Question about 1995 Jeep Grand Cherokee

1 Answer

My 1995 jeep grand cherokee died while driving,found that computer was bad,replaced,all was well for a day or so,now died again with exact symptoms,was told that a bad sensor may be taking out computer.Crank sensor is new,hear fuel pump relay and ASD relay clicking with KOEO,if I unplug MAP clicking stops but still no start,could MAP take out computer or is it somewhere else.Battery voltage is present at both relays mentioned above,any thoughts?

Posted by on

  • 3 more comments 
  • Richard Scordino Sep 01, 2010

    checked the relay grounds?

  • mlcorzine Sep 01, 2010

    No,should they be checked where they plug into PDC

  • mlcorzine Sep 01, 2010

    Doesnt the PCM supply the ground

  • Richard Scordino Sep 02, 2010

    Grounding signal comes from computer except for starter relay that uses a direct ground. However... you need to check that the ground signal is actually getting to the relay you are checking as often chattering of a relay is caused by a poor connection which can be either at the relay spade or where the wire to it is connected to the connector end. If your computer has any ground leads (pigtails to the fender) make sure those are good as well There are at least six ground points on the engine. Make sure they all are clean and secure.

  • mlcorzine Sep 02, 2010

    All grounds seem clean and tight,when I unplug the MAP sensor the relays quit clicking,not sure if this is relevant or not?

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Jeep Master
  • 76,649 Answers

I need to know all the fault codes you have received on testing. I really doubt that any sensor is taking out the computer, worked this type of repair for 20+years and have never seen that happen, not once.

Posted on Jun 25, 2017

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
myob247
  • 1342 Answers

SOURCE: 1992 Jeep Cherokee starting problems

Under the hood on the passenger side just above the battery. It's in your Power Distribution Center (PDC) just above your battery. Once you take the lid off, a diagram is shown on the inside of the lid. The auto shutdown relay location will be shown there. It will be identified as "ASD"

You can try swapping it out with one of the other ones to see if it makes any difference. If not next suspect would be ECM.

Posted on Jul 23, 2008

  • 41 Answers

SOURCE: my 1996 jeep cherokee sports

The CPS is one of the first places to start, but remember that the signal goes thru the ECM first, which ultimately supplies power to the coil, I've had to replace the ECM on my 96 Grand Cherokee 4.0 3 times. The dealer wanted to replace the crack and cam sensors, but it was only the computer that was bad.  Sorry I cant give you any definitive answers but I did get it to turn over when I hit the computer with a wrench!

Posted on Dec 12, 2008

  • 218 Answers

SOURCE: 1995 JEEP GRAND CHEROKEE RAN AND DIED WILL NOT START

IS IT THE 4.0L?IF SO U MAY HAVE A BAD CRANKSHAFT POSITION SENSOR.

Posted on Apr 28, 2009

  • 1857 Answers

SOURCE: my 97 grand cherokee is not getting any voltage to

You may have a bad crank sensor or PCM, or ignition module. Or you may have a ign or PCM fuse that popped.

Posted on Dec 17, 2009

  • 1 Answer

SOURCE: 1993 Jeep Grand Cherokee will start then

this sounds like a imobiliser problem,sit in the car,lock the doors on the key fob then open them on the key fob,you have about 2 minutes to start the car or it will activate the imobiliser.had the same trouble.

Posted on Feb 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Dies while driving


had issue with my 1997, bad computer, twice(4.0 liter grand cherokee laredo) also with a 1995 cherokee, same motor, crank angle sensors go at 80k-100k miles.

Nov 12, 2013 | 1996 Jeep Grand Cherokee

1 Answer

1998 jeep grand cherokee died wont start getting


check node on injectors if none the computer is most likly your problem

Oct 29, 2013 | 1995 Jeep Grand Cherokee

1 Answer

1995 jeep grand cheerokee laredo 6 cyl. randomly dies then takes anywhere from five minutes to hours to restart


The only component I know of, that shuts a Jeep off while idling or driving 40mph down the road, is a bad crank sensor. Usually when it starts going bad, it will sporadically shut off, like yours does. Eventually, it will just die and the Jeep will not start at all. Have it tested and replaced, if necessary.

Mar 15, 2013 | 1995 Jeep Grand Cherokee

1 Answer

I have a 1995 Jeep Grand Cherokee and have a


Look's like you done every thing that need's to check, just make sure your belt is adj' right, cause an alternator under a load will drag so make sure it's tie.Good luck and x-mas.

Dec 08, 2009 | 1995 Jeep Grand Cherokee

1 Answer

95 jeep cherokee idles and wants to die


replace your ignition coil. it will be on the right side of the engine compartment. it has been a while but there is only a few small bolts to remove and of course the center spark plug boot and wire harness un hook. ... Enjoy driving the your jeep again when warm.

Apr 01, 2009 | 1995 Jeep Grand Cherokee

1 Answer

95 jeep grand cherokee problem


Neutral safety switch just slam the shifter into park then try it again or start in Neutral, or replace it.

Feb 25, 2009 | 1995 Jeep Grand Cherokee

Not finding what you are looking for?
1995 Jeep Grand Cherokee Logo

Related Topics:

175 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...