Question about 2004 Dodge Stratus

1 Answer

Where is heater fan resistor located - 2004 Dodge Stratus

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 108 Answers

Should be located on or near your blower motor assembly, under the dash. Trace your wires from your blower motor connector if your not sure and one or both will run to it.

Posted on Sep 02, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Fan resistor


Located Usually On Front Of Engine Block About the Size Of A Quarter ( Black ) with One Wire Comiig outof it

Dec 11, 2013 | Cars & Trucks

1 Answer

Where is the Heater Blower Motor Resistor, located on Chevy S10, 2002?


The resistor is located right behind the blower fan motor and to the drivers side just a bit. I found it easier to get to the resistor by pulling the blower fan housing

Mar 05, 2011 | Chevrolet S 10 Cars & Trucks

3 Answers

Heater motor only wokks on high


probley the restor that gives the a/c heater fan motor its power for the low/ medeam speds has gone bad and onley letes it run on high speed because it gives the fan motor full battery voltage on high speed. it should be located in the heater box were the fan will blow air across it to cool it when it is in use GEORGE STIRBER DBA AUTO ENGINEERING

Jan 01, 2010 | 2001 Nissan Xterra

1 Answer

Heater fan


Your fan technically only has one speed. The voltage is decreased by the use of a resistor pack to produce the slower fan speeds. If this resistor pack burns out, it will leave you with only the high setting. You can find the resistor pack located under the hood, on the passenger side on top of the fan housing.

Dec 15, 2009 | 2003 Ford Ranger Regular Cab

1 Answer

Blower motor, heater fan, radiator fan not working im not sure what the problem is. there is no power getting to these parts


Blower motor problem may resistor,have seen resistor and connector burnt. Resistor is located under dash on right side on heater case, check for damage.Radiator fan has 2 relays,high and low and also has a resistor,I would start with these items. Make sure fuses are ok.

Jul 05, 2009 | 1996 Mercury Mystique

1 Answer

Heater wont work a fuse maybe? some how I doubt it. the rear window heater works. fan dead perhaps? no fan at all. not sure about heat.


Hi: Sounds like a possible heater resistor problem. First check to see if heater fan working, unplug heater under hood and put 12 volts to it from the battery with a wire (single black wire running to back of fan). If works then problem probably the resistor which is located on the fan housing under the hood to the right of the fan. The resistor has wires to it running from the heater fan, 2 - 7mm screws holding resistor in place, check resistor to see if any of the 3 elements are melted off, if so replace. Note: Rear window defrost has nothing to do with heater fan. Hope this helps...

Feb 26, 2009 | 2002 Chevrolet Blazer

2 Answers

2003 Jeep Liberty heater fan problem


It is the blower motor resistor. Look under the passanger side dash and locate the fan housing (looks round and black in color. Then locate the resistor it will be in that housing usually withtwo ten millimeter nuts or two simple screws holding it in. unplug the harness to the resistor and remove the resistor. Part store price is approx. 50.00. Note: on aftermarket (not Jeep) resistor sometimes you have to modify the housing a little to get it in. Hope this helps.

Feb 01, 2009 | 2003 Jeep Liberty

1 Answer

A/c heater fan no blow


sounds to me like the blower motor resistor, and if I'm not mistaken the resistor and the blower motor are located under the dash on the passengers side. the resistor should have a wiring connection and 2 screws attaching it to the blower case. The a/c and heater blower will not work if the resistor goes out. hope this helps you out a little. Best wishes.

Jan 16, 2009 | 2006 Jeep Grand Cherokee

4 Answers

2002 dodge grand caravan heater blower only works on high spped


If you are looking for the fan blower resistor, it is located behind the glove box. No tools need to get to it and a nut driver to remove the 2 screws to replace it. A 20$ part.

Jan 06, 2009 | 2002 Dodge Grand Caravan

1 Answer

Heater switch to operate the fan inside the car


It's usually caused by a faulty fan speed control resistor. If you can follow the wires from your switch, they usually connect to this resistor and in turn the resistor is connected to the fan. I found my fan control resistor on my GM car inside the fan cavity. I removed the fan and located it inside the housing. This resistor gets very hot so it is placed close to the fan to cool it. Good luck.

Oct 13, 2008 | 2002 Chrysler Sebring

Not finding what you are looking for?
2004 Dodge Stratus Logo

55 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...