Question about 2004 Dodge Intrepid

1 Answer

After getting the up to about 55-65mph then slow down to under 40mph it seems that the trans will not go back in to over drive, and now when it happens I get a low end tap as I go over 45mph and a light hum. I have code P0700 and P1776

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 75 Answers

You need to have the solenoid inside your transmission replaced. That is the P1776 code, and it is what is causing the P0700 code.

Also, make sure to do a transmission fluid flush and change, along with changing the transmission filter.

Posted on Sep 02, 2010

  • chad355 Nov 09, 2010

    did this fix your problem?

  • angie smith
    angie smith Jun 26, 2014

    when changen the fluideand filter can the solinoid be taken off and cleaned

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have an 04 hyundai elantra. When im driving slow (0-40mph) you can hear a grinding noise coming from the front driver side, but when i speed up on the highway or anything there is no more noise. it


This could be the brake pads dragging or it could be a wheel bearing. You can check one or the other. The wheel bearing is tested by jacking up the car with that wheel off the ground and see if you can rock the wheel side to side or up and down. The way to check the brakes is to take the wheel off and look at the brake pads.

Sep 14, 2014 | 2004 Hyundai Elantra

1 Answer

Hello I have a 2002 GMC Envoy and my reduced engine power light comes on and now when I drive the car acts as if it wants to? stop what going on


There is nothing you can do to fix this at home, it needs to be diagnosed by the dealer with a special tool

Jun 08, 2012 | 2002 GMC Envoy

1 Answer

Transmission shifts hard when slowing down to stop


Dirty trans filter,stickey trans solinoid,or your torque converter is not unlocking.If you can due it yourself try running some trans flush then replace the filter.

Jan 02, 2010 | 1999 Chevrolet Silverado 1500

1 Answer

Transmission wont shift after 40 mph sometimes it works find but when you slow down to 40mph it **** and the rpm stay up


I had the same problem, so I added "Trans X" from the auto store, and after a few miles the trans started shifting. Seems gunk get into the shifting mechanism. Also a trans service could be the problem. Should have a trans service every 30k. Keeps trans clean. Try it , it worked for me

Oct 15, 2009 | 1994 Chrysler Concorde

1 Answer

I was driving today with my cruise control on. the engine revved up to over 4500rpms and then slowed down to under 2000rpms. the car will drive, but it will not go above 1-15 mph.


is check engine light on, if etac sees trans problem wiil put trans into limp home mode and go into 2nd gear,sometimes when trans cold may work ok,will have to get trans computer scanned to see if input and output speed sensors are ok

Oct 05, 2009 | 2002 Ford Escape

1 Answer

Engine no start on 1988 mercedes benz 190e


Hello, You could have a stopped up fuel filter or a bad fuel pump or bad gas etc. If you overfilled the trans, that would explain the oil loss. It will also aerate the trans oil and make the trans not work properly. You didn't mention what vacuum hose was broken. This could also cause the engine to not run properly. You need to check the fuel pressure and supply and go from there. Make sure that the trans fluid is 10mm below the mark on dipstick when cold and on the mark when warm.
If fuel pressure and supply is correct you need to check the exhaust system for restriction.

If you find this info to be correct, please enter a (fixya) rating.
Thanks, Gator241

Mar 02, 2009 | 1988 Mercedes-Benz 190

2 Answers

1992 buick LeSabre transmission troubleshooting!


92 Buick lesabre 97000 miles, on slow acceleration, @ 40mph going into 4th gear there is a mild chutter, same @ 50mph going into OD mild chutter and when down shifting from OD to 4th. All is when slow acceleration. When I say slow acceleration, I mean I drive like a older senior citizen when everyone behind me is annoyed I don't just donor and go. When I do romp to accelerate quicker, there is no chutter at all. Fluid is good and at perfect level. Any ideas? Great car just wondering the scoop is

Mar 01, 2009 | 1992 Buick LeSabre

1 Answer

Trans clunking when slowing down


Sounds like youi may have a few serious problems going on to have that kind of back lash occuring at higher speeds. I have experiance with low spped clunks on Bronkos and your type of vech being a car dealer. One you might try for low speed clunk on take off and braking at stop likts just completeing a stop? Pull the drive shaft and lubricate the splin - two check your leaf springs for weakness and wore bushings - take a look at your shocks - three u bolts holding springs to rear axle housing may be letting the axle housing actually dip or tweak or all those thing in combination - now you may have some serious slop in the pig - transfer case may be causing that clunk - as far as high spped clunk and activity you have a serous problem and you just might drop the transferr case have an accident fliping over..............Mike South Bend Indiana don't just keep driving and making problem worst...........

Jun 23, 2008 | 1996 Ford Explorer

Not finding what you are looking for?
2004 Dodge Intrepid Logo

693 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

77186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...