Question about 1994 Chevrolet C/K 2500

1 Answer

Eng. acts like an acculater pump is bad, but it has a throttle body fuel inj.no codes and fuel pressure is ok,it simply has a very noticable hesitation when its warmed up

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 361 Answers

Change plugs and wires

Posted on Sep 02, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to check out a fuel pump system on a1998 dodge dakota 3.9 eng


if the fuel pump is running then check the fuel pressure with a gage it should be around 35 lbs pressure for a multipoint injection system if its throttle body injection its around 15/18 lbs. also check fuel volume its usually around 1 pint in 15 seconds.

Aug 16, 2014 | Cars & Trucks

1 Answer

1990 olds 98 suddenly dies. starter spray into inj. cover starts it but then immediately dies again. fuel pump and cannister filter ok. new module filter off inj. line under hood. still won't start. w


You cant check fuel pressure that way. You have to connect a fuel pressure guage to the fuel rail at the schrader valve. It should have 30-40psi when ignition is turned on. Injectors not functioning properly will cause a misfire Sounds like a fuel pump or fuel going out.

Jan 01, 2014 | 1990 Oldsmobile Ninety Eight

2 Answers

Acts like it is starving for fuel. when i push on the accelerator it seems to smother itself out. I changed the fuel filter so far and it did not help. It has throttle body injection. Does anyone have an...


could be your fuel pump is failing. the best beginning will be to place a pressure gauge inline and monitor the fuel pressure when you race the engine. If the pressure drops off then it might be the pump. By the way, is your air filter clean?

Mar 07, 2011 | 1989 Dodge D150

2 Answers

I have a 1993 gmc 2500 van with a 4.3 v 6 engine stalls will not start. get no fuel at throttle body inj. if I add fuel to throttle body van will start and run as long as I give it gas . when allowed to...


You must have a leak or one of the lines are clogged. The reason it stays running when your on the gas is because it keeps the fuel pressure up. Then when it shuts off it loses all pressure in the line and the pump cant handle the initial start with the leak in the line.

Sep 14, 2010 | 1993 GMC G2500

1 Answer

I install a fuel pump but can't get any fuel to the throttle body. the fuel pump runs but it won't go through the throttle body?


hi.. so is it a carby or direct inj or throtle body inj ? if its a carby then you may need to clean out the jets, if not then the fuel does not neciserily go through the throttle body, just make sure your fuel lines are on the correct way, they are easy to confuse and usualy the most common mistake... if it is a mechanical fuel pump to a carby try starting useing 'easy start' aerosol can and it might help **** the fuel through... also if the carby is empty it will be hard to get fuel in so you can help by tipping some fuel into the carby pots..

Feb 11, 2010 | 1987 Chevrolet S-10 Pickup

1 Answer

Hard start/long crank after warmup and sits for 20 30 minites. ( new inj, new plugs, clean throttle body. Don


get yourself a fuel pressure gauge from sears hardware and check the pressure. watch to see if the pressure drops down as the truck sits. if it's dropping down you may need to replace the fuel pressure regulator or the fuel pump. more likely the regulator

Nov 17, 2009 | 2001 Ford F150 Styleside SuperCrew

2 Answers

Crank no start: has no spark and only has injector pulse on cyl # 1. if you spray starting fluid directly into throttle body car starts and stays running and has spark and inj. pulse. once you turn the car...


Fuel pump, you have to have press in the rail to fire all injectors- she will run on ether but not good for her. Ck your pump and any related fuses,relays,wiring.

Jul 11, 2009 | 2002 Hyundai Accent

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

56 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...