Question about 1995 Mazda MPV

Open Question

My 1995 Mazda MPV van, 3.0L w/ac and automatic transmission was running kind of rough. I decided to cange the fuel filter and after I did this the van would not turn over. I can hear a clicking sound going to the relay, thats all. There are two wires that go to the starter, one is from the battery and this has 12v going to the starter, the other wire is from the ignition area and there is no voltage coming from it at all. People were telling me about a reset switch but I was unable to locate one. I need advice...Please dwlj_dj@yahoo.com

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 2004 mazda mvp firing order

The firing order is 1-4-2-5-3-6. The cylinders are, front bank is from drivers side to passenger, 6-5-4 , and 3-2-1 at the firewall. This is for a 2004 Mazda MPV.

Posted on Dec 03, 2008

Ad
stormbrewin
  • 426 Answers

SOURCE: 1996 mazda mx6 ls cranks but won't start

you may need to run a wire from a keyed ignition source that has power while cranking and running to the fuel pump relay and bypass the pcm to test wether it will run, if it runs put a more permanent wire in place.Not too sure what tests youve done but it seems that fuel is what your focusing on so a quick test is too spray engine start up the intake tube to see if the engine trys to run if it does it eliminates a lot of other potential reasons for a no start condition.Also try squeezing the fuel return line to see if the added pressure will try to make engine run.Could be time to replace fuel pump etc anyway let me know how it goes good luck with it

Posted on Dec 12, 2008

Ticodude
  • 53 Answers

SOURCE: #5 cylinder misfire

I have a corolla and had #4 cylinder misfire also diagnosed at autozone. After changing the spark plugs, problem persisted, along with the same error code, so they recommended changing the spark plug wires, and that is what fixed it. I would have changed the rotor cap too, but was low on dough. Glad that was not the problem.

Posted on Dec 29, 2008

  • 259 Answers

SOURCE: 2000 Mazda MPV-DX 2.5L V6 won't turn over just clicks.

yes it could be the starter next time it won't start give the starter motor a tap with a hammer or wheel brace also check where the small blade connector is there should be a fuse in line could be the problem hope this helps regards Jim

Posted on Apr 21, 2009

  • 1 Answer

SOURCE: how many catalytic converters on a Mazda Mpv 2003

I disagree. I believe there is 2 cats on the 03 MPV. If you look under the car. The 2 pipes from the headers meet right before the muffler. There is 1 cat under the vehicle and another right off the header (looks like an old glass pack muffler).

Posted on Sep 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

MY VAN HAS NO POWER WHEN I TRY TO DRIVE IT


Sounds like you have a issue with fuel flow . Try to replace inline fuel filter . Also Fuel injectors could need flushing or possibly replacing . Try filter first .

Jan 31, 2014 | 2001 Mazda MPV

2 Answers

My 2001 Mazda MPV is stalling and has a rough Idle. While driving the van the vehicle stop runing, After letting the vehicle sit for a while, the vehicle will start. This has happened a couple times over...


Sounds like a Fuel problem? Make sure that fuel line pressure is within specification according specs.
Fuel Line Pressure 0.38-0.42 mpa (55-61 psi)
Fuel hold pressure 0.176 mpa (25.5 psi)

Sep 06, 2011 | 2001 Mazda MPV

1 Answer

Hi there, My 2003 Mazda MPV van is chugging while running.... there is always gas in it.... what could be the problem?


When was last tune up??? Plugs, wires, All fluids & filters especially fuel filter??? I'd start there and run a good fuel system cleaner through it.

Mar 23, 2011 | Mazda MPV Cars & Trucks

2 Answers

Where is the fuel pump located on a mazda van mpv


its in the fuel tank. remove the seat in the rear and lift the floor covering theres an access cover to get to the fuel pump there. if there is a hanger assembly available for it i suggest you buy that it comes complete and ready to install. hope this helps

Jan 24, 2011 | 1989 Mazda MPV

1 Answer

2001 Mazda MPV, 2.5L eng. During accelerating on to highway, van lost power. Van continued to operate but with little power available. I have no engine light and my code "checker" shows PASS (no...


looks like not enough fuel pressure, check the fuel filter.
and the fuel pump pressure.with car running 60 psi
the pump is located at the rear seat driver side you have to remove the carpet to access the cover. if the fuel pressure checked "OK" suspect defective maf sensor (sometimes defective maf sensor do not show errors codes)another way to test is disconecting the maf sensor and start the car (computer goes to limp in mode) and works little better,or check by scanner idle= low grams per seconds and increase when accelerate.

May 02, 2017 | 2001 Mazda MPV

1 Answer

1995 Mazda MPV - reverse gear in automatic transmission will not engage. No past problems. No history of slippage in any gear. 2 wheel drive vehicle.


SOUND LIKE BAD TRANSMISSION YOU CAN CHECK THE TRANS PAN FOR METAL SHAVINGS TO MAKE SURE YOU NEED A REBUILD. ALSO CHE YOUR TRANSMISSION FLUID SEE IF ITS RED OR BROWN BROWN MEANS USUALLY TRANSMISSION IS BURN OUT

Dec 23, 2010 | 1995 Mazda MPV

1 Answer

My 91 mazda mpv 4x4 van won't start. we were


than I would have the fuel pressure check and change the fuel filter

Mar 09, 2010 | 1991 Mazda MPV

1 Answer

Mazda MPV runs rough at idle as well...


If it's the gas, it would run rough on all cylynders.
try putting fuel system cleaner (redX) or the like and see if it may be a blocked fuel injecter or jet( this may also clean the O2 sensors.

Aug 14, 2009 | 2002 Mazda MPV

1 Answer

Where is the starter on a 1995 Mazda MPV van?


it is located under the skid plate. you'll need to remove the front drive, the alternator, and power steering pump out to remove the starter. need to remove the bottom cover to see it.

Nov 18, 2008 | 1995 Mazda MPV

Not finding what you are looking for?
1995 Mazda MPV Logo

Related Topics:

49 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8582 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...