use?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 4 Answers

SOURCE: How do I reset the "Oil Change Warning Indication" on colorado

if you have a owners manual read it. try coloradofans.com website and search the forums. i think johnny5846 is right if you don't have a DIC (driver info center). i believe you use the DIC(tripodometer). i don't know the sequence off hand, you can also you can change your lock settings and alarm settings, etc. with the DIC.

Posted on Jan 16, 2009

c17hydro
  • 2984 Answers

SOURCE: how do i change out the knock sensor on a 2006 chevy colorado

You didn't list your engine size so please pick the applicable to your motor size:

Removal & Installation 2.8L & 2.9L Engines To Remove:

  1. Lift the vehicle high enough to gain access to the knock sensor (KS) through the left front wheelhouse.
  2. Remove the left front wheel and wheelhouse liner.
Knock sensor (KS) (A), Engine harness (B), Knock sensor (KS) connector (C)


e44e83f.gif
  1. Disconnect the knock sensor (KS) connector.
  2. Detach the knock sensor (KS) from the engine block.
To Install:
  1. Attach the knock sensor (KS) to the engine block.
    • Tighten the bolt to 18 ft lbs (25 Nm).
  2. Connect the knock sensor (KS) connector.
  3. Install the left front wheelhouse liner and wheel.
  4. Fully lower the vehicle.

Posted on Sep 03, 2009

  • 1 Answer

SOURCE: 2006 colorado intermittently fails to start. It

Clean all the electrical connections you can get to under the hood with automotive electronics cleaner,dry with compressed air and pack each connector with di-electric grease.

Posted on Nov 13, 2009

peterrance19
  • 399 Answers

SOURCE: I have a 2004 chevy colorado. I was going to

hi its situsted next to front passanger wheel in line with the transaxle you will see the oil pan the drain plug is on the back please rate this answer

Posted on Nov 19, 2009

techbuster
  • 5081 Answers

SOURCE: how do you change the

This is for the 5 cylinder 3.5 liter engine in the Colorado

1. The drain plug is in the middle of the oil pan on the drivers side.
Use a 15 mm socket or box end wrench to remove the plug. Drain
oil.
2. The oil filter is at the bottom front corner of the engine on the passenger side. Remove the filter. Try not to tip the filter when you
remove it so you don't get oil on other parts of the truck.
3. Rub a small of oil on the gasket of the new filter. Spin on the new filter, 3/4 to 1 turn past when the gasket starts to seat. Hand tighten
only.
4. Reinstall the drain plug. DO NOT OVER TIGHTEN OR YOU COULD
STRIP THE THREADS.
5. Add 6 quarts of oil to the oil filler tube located on top of the engine
in the front and middle of the engine compartment. It shows the location
in the owners manual. Install the filler cap.
6. Start the engine and let it run a few minutes to fill the filter with oil.
Turn off the engine and wait a few minutes for the oil to drain down to
the bottom of the engine. Remove the dip stick and check oil level.
Checking oil level is in the owners manual.

Posted on Aug 10, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Condensation in engine oil 2006 chevy colorado


Depends on the problem. It could be coolant leaking into the engine oil, or a vent problem, or the engine may not be reaching normal operating temp and getting rid of the moisture inside the engine.

Feb 23, 2014 | 2006 Chevrolet Colorado

1 Answer

Where is the oil pan on a 2006 Chevy Colorado?


if ur asking this its best you dont touch anything

Jul 03, 2012 | 2006 Chevrolet Colorado

1 Answer

Where is the oil drain plug on my 2006 two wheel drive ex cab chevy colorado. I can not find it anywhere please help me!!


The drain plug is on the drivers side of the oil pan. About 1/2 way back from the front of the engine

Jan 25, 2011 | 2006 Chevrolet Colorado

1 Answer

Reset change oil light 2007 chevy colorado 4cyl.


Turn the key to the on position a then press the gas pedal three times within 5 seconds,the oil life light should flash 5 times then go out,then the oil life will be reset[the reset procedure is in the owners manual if this doesn't work].

May 31, 2010 | 2006 Chevrolet Colorado

1 Answer

Reset change oil signal on a 2008 chevy colorado


Turn key on (do NOT start the engine) now depress the gas pedal, to the floor 3 times, now turn the key off. now start the car, the light should be off, if not, try it again.

May 14, 2010 | 2006 Chevrolet Colorado

1 Answer

What type of oil should I use in a 2006 Colorado? And how many ?


It depends on the climate you are in, ask at the local auto parts store where you buy your oil, they should know, usually if you don't know 10W-40 is a healthy medium.

Jan 22, 2009 | 2006 Chevrolet Colorado

Not finding what you are looking for?
2006 Chevrolet Colorado Logo

Related Topics:

322 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...