Question about 1994 Ford Crown Victoria

2 Answers

Need to replace fuel pump, does gas tank have to be removed, or is there a access plate?

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 10,319 Answers

The tank comes down only to replace the fuel pump through the very top of the tank

Posted on Sep 01, 2010

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,092 Answers

No access panel, the fuel tank will have to be remove, to install fuel pump.

Posted on Sep 01, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Is there a reset button on a GMC Savannah 1500 van and where is fuel pump location?


There is no reset button if you mean like a fuel shut-off switch or fuel inertia switch. Only used by Ford as far as I know. I've never heard of one on a GM product.
The fuel pumps have been located in the gas tank since the beginning of fuel injection systems back in the 1980's. Some GM cars since about 2000 have a special access plate in the trunk area just above the gas tank, for fuel pump module removal. Previously, the only way to replace a fuel pump was to remove the tank from the vehicle. That is probably the case in your van, but check for an access plate in the floor, just above the fuel tank-just above the small opening in the tank where the pump is removed.

Apr 30, 2017 | GMC Cars & Trucks

1 Answer

Replace fuel pump


Best to do this in a well vented area because of the fire hazard, so that the gas fumes don't accumulate.
1) Disconnect battery negative cable.2) Jack up car and support on safety Jack stands3) Siphon gas out of tank4) Remove three rubber hoses on rear of tank. These are used for gas fill up; remove hose clamps and disconnect.5) Remove three hoses from front of tank; these hoses go from the fuel pump to the engine. You'll need special fuel line wrenches for this.6) Disconnect two connectors at the front of the tank.7) Remove two bolts that hold the exhaust pipe heat shield. You'll want to use penetrating oil on these; they will be corroded.8) Support tank with a floor jack. Remove the bolts which hold the tank in place. Pivot the tank on the exhaust, tilt and slide out.9) The gas hoses are taped to the tank. Remove the hoses. The fuel pump plate has about 12 screws around it. Remove the screws. Lift the plate out. The fuel pump is retained with one screw. Remove the screw. Filter is retained with a clip; remove it.10) Get your new fuel pump ($250), the rubber gasket for the fuel pump plate, and new filter ($5). Compare the pump with the old one; it must be the exact lenght. I had to go to two different auto parts stores before I got the right one.Installation is opposite of above. Good luck!Fuel pump is not too tough. First, get a Haynes or Chilton manual for reference (about $14).Best to do this outdoors, so that the gas fumes don't accumate. If I recall correctly:1) Disconnect battery2) Jack up car3) Siphon gas out of tank4) Remove three rubber hoses on rear of tank. These are used for gas fill up; remove hose clamps and disconnect.5) Remove three hoses from front of tank; these hoses go from the fuel pump to the engine. You'll need special fuel line wrenches for this.6) Disconnect two connectors at the front of the tank.7) Remove two bolts that hold the exhaust pipe heat shield. You'll want to use penetrating oil on these; they will be corroded.8) Support tank with a floor jack. Remove the bolts which hold the tank in place. Pivot the tank on the exhaust, tilt and slide out.9) The gas hoses are taped to the tank. Remove the hoses. The fuel pump plate has about 12 screws around it. Remove the screws. Lift the plate out. The fuel pump is retained with one screw. Remove the screw. Filter is retained with a clip; remove it.10) Get your new fuel pump ($250), the rubber gasket for the fuel pump plate, and new filter ($5). Compare the pump with the old one; it must be the exact lenght. I had to go to two different auto parts stores before I got the right one.Installation is opposite of above. Good luck!


Read more: http://wiki.answers.com/Q/How_do_you_change_a_fuel_filter_for_a_92_geo_storm#ixzz27tyFTkDd

Sep 29, 2012 | 1990 Geo Storm

3 Answers

Where is the fuel pump located on a 1998 oldsmobile achieva?


The fuel pump is located inside the gas tank so to replace it the tank will need to be dropped out unless there is an access plate in the trunk.

Feb 15, 2011 | Oldsmobile Achieva Cars & Trucks

1 Answer

I have a 01 Acura 3.5RL and the fuel pump is not running.I sprayed starter fluid in the throttle but it still did not start. I seen where one person said you have to drop the gas tank to change pump and...


No your not. If you removed the back seat and there was no access plate and there was also no access plate in the trunk then you will have to drop the gas tank to replace the fuel pump. Good luck!

Aug 04, 2010 | 2001 Acura 3.5RL

1 Answer

Where is the fuel pump for a 1999 ford taurus?


the fuel pump is located inside the gas tank, the gas tank must be removed to replace the pump, there is no access plate like in some Japanese cars.

Feb 03, 2010 | 1999 Ford Taurus

1 Answer

How to replace fuel pump in a 1988 dodge aries 2.2


drain gas from tank drop tank down fuel pump in top of tank not very hard 4 bolts

Feb 16, 2009 | 1988 Dodge Aries

2 Answers

How do you replace fuel pump on a 1995 dodge avenger?


Easy my friend. Pull out the back seat, and remove the square plate on the passenger side. After you pull back the plate, you will see a round plate that needs to be removed. The fuel pump is attached to the bottom side of this plate. No need to remove tank.

Jan 14, 2009 | 1995 Dodge Avenger

4 Answers

93 lexus LS 400 how do I replace the fuel pump?


You will have to remove your back seat to gain access to fuel pump. Fuel tank is located in trunk. No need to take fuel tank down.

Dec 07, 2008 | 1993 Lexus Ls 400

Not finding what you are looking for?
1994 Ford Crown Victoria Logo

167 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5470 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...