Question about 2006 Buick LaCrosse

2 Answers

Cannot locate the interior trunk release switch

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

The 'trunk release' on on the Power door lock switch Hold it in the up position for 2 seconds.

Posted on Oct 27, 2010

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 7,353 Answers

I dont think there is one. you should have a key fob.

Posted on Sep 01, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

2008 CTS trunk won't unlock


Hi Jeff,
I was going to say, check fuse/ jump the load side of relay Good post.
trunk 1-a4vvaacye2kqxo12bveg1ioe-1-0.jpg

trunk 2-a4vvaacye2kqxo12bveg1ioe-1-2.jpg

Mar 19, 2017 | Cars & Trucks

1 Answer

2003 Cadillac deville trunk randomly opens on its own when sitting and not running occasionally what could be the cause.


Do you know anything about automotive electrical testing ? how to read a wiring diagram ? How to use a DVOM - digital volt ohm meter ? You can find a free wiring diagram here http://www.bbbind.com/free_tsb.html

The trunk release is controlled by an electronic control moduel .
Trunk Release Relay
Output Controls
The rear integration module grounds the trunk relay when commanded ON. The rear compartment should release.

This vehicle has a very complex body control system of three different computers

The body control system consists of the following 3 modules:
• The Dash Integration Module (DIM)
• The Instrument Panel Module (IPM)
• The Rear Integration Module (RIM)
Each of the 3 body control modules integrate a number of functional systems under the control of a single module. Each module is connected to the Class 2 serial data circuit, many of the control functions are implemented by Class 2 messages.

. Rear Integration Module (RIM)
The various RIM inputs and outputs are described in the corresponding functional areas as indicated on the RIM electrical schematics.
The RIM functions include the following:
• Automatic level control
• CIGAR relay control
• Class 2 communication requiring RIM interaction
• Content theft deterrent
• Fuel door control
• Fuel level sensor input
• Heated seat control
• HVAC blower control
• LK/CYL relay control
• Park brake relay control
• Rear defog relay control
• Rear park assist chime control
• Retained accessory power (RAP) relay control
• Reverse relay control
• Transmission shift inhibit
• Trunk release relay control
• Various controls for the interior lamps


Luggage Compartment Description and Operation (General)
Rear Compartment Lid (trunk) release actuation is controlled by the following components.
• Rear Compartment Lid Release Relay
• Instrument Panel Module (IPM)
• Rear Integration Module (RIM)
• Valet Switch
• Rear Compartment Lid Release Switch
• Rear Compartment Lid Release Actuator
Battery voltage for the coil side of the trunk release relay is supplied through the Valet switch (with the valet switch in the OFF position) by the ALDL fuse located in the Underhood Fuse (Bussed) Block. Battery voltage for the switch side of the trunk release relay is supplied by the Body fuse located in the Rear Fuse (Bussed) Block. When the rear compartment lid release switch is momentarily pressed, it provides a ground circuit for the trunk release signal of the Instrument Panel Module (IPM). When the IPM senses that the switch has been activated, it sends a Serial Data Class 2 message to the Rear Integration Module (RIM). The RIM then provides a path to ground on the F/TNK DR REL relay control circuit. The trunk release relay is then energized, and battery voltage is applied through the switch side contacts of the trunk release relay to the rear compartment lid release actuator. The actuator is connected to ground through a ground splice pack located at the left rear corner of the rear compartment, near the left tail lamp connector.

Mar 01, 2017 | Cadillac DeVille Cars & Trucks

1 Answer

Trunk want open on chrysler 300 and the key dosn't work


If u can get in truck thru backseats a lot of card these days have latches on the interior of truck

Sep 13, 2014 | 2007 Chrysler 300

2 Answers

Bentley Boot lid manual release


This is all the Bentley shows:

doorlockswitch1.gif
Location: Driver's side door trim in storage compartment.

Removing:

- Remove driver's side door trim:
Repair Manual, Body Interior, Repair Group 70 - Unplug connectors.


doorlockswitch2.gif
Carefully disengage catches -arrows-.
- Press switch for interior monitoring and towing protection -1- or trunk release switch -2- out of trim toward rear.

Installing

Installation is carried out in the reverse order.


doorlockswitch3.gif
Remove trunk lid lock.

Repair Manual, Body Exterior, Repair Group 55
- Use a flat screwdriver to pry plastic tab -3- off retaining pins -1-.
- Bend plastic tab fully to rear.
- Pull contact switch -2- first sideways and then up and out of trunk lid lock.

Installing

Install in reverse order, paying attention to the following:

Note:

Make sure that washers are correctly seated between plastic tab and trunk lid lock.

Sep 01, 2012 | Bentley Continental Flying Spur Cars &...

1 Answer

Is there a fuse for the trunk release button for a 2003 bmw 325i


Yes there is a fuse for the trunk opener.also,do you have a valet switch to shut it off?

Aug 28, 2012 | Cars & Trucks

1 Answer

I have a 1989 chevy cavalier and my key doesnt open the trunk and i cant find a manual release


either located on the rear quarter panel behind the trunk interior cover or between the two rear speakers in the trunk area

Mar 26, 2010 | 1989 Chevrolet Cavalier

1 Answer

No trunk light, trunk release, or back-up lights: Please help!


How can I adj. . a trunk light switch on a 02 Buick Century

Sep 26, 2009 | 1999 Buick Century

1 Answer

The trunk release button in my 2001 lincohn ls not working.


please rate and report back on results.

Make sure you did not inadvertently engage the lock out.

Trunk Release Lockout Switch
The trunk release lockout switch is:
  • located within the glove compartment.
  • disables the trunk release switch.
Does it work with your key fob?

Jul 08, 2009 | 2001 Lincoln LS

3 Answers

2003 saturn ion-release does not work for trunk release


If only the trunk release is not working, did you check to see if the little lever arm switch on the trunk lid at the latch assembly is switched to enable the release? Mine came switched to the 'Off' position when I bought it and it took me a few days to figure that one out.

Apr 27, 2009 | 2006 Saturn ION

2 Answers

Trunk stuck on a 03 Corolla


I was able to unlock my trunk by using a wood pole to operate the interior safety unlock handle, which is located just above the trunk floor, against the rear of the trunk lid. You simply insert the wood pole between your rear seats, while attempting to locate the handle release. When you find the handle, use the wood pole to push down on it.

Then, I had to take the top of the truck mat loose by using a flat head screwdriver to pry the plastic plug holders loose from the trunk. I also had to use a 10mm socket to loosen the trunk locking mechanism. Once inside, I notice the remote release cable ball had dislodged from its slot. I simply placed the ball in its slot and reassembled the trunk.

Problem solve. :)

Nov 22, 2008 | 1997 Toyota Corolla

Not finding what you are looking for?
2006 Buick LaCrosse Logo

Related Topics:

285 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7711 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...