Question about 2008 Chevrolet Tahoe
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
That's just the license light housing. You should be able to find one at most wrecking yards. Some NAPA stores have an outlet for these parts as well. Try carpart.com and partschannel.com. Both of these sites are for replacement body parts.
Posted on Oct 17, 2008
there is an actual liscence plate bracket u can buy at a chrysler dealership thats fits perfectly on bumber it has teeth that perfectly center the bracket right below the grill it looks great i just had one put one on my 2005 300
Posted on Oct 29, 2008
Exploded view of the rear license plate light assembly-step bumper shown, other styles are similar
Posted on Oct 20, 2009
The option is to get a bumper that has the license plate mount on it or buy a mounting kit but you will have to drill holes into the bumper. The clearance below the bumper does not allow you to hang it from below. Wish you had more options. Here in NJ we have the same problems when cars are bought in Pennsylvania!!
Posted on Jan 24, 2010
the light can be replaced from the back side of the light housing . go under the back side of bumper under the truck behind lisence plate you will see the where the wire goes to the light . grab the housing not the wires and twist about a half a turn and pull gently. it should come out and then remove the light bulb and replace with new
Posted on Jan 29, 2010
Tips for a great answer:
Jul 05, 2015 | Chevrolet Impala Cars & Trucks
Jan 15, 2013 | 2001 Ford Windstar
Jun 01, 2011 | 2008 Chevrolet Aveo
Feb 17, 2011 | 2004 Chevrolet Impala
the Steps on how to replace license plate light on your car.
Open the trunk and locate the trunk liner retainer clips.Use the
Phillips head screwdriver to loosen the center plastic screw of the
retainer clip about 1/4 turn, just enough to raise the head of the
screw from the base of the clip. Pull the screw up, and lift the
clip out of the liner. Use a flathead screwdriver to help pry it
out. Remove enough of the clips to allow access to the license plate
light sockets. Pull the liner back.
Remove the emergency trunk release handle by popping off the top
cover of the handle. Use the needle nose pliers to gently squeeze
the prongs on the shaft, while removing the handle.
Unplug the wire harness from the license plate light bulb socket the
release clip on the side of the outlet.Twist the license plate light
bulb socket 1/4 turn counterclockwise, using the needle nose pliers
again. Do not apply too much pressure to the pliers; you may damage
Remove the bulb from the socket, and replace it with a new one.
Replace the socket into the socket assembly, and plug the wire
harness back in. Test the bulb by turning on the lights of the
Corolla, then turn them off again.
Replace the trunk emergency release handle, and replace the hood
liner and the retainer clips. Remove the old bulb and tools, and
close the trunk.
Dec 22, 2010 | 1995 Toyota Corolla
Mar 31, 2010 | 2002 Chevrolet Tahoe
Feb 20, 2010 | 2002 Chevrolet Tahoe
Jun 06, 2009 | 2000 Lincoln LS
55 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: