Question about Nissan Xterra

Open Question

Radio preset disappear, some times turning key to start gets a click or two before the starter engages. bat, alt & starter are new or test good. how do you remove the main 120 amp fuse?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
Mikey108
  • 475 Answers

SOURCE: 1989 jeep starts slow and not at all?

Are you talking about a slow crank or not starting right away?

Posted on Nov 17, 2008

Ad
  • 12 Answers

SOURCE: 1994 Toyota Camry 4 cylinder Starting problems

your starter is bad.... the two contacts inside the solinoid are worn out only way to fix is replace the unit as a whole bet ya you get click click click then my start.. bet my life on this one been fixin toyotas for 20+ years

Posted on Dec 30, 2008

  • 19 Answers

SOURCE: 1994 Toyota Tercel Starter Problems

sounds to me that you have an igniton problem not a starter problem and or if you have or had an alarm system could be cause if u do give me feedback and i will explain but seems that your starter is fine from what u say but if you think in terms of the elemts to start a vehicle batery gives pwoer to ignition which sends to starter which gives spark etc i would check you ignition system something is causeing a short and not alowing starter to function

Posted on Feb 10, 2009

  • 508 Answers

SOURCE: all power is lost after turning key will not start

Sounds like you may have some severly corroded terminals since you disconnect and reconnect the battery to establish power again. Check you cables and the connections. This includes the ground cable also.

Posted on Feb 26, 2009

  • 52 Answers

SOURCE: Starter does not engage

if the starter doesn't do anything. try a new starter relay in the power distribution center. it just might be the problem.

Posted on Oct 07, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Will not start or click when hitting the ignition switch. have replaced the starter, charged the battery and cleaned the battery terminals


Use voltmeter or test lamp to see if you are getting power to ignition switch. Could be blown fusible link or bad switch.

Apr 21, 2016 | Cars & Trucks

2 Answers

Ford ranger wont start


Are you saying when you turn the key to start the radio and dome light go off ? That should be normal unless the draw from the starter is too high. The start position only powers the relay-solenoid under the hood.
Do you have full battery power at the starter when the key is in the start position ? Battery cables clean and tight on both ends ?

Feb 03, 2014 | Cars & Trucks

1 Answer

2001 Chevy venture will not start. We had an inspection done yesterday, oil change & a power steering line replaced As well. Looks like they had moved the wiring harness & also taped it when this...


-Battery is full...? If so check for corosion battery cable.
And make sure good connector (Tight)
-If all are good and just Click but can't turn. >>> Need new starter.


Mai

Apr 02, 2013 | Cars & Trucks

2 Answers

06 pontiac grand prix wont start no clicking when you turn the key over even jump starting the battery, has dash lights & radio & parking lights. battery tested good. put a used starter & altinator on


Used parts such as starters and altinators don't last. It might **** but it sounds like you need to buy a new starter,altinator, and battery. Or just start with buying one at a time.

Dec 06, 2011 | 2006 Pontiac Grand Prix

1 Answer

Van won't start, when I turn ignition key there is a click. All lights, radio will work, so I do not beleive it is the battery.


The only way to verify if a battery is good is by a load test, but...a volt meter will also give you a good idea. If you have a failing starter, the solenoid will click instead of engaging. You can tell by testing voltage with a meter. You have two wire going to the starter. The large one is from the battery, and the voltage should be the same as the battery, as it is there all of the time. The second and smaller wire gets positive volts only when you turn the key to "start" the engine. If you have these, the starter is the issue.

Jun 18, 2010 | 2002 GMC Safari

1 Answer

F 150 starts and starter stays engaged unplug alternator starts ok but no charge


2 problems, first you have bad starter or starter relay for starter staying engaged, keep alt plugged in has nothing to do with starter staying engauged, to test starter relay, jump at relay bat + post with red/bk wire on solonoid, if cranks over without staying engaged, then not relay or starter but rather in your ign switch, ford had bad problems with ign switch some years ago doing that

Feb 05, 2010 | 2006 Chrysler PT Cruiser

4 Answers

I turn the key and sometimes it will just click and not turn over. I try this 2 or 3 times and then the starter engages and the vehicle starts.


Either the solenoid or the starter motor itself. You need either a test light or a voltmeter to check for power at the starter side large terminal of the solenoid when it just clicks. If you get voltage or light every time it clicks, the starter motor is defective. If you don't get voltage or light when it just clicks, the solenoid is defective.

Oct 20, 2009 | 1999 Toyota Tacoma PreRunner

2 Answers

Pt wont start or turn over


try to get a jump from a friend and see what happens, does the same, faulty starter, may need replacing, try to use small hammer and tap lightly on the starter couple time and have a friend start the car while you tap lightly on it. check ignition switch where you stick the key in. stick the key in the ignition and turn the key back and forth jiggle and wiggle it and see if your igniting will make contact. do it several time to test and see if its the ignition problems, this part is not cheap to replace.

Sep 25, 2009 | 2004 Chrysler PT Cruiser

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

39 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...